A smooth, homogeneous sphere is held ar rest by the two inclines as shown. Determine the reactions at A and B (represent by RA and Rg respectively). The weight of the sphere is 200N. Solve by the triangle method. A 75° 30°

A smooth, homogeneous sphere is held ar rest by the two inclines as shown. Determine the reactions at A and B (represent by RA and Rg respectively). The weight of the sphere is 200N. Solve by the triangle method. A 75° 30°

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.185RP: Find the magnitude of the pin reaction at B caused by the weight W=80lb. Neglect the weights of the...

See similar textbooks

Related questions

Q: Determine the following a) reactions at the roller, b) reaction at A. The pulleys at C and D are…

A: Given:- L1= 1.5 L2= 0.3 L3= 0.4 L4= 0.5 M= 520 T=700 To find:- a) Reaction force at roller b)…

Q: A smooth, homogeneous sphere is held ar rest by the two inclines as shown. Determine the reactions…

Q: Q4) Determine the horizontal and vertical components of reaction on the beam caused by the pin at B…

A: The reaction at the point A will be in the vertical direction only and it can be determined as,

Q: The figure below shows the hollow cylinder that each weighs 100 lb.

Q: Q2: Determine the reactions of fixed support at A 15 kN 7 kN/m 4 kN/m 60° A 3 m 3 m

Q: 150 lb/ft B 6 ft 8 ft

A: divide this load into two parts from A to C and C to B the total load of UVL (from A to C) =…

Q: The cable shown in Fig. If the sag ha in the cable is 200 m, determine weighs 30 N/m. The tension in…

A: Write the expression for tension in the cable.

Q: The cables shown in the figure are used to support a 40-lb crate. Determine the reaction of cable AB

Q: A T-shaped bracket supports the four loads shown. Determine the reactions at A and B (a) if a = 10…

Q: A 2600-lb tractor is used to lift 900 lb of gravel. Determine the reaction at each of the two rear…

A: Let RA be the reaction at each of the two rear wheels A. Hence, 2RA be the combined reaction at the…

Q: The bent rod is supported by a smooth surface at B and by a collar at A, which is fixed to the rod…

A: Given that F = 170 lb M = 350 lb⋅ft

Q: Q5: Determine the horizontal and vertical components of reaction at the pin A and the reaction of…

Q: From the given beam: Determine the vertical reaction at the roller support. 5000 lb 4000 lb 1000…

Q: Determine the value of P and F to maintain equilibrium of the forces. 105° 60 300 lb Determine P 45°…

Q: Determine the magnitude of the reaction at support A, in lb. If: P = 342 lb, h = 19 in., A = 22 in.…

Q: A fixed crane, as given in figure, has a mass of 1000 kg and is used to lift a 2400-kg crate. It is…

A: Given data: The mass of crane, m1=1000 kg. The mass of crate, m2=2400 kg. Draw the free-body…

Q: Refer to the diagram. The roller at A is in a smooth slot. Determine the reactions at A and O.

A: for vertical equilibrium F1sin 55 + Ay = Ry1.258 * sin 55 + Ay = Ry For Horizontal Equilibrium…

Q: The crane BC shown below lifts a load of W. Neglecting the weight of the crane. Determine the…

Q: A smooth, homogeneous sphere is held ar rest by the two inclines as shown. Determine the reactions…

Q: From the given set of distributed load shown. Determine the reaction at the right support B. 400 N/m…

Q: A mass M of 300 kg is supported by a boom, as shown. Determine the tensile force in the cable 'and…

A: Solution:

Q: A uniform plank 8 ft long is balanced on a corner If using a horizontal force of 75 lb as shown in…

A: Let's draw free body diagram of 'AB' as shown in figure. Here, W=45 lb

Q: The vertical bar is cantilevered to the floor as shown. Determine the reactions at B.

Q: Determine the reactions at point C and the force in cored AB 30° В 800 lb/ft -15 ft -15 ft-

Q: The jib crane is fixed at ( A ) and carry a pox of ( 2500 kg) mass, as shown in the figure.…

Q: Q2/. Determine the reactions on the bent rod which is supported by a smooth surface at B and by a…

A: Given data Force acting on rod is 100 lb Moment - 200 lb-ft

Q: 750 50 N 550

A: Let T is tension in the cord N is reaction of inclined plane Free body diagram of sphere…

Q: Collar A is connected as shown to a 50-lb load and can slide on a frictionless horizontal rod.…

A: Draw the free body diagram of collar

Q: The unstretched length of spring AB is 2 m. If the block is held in the equilibrium position shown,…

A: Solution : Given data : unstretched length of spring AB is 2 m.

