A wire frame is in the shape of a regular polygon of 2016 sides. Each side is of length L = 1 cm. If a current 1 = 5.0 A is given to the wire frame estimate the magnetic induction field (B) at the centre of the polygon. [Take 7? 10.08]

A wire frame is in the shape of a regular polygon of 2016 sides. Each side is of length L = 1 cm. If a current 1 = 5.0 A is given to the wire frame estimate the magnetic induction field (B) at the centre of the polygon. [Take 7? 10.08]

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: s3(t), and s4(1), respectively, where s1 (1) = 20/2 sin 2t s2(t) = 0 1 TM = Тм 20 s3 (1) = 10/2 cos ...

A: Solution- Given, A equiprobable messages m1, m2, m3, m4 m1 → S1(t)= 202sin2πTmt m2 →S2(t) =0 ...

Q: An R-L load connected to 250V supply is consuming 1.5kW. When a capacitor is connected parallel to t...

Q: Needs to be done asap pls HINT In the following question, zero initial conditions apply for the outp...

A: We need to solve the given equation

Q: 12–94. A golf ball is struck with a velocity of 80 ft/s as shown. Determine the speed at which it st...

A: Please refer the attached images for the complete answer..

Q: Complete the operational diagram for each load in the circuit. The timers are set for 5 seconds 1. O...

A: 1. The given figure is shown below:

Q: know that V = Ayz + yx^2B. a. Determine A and B if V = 0 for points (2,-2,2) and V = 100 for the poi...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: も

Q: 5. Determine the magnitude of the current flowing through a 4.7 k2 resistor if the voltage across it...

Q: Consider a silicon pn junction at T= 300 K with acceptor doping concentrations of 10to cm"3 and dono...

Q: Consider the two signals c1(t) = cos(105nt) and c2(t) = sin(10°t). Consider also the two signals, m1...

Q: A signal of 15 MHz is sampled at a rate of 28 MHz. What alias frequencies are generated?

Q: 1. Assume that a set of currents given by the equations below will be applied to the stator containi...

A: Here is your answer! I hope this will help you.

Q: Determine Vhf in the circuit in polar form. Write the angle only in four decimal places. 80260°V 3+j...

Q: Let a 5kVA, 400/200 V transformer be approximately represented by a 2Ω reactance referred to the low...

Q: A set of conductors is used to supply residential unit with a total load current of 60 A at a single...

Q: Consider a silicon pn junction at T= 300 K with acceptor doping concentrations of 1016 cm-3 and dono...

Q: The figure shows a long cylinder and its cross section. There are N (N is a large number) wire on th...

A: We need to find out magnetic field for given current distribution .

Q: Wheatstone Bridge Experiment: Wheatstone bridge consists of: a) 4 resistive arms b) 2 resistive arms...

A: Generally the Whetstone bridge consists of the 4 arms , and all are resistive in nature only So...

Q: a single line diagram of power system

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are...

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (d) the maximum p...

Q: Given ZL = 185 - j175 ohms and Zo = 200 ohms. Match the load to the line using a) short-circuited sh...

A: Stubs or Quarter wave transformer is used for Impedance matching for max power efficiency

Q: 4. Calculate the working values of the following circuits from the parameters in the given table. pa...

Q: A synchronous generator with 6 magnetic poles supplies an induction threephase motor. Considering th...

A: Pole: This is placed at the stator and on this winding will be done. With the help of the pole magne...

Q: What is a rectifier circuit? Give at least 3 applications of rectifier circuit.

Q: Given the sequential circuit below, derive the excitation table. RQ FF1 Y X- Emphasis RQ %24 FF2 Wha...

A: For FF1 the output be 'A' For FF2 the output be 'B' In the given problem, C is given there is no In...

Q: Wheatstone Bridge Experiment: A galvanometer is used as a: a) current source b) voltage source c) nu...

A: Given is an Wheatstone bridge We need to find the use of galvanometer

Q: (4-j5) (12+j11)

Q: DFT

Q: The parallel plates have an area of 2000 cm2 and are separated at 1.00 cm apart. The original potent...

A: The solution is given below

Q: Given an analog filter Ha(s) = designed from H«(s) by many-one mapping method, assuming sampling per...

Q: Q10/ At room temperature (300 K) with the Fermi level located exactly in the middle of the bandgap, ...

A: The solution is given below

Q: Q5/ When a silicon material is doped with Arsenic (As) that has 5 valance electrons, the impurity is...

A: Arsenic is the 5th group element which has 5 valency electrons and when it doped with silicon the m...

Q: a. f(t) = 2 cos(120t + 45) -04° cos12t b.f(t) =

A: As per the guidelines,we are supposed to answer only first two sub parts of a question.Please post t...

Q: Q5/ When a silicon material is doped with Arsenic (As) that has 5 valance electrons, the impurity is...

