10.1 A uniform disk of mass M and radius R starts from rest at the top of an incline at a verticalheight h above the floor. If the disk rolls without slipping down the ramp then what is themagnitude of the velocity of the center of mass of the disk at the bottom of the incline?Answer in terms of any of the symbols given, as well as g or n, etc. You may use anytechnique that you wish, but include a force diagram if you do a force analysis or indicateyour choice of coordinate system and the mechanical energy at each location of interest if youdo an energy technique. Note: you only need to do a single technique for the calculation.

Given: Uniform disk of mass, M radius, R To Find: Velocity of centre of mass of disk at bottom of…

A uniform disk of mass M and radius R starts from rest at the top of an incline at a vertical heighth above the floor. If the disk rolls without slipping down the ramp then what is the magnitude of the velocity of the center of mass of the disk at the bottom of the incline? Answer in terms of any of the symbols given, as well as g or л, etc. You may use any

A uniform disk of mass M and radius R starts from rest at the top of an incline at a vertical heighth above the floor. If the disk rolls without slipping down the ramp then what is the magnitude of the velocity of the center of mass of the disk at the bottom of the incline? Answer in terms of any of the symbols given, as well as g or л, etc. You may use any

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 59P: A bug of mass 0.020 kg is at rest on the edge of a solid cylindrical disk (M=0.10kg,R=0.10m)...

See similar textbooks

Similar questions

A uniform rod of length L and mass M is held vertically with one end resting on the floor as shown below. When the rod is released, it rotates around its lower end until it hits the floor. Assuming the lower end of the rod does not slip, what is the linear velocity of the upper end when is hits the floor?
A uniform solid disk and a uniform hoop are placed side by side at the top of an incline of height h. (a) If they are released from rest and roll without slipping, which object reaches the bottom first? (b) Verify your answer by calculating their speeds when they reach the bottom in terms of h.
Check Your Understanding What is the moment of inertia of a cylinder of radius R and mass m about an axis through a point on the surface, as shown below? A uniform thin disk about an axis through the center Integrating to find the moment of inertia of a two-dimensional object is a little bit trickier, but one shape is commonly done at this level of study—a uniform thin disk about an axis through its center (Figure 10.27). Figure 10.27 Calculating the moment of inertia for a thin disk about an axis through its center.
A solid cylinder of radius 10.0 cm rolls down an incline with slipping. The angle of the incline is 30 . The coefficient of kinetic friction on the surface is 0.400. What is the angular acceleration of the solid cylinder? What is the linear acceleration?
What three factors affect the torque created by a force relative to a specific pivot point?
A diver goes into a somersault during a dive by tucking her limbs. If her rotational kindetic energy is 100 J and her moment of inertia in the tuck is 9.0kgm2 , what is her rotational rate during the somersault?
A hollow cylinder that is rolling without slipping is given a velocity of 5.0 m/s and rolls up an incline to a vertical height of 1.0 m. If a hollow sphere of the same mass and radius is given the same initial velocity how high vertically does it roll up the incline?
If the angular acceleration of a rigid body is zero, what is the functional form of the angular velocity?
A system of point particles is rotating about a fixed axis at 4 rev/s. The particles are fixed with respect to each other. The masses and distances to the axis of the point particles are m1=0.1kg , r1=0.2m , m2=0.05kg , r2=0.4m , m3=0.5kg , r3=0.01m . (a) What is the moment of inertia of the system? (b) What is the rotational kinetic energy of the system?
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?
A cylinder with rotational inertia I1=2.0kgm2 rotates clockwise about a vertical axis through its center with angular speed 1=5.0rad/s . A second cylinder with rotational inertia I2=1.0kgm2 rotates counterclockwise about the same axis with angular speed 2=8.0rad/s . If the cylinders couple so they have the same rotational axis what is the angular speed of the combination? What percentage of the original kinetic energy is lost to friction?
A bug of mass 0.020 kg is at rest on the edge of a solid cylindrical disk (M=0.10kg,R=0.10m) rotating in a horizontal plane around the vertical axis through its center. The disk is rotating at 10.0 rad/s. The bug crawls to the center of the disk. (a) What is the new angular velocity of the disk? (b) What is the change in the kinetic energy of the system? (c) If the bug crawls back to the outer edge of the disk, what is the angular velocity of the disk then? (d) What is the new kinetic energy of the system? (e) What is the cause of the increase and decrease of kinetic energy?