Q: 1. The telephone pole AB weighing 3730 N is resting in a hole that is 2 m deep. If the contact force…

Q: Body W in fig. (1) has a mass of (1000 kg). Determine the reactions at A and B on member AB.

A: Given data: Mass of the body, m = 1000 kg. Draw the free-body diagram of the string connected with…

Q: The homogeneous bar AB weighs 80 lb. End B is supported against a vertical wall and end A is…

A: Given Data Weight of bar AB is :WAB=80 lb Now draw the free body diagram:

Q: 5) The system shown is in equilibrium. Find the force exerted on the strut by the hinge at point A.…

A: The combined free-body diagram of the given system is given below:

Q: Neglecting the mass of the beam, compute the reactions at A and B. 600 lb 150 Ibt Fontont 7200 lb-ft…

Q: The truss shown is supported by a pinned connection at A and a roller (on a plane inclined at 25 to…

A: Given: F¹ = 2.67 kN To Find: The reaction at D.

Q: are joined at the junction ring C. Determine the tensions in cables AC and BC caused by the weight…

Q: d) system of chains Write the solution here: Determine the maximum weight of the engine that can be…

A: Given data: The tension in the cable AB, FAB = 450 lb. The tension in the cable AC, FAC = 480 lb.…

Q: As shown in the figure, three cylinders have a weight of 15 lb, 40 lb, 20 lb was stacked up on a…

Q: A small winch is used to raise a 120-lb load. Find (a) the magnitude of the vertical force P that…

A: Draw the free body diagram for the above problem. Write the position coordinate for point C from…

Q: Determine the magnitude of the reactions at A and C (resultant). 2m 1.8m 3m 12KN/m

A: The equivalent force due to uniformly varying load can be determined as the area of a triangle…

Q: PROBLEMS 1 - A ( 200 N ) weight of the block shown in fig. is supported by a pin and bracket at ( A…

A: GIVEN DATA- A BLOCK SUPPORTED BY PIN AND CABLE WE HAVE TO FIND REACTION AND TENSION

Q: Neglecting the mass of the beam, compute the reactions at A and B. 600 lb 150 Ivt Fonto 7200 lb-ft…

Q: Determine the reactions at A (Ax, Ay) and B (By) for the bracket shown in the figure If you know…

A: Draw a labeled free-body diagram of the given system. Apply equilibrium equation of forces in the…

Q: 1 - A ( 200 N ) weight of the block shown in fig. is supported by a pin and bracket at (A) and by a…

A: Given data Weight of block = 200N

Q: Q) Find the required weight (N) and the angle 0 of block B for equilibrium. If the weight of block D…

A: Given, WD=375 NWC=230 N Since the pulleys are frictionless, the weight of the blocks B and C acts as…

Q: Three smooth cylinders, each weighing 500 N, is placed inside a smooth box as shown in the figure.…

Q: The 13m uniform rod as shown below weighs 1020 N. Segment AB and BC is 6m long. The cable acts at a…

Q: 10KN Di B. 5m 1.25m 1.25m 2.5m

Question

PLEASE SHOW COMPLETE SOLUTION AND FBD. THANK YOU.

A smooth, homogeneous sphere is held ar rest by the two inclines as shown. Determine the reactions at A andB (represent by RA and RB respectively). The weight of the sphere is 200N.
Solve by the triangle method.
75°
30°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Solve for the component of the reactions.
Q- Two radial 200 N and 500 N forces and tangential 700 N force are applied to shown system. If the system is in equilibrium find reactions at A and B. 500 N 200 N 700 N 10 15 2 m 1.1 m A B Solve the following question in the attachment by two methods A. Scalar B. Vector Show that result of both methods are the same
Solve for the reactions at A.
2. The homogeneous bar AB weighs 25 lb. Determine the forces acting on the bar at A and B. Neglect friction. 60° A
The homogeneous AB beam weighs 400 lbs. For each support condition in (a) a (d), plot the DCL of the beam and determine the number of unknowns.
solve for the reaction forces
Solve for the reaction of supports
Solve for the reactions where the beam is fixed to the wall at A.
The frame is subjected to a horizontal force F = {25 j} kN. Apply the learned concepts of forces and equilibrium to compute the components of this force parallel and perpendicular to the member AB. B F= { 25 j } kN 4 m A 3 m 8 m
find the reactions for each.
1. Find the distance x (measured along AB) at which a horizontal force of 60 lb should be applied to hold the uniform bar AB in the position shown. Bar AB is 10 ft long and weighs 140 lb. The incline and the flpor are smooth. 60 Ib
1) Determine the reaction at roller A. Express your answer to three significant figures and include the appropriate units. 2) Determine the horizontal and vertical components of reaction at pin B( Bx,By) . Express your answers in newtons to three significant figures separated by a comma.