A single phase AC motor is connected to a 240 V 60 Hz line a clamp on amp meter indicates the motor has a current draw of 15 A at full load a wattmeter indicates a true power of 2.2 KW what is the power factor of the motor load and how much capacitance is needed to correct the power factor to 100%

A single phase AC motor is connected to a 240 V 60 Hz line a clamp on amp meter indicates the motor has a current draw of 15 A at full load a wattmeter indicates a true power of 2.2 KW what is the power factor of the motor load and how much capacitance is needed to correct the power factor to 100%

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter26: Three-phase Circuits

Section: Chapter Questions

Problem 3PA: You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a...

See similar textbooks

Related questions

Q: Given a signal m(t) defined as m(t) = sin(300πt) + 4 cos(800πt) 1) Sketch the magnitude of the…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The n-channel FETs below have K n’ = 100μA/V^2, W = 60μm, L = 3μm, Vt = 0.7V, and λ = 0.03V ^-1. d)…

Q: A 300 Km single circuit 30 transposed TL is composed of 2 conductors per phase, with horizontal…

A: In this question, we need to choose the correct options. What is GMR and total inductance .

Q: Discuss the challenges and solutions related to integrating renewable energy sources into the…

A: To discuss:The challenges and solutions related to integrating renewable energy sources into…

Q: What does the circuit work like?

A: The above question is based on the firing circuit of a TRAIC.

Q: Hi, For the following resistive network, I am asked to calculate the equivalent resistance between…

A: Given:A network, we need to find:the equivalent resistance between the terminals a and b.

Q: of an Ideal What are the characteristics Operational Amplifier? Draw the diagram of an inverting…

A: The characteristics of the ideal opamp needs to be briefed and the circuit diagram of various…

Q: In the given circuit, determine vx and the power absorbed by the 60-Ω resistor. Assume /= 65 Α. 6Ω…

A: In this question, we need to determine the value of Vx and the power absorbed by 60 ohm resistance…

Q: Describe the process of semiconductor fabrication used to manufacture microchips. What are some key…

A: Semiconductor fabrication, also known as semiconductor manufacturing or microchip fabrication, is…

Q: + +₁₁ Rig O'sig Rin RG VDD=+5 V RD -VSS 8 Cg RL -0%

Q: 320 V + t=0 = 350 μF V Given: The capacitors have initial voltages as shown in the above circuit. At…

Q: A single circuit 30 transposed TL is composed of 3 ACSR 1272000 cmil conductor per phase, with…

A: The given configuration is shown below,

Q: Describe the importance of power system protection mechanisms, including relays and circuit…

A: The importance of power system protection and various types of protection devices and strategies…

Q: Show me step by step how to do this design

A: The implementation of the logic gate using the IC in multisim software needs to be briefed.

Q: 1.88 Consider the circuit of Fig. P1.88 with R₁ = 2 ks, R2 = 5 k2, and C₁ = 0.1 μF. Plot vOUT and i2…

A: Given:a system, with, we need to find and plot:Vout and i2

Q: Explain the role of fabrication processes like photolithography in the manufacturing of microchips,…

A: Fabrication processes like photolithography are critical in the manufacturing of microchips…

Q: Use the step-by-step method to find the value of the output current just after the switch opens,…

Q: A battery is used to move 400 coulombs of charge across a potential difference of 10 volts. What is…

Q: Discuss the concept of light propagation in optical fibers. What are the principles of total…

A: Light propagation in optical fibers involves the transmission of data via light signals through…

Q: Discuss the various types of renewable energy sources used in modern power systems and their…

A: To discuss:the various types of renewable energy sources used in modern power systems and their…

Q: 14. For the feedback system shown in Fig. 5.55, find the value of the gain K that results in…

Q: In the figure 8 = 9.22 V. R₁ = 12400, R₂ = 30500, and R3 = 3020 02. What are the potential…

A: We are givenwhere

Q: One characteristic of the emitter follower is ______. A. low resistance output B. low current…

A: One characteristic of the emitter follower is-a) Low resistance outputb) Low current amplificationc)…

Q: What are the key challenges associated with power system stability and reliability?

A: To explain:What are the key challenges associated with power system stability and…

Q: The switch closes at t=0 and opens at t=1 when the initial storage value of the inductor and…

A: A DC-series RLC circuit with a switch is given. The switch closes at t = 0 and opens at t = 1…

Q: Exampley Find parameters + V₁ 2, the 42 admizzance. 212 + V Iz 2

Q: In the following circuit, R, is an active sensor and Rc is an identical dummy sensor used for…

Q: 1. What value of R will result in a balanced bridge? a) 300, b) 600Ω, c) 300Ω, d)3/ΟΚΩ 2. With R =…

A: Given circuitAsked to find the,

Q: Explore the concept of System on a Chip (SoC) and provide examples of its applications in modern…

A: A System on a Chip (SoC) is an integrated circuit that incorporates various components of a computer…

Q: For the given circuit of FIGURE 2: Calculate the capacitor voltage for t 12 V FIGURE 2 +1 2 F + v -…

Q: How does the integration of microgrids and distributed energy resources (DERs) influence the overall…

A: The effect of the integration of micro grids and DER in the power system design and its operation…

Q: Problem 03.073.a - The Q-point of the diode Determine Q-point for the diodes in the circuit given…

A: Given Data:A DC resistive network with,Ideal diodes (From left side)To Find:The Q-Points of the…

Q: Explore the role of power factor correction and reactive power in power quality improvement within…

A: Power factor correction and the management of reactive power are essential aspects of improving…

Q: GI 30V + Calculate current 14 by converting the A circuit to Y ((abc) in the figure) 14 24 1052 cu…

Q: Design a clocked synchronous state machine with the state/output table below, using D flip flops.…

A: we need to design:A synchronous state machine with state/output table below:

Q: For the circuit shown. Using nodal analysis to determine node voltages. 0 727 62 m sn 10л 32 422 m…

A: We need to find the node voltages using nodal analysis.

Q: What is the significance of substations in power systems, and how do they help manage voltage…

A: Substations are the points in the power system where transmission lines and distribution feeders are…

Q: urrent through capacitor is shown below. At the voltage, power, and stored energy to scale versus…

A: define voltage across capacitor

Q: 1. Calculate Vx & Vy in the circuit of Fig1. 40 /30° V =j2 Ω 8 Ω 3 Ω j6 Ω 10 Ω Σ΄, 5/0°A

A: Given:a circuit,we need to find:the values of Vx and Vy.

Q: In the circuit, diode D1 has n = 1.4 and has an operating point I D = 1mA at V D = 0.7 V and is at…

A: The circuit is given ashere

Q: 8 ΚΩ με 160 ΚΩ 240 ΚΩ • 35 V –35V * {30 ΚΩ

A: Given non inverting amplifierNeed to find Vo/Vg..?

Q: Find Vo and Ix via superposition. Please give step by step explaning the work.

A: For the given circuit the value of the unknown voltage and current needs to be calculated by using…

Q: a system whose closed-loop transfer function is given by G(s)=K/s(s^2+s+1)(s+2)+K derive a…

A: Closed-loop transfer function of a system is,To determine:stability of the system using…

Q: How does a transformer work in a power system, and what are its applications in voltage conversion

A: A transformer is a crucial device in a power distribution system that operates on the principle of…

Q: Clock and Data Signals are shown for a D-Latch. Sketch the output waveform Q. Assume the propagation…

Q: Find the Energy and Power for the following signal x(t) = e^²t.u(t)

A: Function is given as,

Q: An amplifier current gain will be slightly less than 1, but its voltage gain will be high. This is…

A: Given that, an amplifier current gain will be slightly less than 1, but its voltage gain will be…

Q: 14. With regard to the circuit represented in Fig. 9.39, determine (a) ic(0); (b) i(0); (c) ig(0);…

A: Since multiple subparts have been asked, as per Bartleby guidelines only the first 3 have been…

Q: Problem 7-4. For the circuit shown in figure P7.4, determine v₁(t), vc(t) and ix(t) for t≥ 0+.…

Q: For the circuit in the given figure, use KVL to find the branch voltages V₁ to V4. Assume A = 7 V,…

A: In this question, we need to determine the unknown voltages V1 , V2 , V3 4using the KVL.

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction about the given question

VIEW

Step 2: Calculation for the power factor and capacitance

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Can V curve be plotted for an alternator. If yes then what is the difference between V curve of an alternator and V curve of a motor.
(b) A 4-pole 3 phase alternator is driven at 1200 rpm. What is the frequency of the output voltage of the alternator? Explain how the same alternator can be used to generate voltage at 50 Hz.
A single phase motor is rated 5hp, 75% pf lag,220V. What is the approximate size of capacitor is necessary to raise the power factor to about 95%?
How can you tell that the power pumped by an alternator is directly proportional to the load angle?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
A single phase AC motor draws 4.5 A from the 220 V, 50 Hz network. The active power drawn by the motor from the mains is 720 W. Calculate the Capacitance (C) and Power of the capacitor that should be used to make the Power factor of the motor 0.95.
A 60 cycle alternating current with a maximum value of 10 amperes has an instantaneous value of 5Amperes when t=0 while di/dt is positive. What is the equation of the current wave?
A small facility has two 20 kW of incandescent lights and three 25 kW motors that have a power factor of 80%. What is the power factor of the combined load?
A single-phase motor is rated 5HP, 75% pf and 220V. What is the approximate size of capacitor needed to raise the nower factor to about 95%?
Correct the power factor for a motor connected in series with a 120V RMS 60Hz power supply. The motor has an inductance of 200mH and an internal resistance of 30 ohms.
EXPLAIN BRIEFLY THE SYCHRONOUS ALTERNATOR WHEN OPERATING AT NO LOAD
When 40V DC voltage is applied to a single-phase AC motor, it draws 1A current. When 200v-50Hz AC is applied to the same motor, it draws 4A current. Calculate the capacity of the capacitor to be connected in parallel and the circuit current in this case to make the power factor of this motor 0.9.