Answered: A series circuit consisting a 9 ohm…

A series circuit consisting a 9 ohm resistance and 69.747 microfarad capacitance is connected across a 220 Voltas 60Hz supply. Calculate the magnitude of the total impedance of the circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Compose the mesh equations. 10 Q j10 O j10 O ll ll 10 V [11] [ 12] へ)15V -j10 O sine sine @mesh 1:…

A: In this question, We need to determine the real and imaginary part of impedance

Q: Vhat would be the barrier potential of a silicon diode when the junction emperature is at 10°C?…

Q: 1) A load of 20 + j35 ohms is connected across a 220 volts source. Determine the VARS. 2)…

A: The solution is given below

Q: Given that RI = i0, R2 (Rload) - IKA, LI - 750mH, k - 1,Vi - 220V.f = 60HZ, assume an ideal diode,…

A: A center tapped full wave rectifier is given. It converts AC into pulsating DC.

Q: 1 A three-phase, four-pole, star-connected wound-rotor induction motor is to be controlled by…

A: Triac stands for triode for alternating current. It is a three terminal device and has capability to…

Q: =) The switch in the circuit shown in Figure Q1(c) has been closed for a long time before opening t=…

Q: In a balanced A-Y circuit, Vab = 240/15° and Zy = (12 + j15) N. Calculate the line currents. Answer:…

A: Given data, VAB = 240∠15° VZY = (12+J15)Ω

Q: ithin a satellite transponder, the implementation of a Low Noise Amplifier (LNA) is important to:…

A: Low noise amplifier is the starting circuit of the transponder. Ideally LNA should not add any noise…

Q: A continuous-time signal is composed of in-phase sinusoids with periods of 1 ms, 2 ms, and 4 ms.…

Q: For the following network, find the value of load resistance RỊ for maximum power to RL. R1 R3 6Ω…

Q: find the power Supply in bhe Cir cuit in fig. 12ka 12kn

Q: . Determine the output voltage

Q: For medium transmission line under light load or no load condition the receiving end voltage is…

Q: Plot the graph between P vs Va in Dc series excitation motor

A: Armature voltage : Armature voltage is the voltage developed at the…

Q: Refer to Figure 8. Find Thevenin equivalent circuit with two different methods.

Q: A six pole three-phase 440-volts 50Hz, induction motor develops an 8-Hp at 955 rpm, the power factor…

A: The solution is given below

Q: Gi G3 土 G2 Gu

Q: Determine the current, voltage and power

Q: Q/ Name a Schottky diode that operates at small frequencies

A: The Schottky diode is a type of metal– semiconductor junction diode. Schottky diodes are also known…

Q: Find the value of ZL for maximum power transfer in the network and th maximum power that can be…

A: In this question, We need to find the value of ZL for the maximum power transfer to the load.…

Q: Using the drain characteristic of Fig. a. What is the value of ra for VGS = -1 v? b. What is the…

A: The drain characteristics are plotted between VDS and ID of the FET or MOSFET.

Q: Calculate the (a) r.ms. value, (b) the form factor and peak factor of a periodic voltage having the…

A: Given here a periodic voltage having the following values for equal time intervals changing suddenly…

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered at a time,…

Q: The partial ac equivalent circuit of an amplifier is shown below. If R1 = 45 kN and R2 = 1.09 kN,…

A: Given data, R1 = 45kΩR2 = 1.09kΩ

Q: Vo(s) V(s) each of the operational amplifiers shown, find the transfer function G(s) %3D 100k ohms…

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

Q: R(s) C(s) g4 + 353+ 2s² + s+ 1 g5 + 4s4 + 3s3 + 2s² + 3s + 2

Q: 9 Find I(s) and I(s) in the circuit of Fig. 16.92. 1 H 2 H 2 H i2 ell 10e-3'u(t) V 1Ω 10

Q: *13. Find the Thévenin equivalent circuit for the portions of the networks of Fig. 18.121 extenal to…

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per the guidelines of bartleyby I need to Answer first three subparts only so kindly repost other…

Q: Pollution and pollutant standards in regards to power plants

A: Major power plants are thermal power plants and fuel of thermal plants is coal. Coal is major source…

Q: Find Q point ( Ie, VCE) Veu 12 B : 100 1 VA = 0 300KA R2 R3 160KA Ry { 13KA

Q: The signal with the am module is given below. what is modulation index 1.5 0.5 -0.5 -1 -1.5 0.5 0…

A: Given here an am modulation graph and asked to determine the modulation index of the waveform.

