a steam 8.0 MPa and 485 degree Celsius enters the turbine and expand at condenser pressure of 0.006 mpa for cycle and 1kg of steam. determine A.) heat added, B.) Wnet, C.) Thermal Efficiency. And for the engine, Determine the steam flow and the energy output of 40,000 Kw,

Q: In an ideal Stirling engine with a regenerator that uses air, the maximum and minimum volumes of the…

A:

Q: an air-standard Otto cycle. It operates with a compression ratio of 8 starting from 20C and 101.3…

A:

Q: 3.) In In an actual Rankine cycle, steam first enters the turbine at 10 MPa and 400C. It expands to…

A:

Q: Compute the Total work of a plant if the the combined cycle overall efficiency is the average value…

A: Combined cycle overall efficiency is the average value Heat input= 192 kJoules= 192000 Joules   To…

Q: Question 2: In the Ericsson cycle, the pressure of the air entering the compressor is 100 kPa, the…

A:

Q: 7.) A Rankine cycle is used for a steam power plant. Liquid first enters the turbine at 2.25 MPa and…

A: GIVEN DATA A RANKINE CYCLE OPERATING BETWEEN 2.25MPa , 300'C AND 0.025 MPa WE HAVE TO FIND ALL GIVEN…

Q: Airborne heat used to heat a home refrigerant circulating in the cycle of the pump-134a 600 kPa…

A: Given data: Heat from outside air is used to heat a home. For the heat pump, refrigerant R-134 a is…

Q: Step 2) Find the optimum value of the reheat pressure in order to achieve the highest efficiency in…

A: Draw the diagram of ideal rankine cycle with reheater-

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. Steam enter the…

A: Pressure of steam at turbine inlet, P3=4 MPa Temperature of the steam at turbine inlet, T3=400oC…

Q: 3. An ideal regenerative cycle is executed with steam generated at 8 MPa, 500°C. Before condensing…

A: Boiler condition, P[1] = 8 MPa, T[1] = 500 C Feedwater heater pressure , 0.8 MPa Condenser pressure,…

Q: HW Q) A gas turbine power plant operate at a pressure ratio of 9. Air enters the compressor at 1.0…

A: INTRODUCTION : The heat energy gained from the combustion of solid fuels is utilized in thermal…

Q: A refrigerator is designed with a turbine instead of a throttle. What would you expect to happen to…

A:

Q: The figure below is the basic plot of pressure vs. volume for the Dual Standard Cycle. Constant…

A: (g) To find: The pressure at point 5. Given: The gas constant is R=287 Jkg·K. The specific heat…

Q: turbo generator has a combined steam rate of 5.35 kg/kwh at its rated output at 20 MW. The steam is…

A: INTRODUCTION: We will compute the combined heat rate supplied to the turbo generator and the turbo…

Q: ESuperheuted steam at 350 and 20 bar enters the turbine of steam power plant and expands to a…

A:

Q: Air undergoes Isothermal expansion in a Carnot cycle where the pressure decreases from 2.5 MPa to…

A: Dear student z we are suppose to solve only 3 subparts. Still I have solved 5 sub parts. Please post…

Q: A refrigeration system is designed to cool 10,000 lb per hour of water from 60 deg F to 40 deg F .…

A: Given DataT1=60F=15.55°CT2=40F=4.44°CCP=4.18m˙=10000 lb/hr=1.26kg/s

Q: 04: A) Prove that the ratio of work to the petrol engine works according to the Otto cycle equal: rw…

A:

Q: Subject: Refrigeration System  A carnot cycle used to produce work has temperature limits of 25C,…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: Homework-2 Compute the themal e fficiency of an ideal Ran kine cycle for which the steam leaved the…

A: Answer: (a) The thermal efficiency of ideal Rankine cycle is 35.60 %. (b) The mass flow rate of the…

Q: Answer this ASAP,thx In a gas turbine, air enters the compressor at a temperature of 290 K and a…

A: (a) To find: The thermal efficiency. Given: The inlet pressure and temperature at compressor is…

Q: H.W: For the power plant shown, draw the T-s diagram and calculate the efficiency and S.S.C for the…

A: given; draw T-S diagram and efficiency of cycle?

Q: Qin > Qout in (mark all that apply):

A:

Q: An OTEC power plant has an efficiency of 2.5%. The difference in temperature of teh warm surface…

A: Given:η=2.5%∆T=T1-T2 =7.5°C

Q: Use the steam tables provided and use 4 decimal places for solving.  A steam power plant operates…

A: Inlet turbine conditionsP[1] = 15000[kPa]T[1] = 500[C]Condenser pressure = P[3] = 5 kPaIt is asked…

Q: .Steam at 210 bar and 760 oC enters a Reheat engine and expands to 10 bar. At this point it leaves…

A:

Q: Problem 4. Consider an air conditioner operating on an ideal vapor-compression refrigeration cycle…

A:

Q: In a steam power cycle, steam enters the turbine at 30bar with the following different conditions…

A: Given that, Pressure at the entry of turbine, P=30 barPressure at the exit of turbine, P=1 bar,Mass…

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

A:

Q: Combined Cycle (CC) Natural Gas Power: Cheap natural gas (mostly from fracking and similar…

A:

Q: steam is delivered to an engineturbine at 7mpa at 600 degree celsius,reheat it 1.5 mpa and 600…

A:

Q: Enthalpy data is given for a regenerative Brayton cycle with intercooling and reheating. The cycle…

A: We are suppose to solve only 3 subparts. Please post other parts as a separate question.

Q: 6.) Air undergoes Isothermal expansion in a Carnot cycle where the pressure decreases from 2.5 MPa…

A: As per the guidelines of BARTLEBY we are subjected to solve only 3 subparts at a time. Please repost…

Q: A power plant uses steam flowing at 75kg/s to perform power cycle. Both the turbine and the pump…

A: It is given that the turbine and pump are adiabatic in nature. Thus, it can be considered that the…

Q: 1.There are compressed 100 m/min of air from p=100kpaa and t=24°Cto p-534 kpaa. determine a) Wa, Waf…

A:

Q: The pressure ratio of a Brayton cycle with a regenerator whose working fluid is air is 8. The air…

A: Given data: The pressure ratio of the Brayton cycle is rP = 8 The value of the adiabatic constant…