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (a) the inductive...

A: As per our guidelines we are supposed to be answer only the first 3 questions. Kindly repost the oth...

Q: Find the total capacitance of the combination of capacitors shown in picture. Assume the capacitance...

Q: What is the nominal value of a resistor with the first three colour bands ORANGE, VIOLET, RED?

Q: R(s) + 1 C(s) K s(s+7)(s+3) + E(s) C(s) G(s) S or the system shown above, find the value of gain K t...

Q: 12–5. The velocity of a particle traveling in a straight line is given by v = (6t – 3²) m/s, where t...

Q: Figure below shows a negative feedback system. The open loop gains of amplifiers are given as follow...

A: Given: The figure below shows a negative feedback system. The open-loop gains of amplifiers are give...

Q: 1. It is a machine that converts mechanical energy to electrical energy. 2. It is a machine that co...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: SOLVE FOR S, Q, P, VR, VL, I, and phase angle. draw the phasor diagram 50ohms R 60иН VR V V = 210210...

Q: Find the total current in polar form

A: In this question, We need to find the total current in polar form . We are solving this problem us...

Q: Find the Laplace transform and box the final answer

A: This question belongs to signal and system . It is based on the concept of calculation of Laplace tr...

Q: A 70 KV short transmission line is 20 Km with per phase ine impedance of (0.125 p.5) ohms. The Ine d...

Q: 2. A 3-phase, 400-V, Y-connected induction motor has an equivalent T-circuit consisting of R = 1 2, ...

Q: DFT {8(n)} is OA. 0 ОВ. 1 OC. 2pi OD. pi Reset Selection

Q: R1 R4 3.0 kn 1.5 kn +10V +V R2 R3 2.5 kn 7.5 kn Figure 4.5

Q: Figure below shows a negative feedback system. The open loop gains of amplifiers are given as follow...

Q: 8Ω + 5A 12Ω

Question

A wire frame is in the shape of a regular polygon of
2016 sides. Each side is of length L = 1 cm. If a current
1 = 5.0 A is given to the wire frame estimate the magnetic
induction field (B) at the centre of the polygon.
[Take 7?
10.08]
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are interpoles, and what is their purpose?
Question A suspension type insulator has three units with self-capacitance C and ground capacitance 0.1C. What will be the string efficiency?
An air gap has a length of 0.1 cm. What length of iron core has the same reluctance as the air gap? The relative permeability of the iron is 5000. Assume that the cross-sectional areas of the gap and the core are the same.
Each of three insulators forming a string has self-capacitance of "C" farad. The shunt capacitance of each cap of insulator is 0-25 C to earth and 0-15 C to line. Calculate the voltage distribution across each insulator as a pecentage of line voltage to earth and the string efficiency.
PLEASE ANSWER IT ASAP FOR AN UPVOTE. THANK YOU. Round off your answer into four decimal places .Box your final answer .Use SI unit. A magnetic circuit consist of silicon having a cross section of 1.5 sq. m and 0.1 m length and an air gap of the same cross section and pf 0.02 m length. what is the field intensity at the air gap if 0.5 A current flows through the 5000-turns coil? Assume the permeability of silicon steel is 3000.
Electrical Engineering B-H curve of magnetic material is given. find maximum BH value step by step solution plz! Step-by step plz H.=-20[KA/m] Tip: B=5x(0$H+I[T] I CBH) = Value of H that becomer O ANS: -5000 [J/m']
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
Nb3Sn and GaV are candidates for a superconducting application, when the magnetic field is 150,000 Oe. Which of them would require the lowest temperature in order to be a superconductor?
A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space free permeability is 4t×10-7 H/m. Find the reluctance of the left leg and the top side of the core. Ignore the gap in your calculations. 10 cm 0.1 cm gap 20 cm 5 cm 5 cm 40 cm 5 cm core depth = 10 cm Select one: O a. Rleft = 1251 A.t./Wb , Rtop = 1023 A.t/Wb b. Rjeft = 125.1 A.t./Wb , Rtop = 102.3 A.t/Wb O c. Rjeft = 12.51 KA.t./Wb , Rtop = 10.23 KA.t/Wb d. None
Figure shows a circuit and a conducting rod. A conducting rod moves with a constant velocity vperpendicular to a circuit with a current I=2.82sin(??)
This question is about electrical conductivity: 1. How are electrical properties different for isotropic 3D bulk and 2D sheets?
5) ) The point charge at the bottom of the figure is, Q = 17 nC and the curve is a circular arc, of radius r = 5 cm. What is the magnitude of the force on the charge Q due to the other point charges shown? -6.0 nC 2.0 nC 2.0 nC 45° 45° 5.0 cm 5.0 cm +) Explain or Show Work Here: