A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt] %3D where Vc = 11 V WC = 618.893753MHZ mf = 63 wm= 6465 Hz Find the following: (1) expression of carrier [ (ii) expression of message | (iii) modulation index mf [ (iv) frequency deviation Af ( (v) deviation sensitivity if the maximum amplitude of the message is 5V [ (vi) power dissipated in 1460 resistor [ (vii) Bandwidth of the FM Wave[

Q: An FM transmitter is determined to have a transmitter sensitivity of 410.348Hz/V. If the modulating…

A: Given, Frequency sensitivity (K)= 410.348Hz/V Amplitude of message signal(Am) = 27.397V  Therefore,…

Q: (A): Consider the frequency modulated signal s(1) = 10 cos[(10")mt + 5 sin 2#(10°)4] Calculate the:…

A: Thank you for the question. As per our policy I will be answering only first question (A). For the…

Q: Given the AM voltage equation. Determine the carrier voltage and frequency, the modulating voltage…

A: Given: VAM=310 cos (6,540,000 t)+650 sin (6,600,000 t) - 310 cos (6,660,000 t) Volts To do:…

Q: Step 2.2 Plot the following equations: m(t) = 2cos(2π*1.2kHz*t) c(t) = 5cos(2π*10.5kHz*t) Question…

A: Since the modulation index for the AM modulation is less than one . So there will be no zero…

Q: A. The output signal from an AM modulator is: SAM(1) = 20 COS (1200 10' n)t + 6 COS (1208*10'n)t + 6…

A: We need to analyse the given signal .

Q: A transmitter transmits an AM/DSB(single tone-modulating signal given by 3 cos(2n103t)volt/with a…

A: Please post the other question a separate question because according to our guideline by how to…

Q: An AM transmitter radiates 15kW. The modulation depth is rated at 80% with a channel capacity of…

A: We need to calculate the carrier power and bandwidth and side band power .

Q: Tagay The GSM cellular radio system uses GMSK in a 200-kHz channel, with channel data rate of…

A:

Q: Convolution of an image with the filter shown below will blur sharp image edges. 1 1 1 1 If the…

A:

Q: 1. A certain city has an area of 1,300 square miles and is covered by a cellular system using a…

A: Given    area of 1,300 square miles  40 MHz of spectrum with a full duplex channel band- width of 60…

Q: An FM signal is represented by the equation v(t) = 12 sin (6.28x108 t + 8 sin 1450t). Determine the…

A: We have to determine the unmodulated carrier frequency, the modulating frequency and the modulation…

Q: 4. An AM transmitter radiates 15kW. The modulation depth is rated at 80% with a channel capacity of…

A: In this question we will find carrier power , sideband power....

Q: Given the following FM modulated signal equation, determine the original message equation, m(t).…

A:

Q: A. An FM signal has the form S(t) = 20 Cos (2 n fc t+ 12 Sin (2 n fm t)) Where fc = 400 MHz, and fm…

A: In the question,  A FM signal s(t) = 20cos(2πfc t+ 12sin(2πfm t))  Where fc = 400Mhz and fm = 20Khz…

Q: In a DSB-LC system, the message signal is 15 cos (87T*10*t) and the modulation index is 0.8. The…

A: We need to find losses and signal to noise ratio for given system

Q: Q.2] A 40-km single-mode fiber has a dispersion parameter D = 10 ps/nm-km. An %3D optical signal of…

A: The solution is given below

Q: 2. An FM signal is represented by the equation v(t) 12 sin (6.28x10*t + 8 sin 1450t). Determine the…

A: Given: The equation of the FM signal is vt=12sin6.28×108t+8sin1450t

Q: Suppose a communications system that transmits a user's information, given by the following signal:…

A: According to the question, the information signal  xt=3cos2π.200t+5cos2π.300t. frequency of the…

Q: An FM signal is represented by the equation v(t) = 12 sin (6.28x108t + 8 sin 1450t). Determine the…

A: The solution can be achieved as follows.

