A soil has a discharge velocity of 6 x 10-7 m/sand a void ratio of 0.5. Its seepage velocity is(a) 18 x 10-7 m/s(c) 6 x 10-7 m/s(b) 12 x 10-7 m/s(d) 3 x 10-7 m/s

Given data : Void ratio (e)=0.5Discharge velocity =6×10-7 m/s

Answered: A soil has a discharge velocity of 6 ×…

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.8P

See similar textbooks

Similar questions

A soil has a discharge and a void ratio of is. A B C D 18x10-7 m/sec 12×10-7 m/sec 24×10 m/sec 36x107 m/sec velocity of 6×10¯7 m/sec Its .50. seepage velocity
glass container with pervious bottom containing fine sand in loose state (void ratio 0.8) is subjected to hydrostatic pressure from underneath until quick condition occurs in the sand. If the specific gravity of sand particles -2.65, area of cross-section of sand sample 10 cm² and height of sample = 10 cm, compute the head of water required to cause quicksand condition and also the seepage force acting from below. Seepag
1. For a constant head laboratory permeability test on a fine sand, the following values are given: L = 300 mm; D₁ = 200 mm; h = 400 mm; Vol = 420 m³; t = 4 min; e = 0.55. a. Compute the coefficient of permeability in cm/sec. b. Compute the discharge velocity in cm/sec. c. Compute the velocity. seepage 2. For a falling head permeability test, the following are given. Length of specimen is 380 mm, are of specimen - 6.5 cm², hydraulic conductivity of soil specimen is 0.175 cm/min. a. What should be the area of the stand pipe for the head to drop from 650 cm to 300 cm in 8 min?
A soil has a discharge velocity of 6 × 107 m/s and a void ratio of 0.5. What is its seepage velocity? 13x10 m/s 2 6x 10 m/s 3 12 x 10 m/s 4. 18 x 107 m/s
_If the soil has discharge velocity is 9*10-7cm/s and the voids ratio of 0.5, then the seepage velocity will be -
Problem Number 2: Given the figure below and considering an upward flow, forthe sand the following are its properties e=0.52 and Gs = 2.67. a) Calculate and illustrate through a diagram the 6,u and 6' of the points A, & B.10 Points b) what is the upward seepage per unit volume of soil? 15 m 2 m Valve (open) Inflow Sand P eat
The permeability of sand in horizontal and vertical directions are 3 × 10- 3 cm/sec and 1 x 10-3 cm/sec and the permeability of clay in horizontal and vertical directions are 9 x 10-7 cm/sec and 3 × 10-9 cm/sec, then the ratio of X seepage Loss per meter length of dam in sand to clay is:
In the soil profile shown below, the clay is normally consolidated and H,=9m, H2=5m, H3=3m. The depth of water table is then decreased so that H;=2m, H2=12m, H3=3m. a) Calculate the overconsolidation ratio (OCR) at this stage. When a surcharge of Ao = 180 kPa applied to the surface. b) Estimate the primary consolidation settlement of the clay layer. c) Estimate the degree of consolidation will be after 40 days? d) How many days would it take for 90% consolidation? Soil characteristics are as follows (use appropriate relations from the Appendix, 9.81 kN/m³): Yw = Sand: e = 0.56; G, = 2.6 Clay: LL = 63; e = 0.83; G, = 2.77; C, = - Cc; Cy = 6.66 × 10-4cm² /s %3D Ao H1 Sand Groundwater table Sand H2 Clay. Void ratio = e H3 Normally consolidated Sand
Question- Seepage principles- If the void ratio and discharge velocity for soil is 0.5 and 5 x 10-7 m/s respectively, what will be the seepage velocity in m/s?
Q- A suspension of sand like particles in water with particles of diameter 0.10 mm and below is flowing into a settling tank at 0.10 m³/s. Assume g=9.81 m/s², specific gravity of particles=2.65, and kinematic viscosity of water=1.0105x102 cm²/s. Find the minimum surface area (in m²) required for this settling tank to remove particles of size 0.06 mm and above with 100% efficiency.
The bottom of a stream consists of silty clay has a coefficient of permeability of 0.06 m/day has an average depth of 2.0 m. The underlying aquifer of fine sand has an average thickness of 20 m. The coefficient of permeability of fine sand is 3 m/day. Determine the coefficient of leakage. Determine the retardation coefficient. Determine the leakage factor.
From the given figure shown, the discharge velocity of the water through the soil is 0.08 em/s. with a void ratio of 0.60, O Compute the coeff. of permeability in cm/sec. ® Compute the seepage velocity in cm/sec. O Compute the seepage force per unit volume.

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Fundamentals of Geotechnical Engineering (MindTap…

Civil Engineering

ISBN:

9781305635180

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Fundamentals of Geotechnical Engineering (MindTap…

Civil Engineering

ISBN:

9781305635180

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A soil has a discharge velocity of 6 × 10-7 m/s and a void ratio of 0.5. Its seepage velocity is (a) 18 x 10-7 m/s (c) 6 x 10-7 m/s (b) 12 x 10-7 m/s (d) 3 x 10-7 m/s