A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 50. The DC and RMS output voltages are respectively equal to: Scondary AD D Ds R 本D。太De 太D, Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O C. 180V, 197.2V O d. 220V, 249.2V

A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 50. The DC and RMS output voltages are respectively equal to: Scondary AD D Ds R 本D。太De 太D, Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O C. 180V, 197.2V O d. 220V, 249.2V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 52. The DC and RMS output voltages are respectively equal to: Secondary 太D太D,太D, 太D。太De太D, b. Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O c. 180V, 197.2V O d. 220V, 249.2V
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
The power output of the half-wave rectifier is rated at 102.4 W with a load resistor of 40 ohms. The RMS voltage at the output is: O A. None of the other choices are correct O B. 12.5 V O C. 102 V O D. 25.5 V O E. 51 V
A single phase full wave rectifier supplies a 20 Ohm load at an average voltage of 15 V. Determine the source rms voltage. O 23.6 V 16.7 V 9.5 V O 33.3 V
Calculate the value of the capacitor in the full wave rectifier filter as shown below. Knowing that the ripple percent is 5%. 10.1 130 V Ouepon 750 uF O 1000 uF O 660 uF O 2200 uF Other value O
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to り:1 L-Dc こ0SA ドL VL-De =20V 220V omsh 0.01 F 0.02 F O 0.0167 F None of the above A Moving to another question will save this response. « F8 F10 %$4 48 & 50 67 7V 8人 99 1O 3. F GJ H. K. Corll %24
4. Determine the ripple factor for the filtered bridge rectifier with a load as indicated in figure. Vp = 0.7 v₁ 120 V rms 60 Hz Vpipri) 10:1 Posec's D₂ D₁ DA C 1000μF Output RL 220 (2
Quèstion 15 Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to IL-DE 205A iL-DC 220V ams 5OH23 VL-DC =20V 0.01 F 0.02 F 0.0167 F None of the above SHOT ON RED MAGIC 5S POWERED BY NUBIA
a/ What is the function of the inductance L in a single phase halfwave thyristor? b/ A controlled full wave bridge rectifier has a source of 50 Sinwt with R = 10 and L = 20 mH find the d.c load current if a = 40°, then draw Vo and lo use 50 Hz freq. and B = 1.1n %3D
A Capacitor filter is used at the output across the load to minimize the ripple factor of the output voltage. If R = 20 02 and the single- phase bridge rectifier is supplied from a 120V - 60 Hz sinusoidal source. Find the capacitor value in millifarads that will maintain the amount of the output ripples to less than 5% 艹 Ce = m₂ 0 mF RL%
If a half-wave rectifier is used with 117-V rms ac, the average dc output voltage is about: O 117 V O 328 V O 52.7 V O 105 V
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to c 20:5A L VI-DC20V 220V omsh T 0.01 F 0.02 F 0.0167 F None of the above euer