Q: Q2. An FM transmitter is modulated with a single tonc A, cos (2tA,t) and a carrier amplitude of Az…

A: Since Ac=A3=83 v  And RL=A4=419 ohm    So Pavg=(83^2)/(4×419)     Pavg=4.11watt

Q: Consider a quadrature carrier multiplexing (QAM) system that is used to transmit two message signals…

A:

Q: 01: A satellite broadcast system operates at 12.45 GHz, with a transmit power of 120 W, and a…

A:

Q: A- Assume you have a Frequency Modulator where its instantaneous frequency varies with the message…

A:

Q: 1. Assuming you are positioned at 5500 meters from the omnidirectional radio receiver you are…

A: Given, Distance, di=5500 m Distance, ds=3000 m Signal transmitter’s EIRP (Effective isotropically…

Q: What is the modulation index of an FM transmitter whose frequency deviation is 50 kHz, while its…

A:

Q: A. An FM signal has the form S(t) = 10 Cos (2 a fc t+ 4 Sin (2 n fm t)) Where fc = 200 MHz, and fm =…

A: In the question,  Now A FM signal s(t) = 20cos(2πfc t+ 12sin(2πfm t))  fc = 400Mhz and fm = 20Khz…

Q: 3.31 The carrier c(t)= 100 cos 27 fet is frequency modulated by the signal m(t) = 5 cos 200007 t,…

A: 3.31  Ct=100 cos2π 108t⇒Ac cos 2πfct           mt=5 cos 2π10000t⇒Am cos2π fmt…

Q: 1.1 0.9 Jo 0.8 0.7 0.6 0.5 J4 Js 0.4 0.3 0.2 0.1 1. 10 1 -0.1 -0.2 -0.3 -0.4 -0.5 A given FM…

A:

Q: 3. A transmitted RF signal is given by yRF (t) = 10 cos(2 nfct + Bsin (2 afmt)), where fc=100MHZ,…

A: As per our guidelines we are supposed to be answer the first three questions only. Kindly repost the…

Q: A certain city has an area of 1,300 square miles and is covered by a cellular system using a…

A:

Q: Q: Consider the signal cos(2n10 1)+0.1sin(2n10't) is used to generate WBFM with Af no more than…

A: Given : m(t)=cos2π102t+0.1 sin2π103t ∆f=77KHz fc=100MHz fm=maxfm1,fm2fm1=102Hzfm2=103HzThus…

Q: In an amplitude modulation system, the message signal is given by Fig.below and the carrier…

A: Since you have asked multiple subparts and not specified which one to answer. I will answer the…

Q: 1. A certain city has an area of 1,300 square miles and is covered by a cellular system using a…

A: Given

Q: Suppose a communications system that transmits a user's information, given by the following signal:…

A: Since you have asked multiple questions, we will solve the first question for you. if you want any…

Q: Q2 Consider a message signal m(t) = 2 сos(2π × 10t) + 4 cos(2π × 15t) + cos(2π x 40t). The message…

A:

Q: If the SNR of a wireless link is 180B and the RF bandwidth is 30kHz, using Shannon's capacity…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The optical power, after propagating through a fiber that is 7 km long is reduced to 30% of its…

A: Consider the given data: The length is given as 7 km The optical power is reduced to 30% of its…

Q: A message signal m(t) has a bandwidth of 10 kHz, a power of 16 W and a maximum amplitude of 6. This…

A:

Q: The message signal m(t) shown in the figure below frequency modulates the carrier signal c(t) = 20…

A:

Q: 1. An FM signal , 2000 sin(2n x 10®t + 2sin Tx 10°t), is applied to a 50 ohms antenna. Determine:…

A:

Q: In a broadcasting communication system, the transmitter power Pr is 80 KW, the channel attenuation…

A: We need to calculate (S/N) ratio for input and output for the given recommended values.

Q: In a broadcasting communication system, the transmitter power Pr is 80 KW, the channel attenuation…

A: Communication system

Q: 8) Consider a GSM uplink (900 MHz). The MS has 100-mW transmit power, and the sensitivity of the BS…

A: First we will find out the received power then we will find out losses .

Q: A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt] %3D where Vc = 11 V wC =…

A:

Q: A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt] where Vc = 16 V wC =…

A: From the given data we can calculate all the required values. They mentioned the amplitudes of m(t)…

Q: Q1. Consider a message signal m(t) = 20 cos(2Ħt) and a carrier signal c(t)=50 cos (100 z t), both in…

A: Given, modulating or message signal is, mt = 20 cos2πt = Am cos2πfmtHere:Am = 20fm = 1 Hz Carrier…

Q: Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with…

A: An antenna refers to an interfacing channel between the radio waves which are travelling through…

Q: Consider a message signal m(t) = 2 сos(2π x 10t) + 4 cos(2π × 15t) + сos(2π X 40t). The message…

A:

Q: Problem 1: In a broadcasting communication system, the transmitter power P, is so KW, the channel…

A: Dear student you posted 2 question with multiple sub-parts.You did not mentioned which question you…