Q: a. What is the Staebler-Wornski effect in an amorphous silicon (a-Si) solar cells and how can it be…

A: Solution (a) - Staebler-Wornski effect - The light-induced metastable changes in the…

Q: Solve the following FIND CURRENT FLOWING THROUGH Z3 FIND CURRENT FLOWING THROUGH Z4

A: The given circuit is shown below with mesh currents and assumed current directions in each…

Q: Between line a and b , line b and c and line c and a of a balance 230V 3-phase systen are connected…

A: It is given that: 10 A @ unity p.f.20 A @ 0.5 p.f. lag30 A @ 0.866 p.f. lag

Q: 13. Find the Thévenin equivalent circuit for the portions of the networks of Fig. 18.121 external to…

A: The solution is given below

Q: a) G(s) = %3D s+ 10 1 b) s+1 G(s) = s+ 10 c) s+ 10 G(s): s+1 d) G(s) = (s+1)(s+100)

Q: 4. Determine the currents in the unbalanced bridge circuit below. Also, determine the potential…

Q: Determine the voltage output Vo and the current I of the sketched circuit referring to figure 3

Q: What is the per unit impedance of a 50 MVA, 13.8 kV, 1% impedance transformer if the base is change…

Q: If the surface-leakage current is 2nA for a reverse voltage of 25V, what is the surface-leakage…

A: Surface leakage current is directly proportional to the reverse voltage. Then if reverse voltage…

Q: Consider the circuit below, what is the current flowing at 16 kohms? 24 V Ge 8k2 V. 16kn O 0.58 mA O…

Q: 2.1.1

Q: y 20 B 10 |A T 27 Time

Q: What happens to the delay in a CMOS inverter if the load is increased? What are the Barkhausen's…

A: Solution (1) - Load capacitance in a CMOS circuit configuration is the sum of the input capacitance…

Q: Solve: Answers should be expressed using 2 decimal places a. k (transfer constant) = mA/v2 b. Ip =…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: Q1) Define briefly: 1. Optoelectronics. 2. Electroluminescence. 3. Internal quantum efficiency. 4.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: (i) i(0), v(0) (ii) a, o and circuit response (iii) dv(0)/dt (iv) v(0) (v) v(t) 20 40mF= v(t)…

Q: For the ahoork Find (resoune frguny) Dedomie Qp Delomne Ve at esonance Find T and I at risonance. Fy…

A: Given data : L= 3mH I=2mA R=50kΩ Rp=100Ω=.1kΩ C=50pf

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A series circuit consisting a 9 ohm resistance and 69.747 microfarad capacitance is connected across a 220 Voltas 60Hz supply. Calculate the magnitude of the total impedance of the circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 13099 B) 14999 O C) 15099 O D) None
A 25ohm resistor is connected in series with a %0 mH inductor. This circuit is connected to a 120V, 50Hz supply. Solve for a. Inductive reactance b. impedance c. S d. P e. Q
An inductive impedance of 40 + j40 ohms is connected in parallel with a pure capacitor. What must be the reactance of the capacitor in ohms so that the total current is in phase with the supply voltage of 230V?
Measure the voltage and current across the capacitor.Measure the average power delivered by the source.Observe the phase angle in the condenser
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
13.) Calculate the inductance or capacitance in series for the impedance 7.5z-53.13° ohms. Assume the frequency to be 60 Hz.