2. A furnace is charged with 100 kmols of fuel gas, the composition of which is: 50% CO,30% H2, 5% CH4, 5% C2H6 and 10% O2. Dry air is supplied 50% in excess for combustion.Assuming complete combUstion.a) Complete analysis46rty of and for the exclusive use of SLU. Reproduction, storing in a retneval system, distributing. uploading or posting online, or transmitting in any form or by any5, electronic, mechanical, photocopying, recording, or otherwise of any part of this document, without the prior written permission of SLU, is strictly prohibited.STIOUIS

Total number of moles of fuel gas = 100 kmols % CO = 50 %, % H2 = 30 %, % CH4 = 5 %, % C2H2 = 5 %,%…

A furnace is charged with 100 kmols of fuel gas, the composition of which is: 50% CO, 30% H2, 5% CH4, 5% C2H6 and 10% O2. Dry air is supplied 50% in excess for combustion. Assuming complete combustion. a) Complete analysis

A furnace is charged with 100 kmols of fuel gas, the composition of which is: 50% CO, 30% H2, 5% CH4, 5% C2H6 and 10% O2. Dry air is supplied 50% in excess for combustion. Assuming complete combustion. a) Complete analysis

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Feed gas containing of 78.5mol % H₂, 21% of N₂ & 0.5% of Ar is mixed with recycle gas and enters a reactor where 15% N₂ is converted to NH3 as per the reaction. Ammonia from the exit of the reactor is completely separated from unconverted gases. To avoid the buildup of inerts, a small fraction (5%) of the unreacted gases purged and the balance recycled. USING ASPEN/HYSYS Draw the process flow sheet Product rate and Purge rate Basis:100mol/hr
4. Producer gas from bituminous coal (see table below) is burned with 20% excess air. Calculate the air fuel ratio on a volumetric basis and on a mass basis. Various Natural Gases Producer Gas Carbureted Coke- from Bituminous Water Oven Constituent A B C Coal Gas Gas Methane 93.9 60.1 67.4 54.3 3.0 10.2 32.1 Ethane 3.6 14.8 16.8 16.3 Propane Butanes plus 1.2 13.4 15.8 16.2 1.3 4.2 7.4 Ethene 6.1 3.5 Benzene 2.8 0.5 Hydrogen 14.0 40.5 46.5 Nitrogen 7.5 5.8 50.9 2.9 8.1 Oxygen 0.6 0.5 0.8 Carbon monoxide 27.0 34.0 6.3 Carbon dioxide 4.5 3.0 2.2
2. A furnace is fired with fuel oil with a partial analysis of 7.6% S and 2.8% N. Orsat analysis of the stack gas shows 9.44% CO2, 1.19% CO, 0.4% SO2, 0.47% H2, 6.8% O2 and 81.7% N2. Air supplied is at 23 deg Celsius, 755 mmHg and 85% RH. Calculate the percent excess air. a. 55% b. 78% c. 23% d. 38%
Two-hundred fifty pounds per hour of iron pyrites containing 90% FeS2 and 10% gangue are burned with 20% excess air based on conversion to SO3. The cinder discharged from the burner contains no sulfur. No conversion to SO3 occurs in the burner. The burner gas is passed through a converter which effects a 98% conversion of SO2 to SO3. The converter gas is passed to an absorber where all the SO3 is absorbed by 80% H2SO4 solution, which becomes 100% H2SO4 solution in the process. Establish a basis of one hundred pounds of iron pyrites Calculate: (a) the burner gas analysis, (b) the converter gas analysis, (c) pounds of 100% H2SO4 produced per 24-h day, if waste gas analyzes 0.19% SO2, 4.14% O2 and 95.67% N2
The liquefied petrolieum gas(LPG) is composed of 80% C;Hg and 20% C4H10 in mass basis. (1). Determine the molar fraction of C3H8 and C4H10 in LPG. (2). Determine the stoichiometric air fuel ratio of the LPG. (3). Determine the lower heating value of LPG in kJ/m³ at 25°C and 100 kPa. (4). LPG is mixed with excess air to burn in a boiler at 100 kPa. The CO2 in burned gas is 7% on dry basis. Determine the equivalence ratio of the mixture.
Naturally occurring barium sulphate is converted into water–soluble formby heating with carbon, thus reducing the sulphate to barium sulphide(BaS). The resulting reaction mixture, “barium black ash”, contains 65%w/w soluble BaS and is to be leached with water. Black ash is to be fedto a tube mill at 100 tonnes per day, together with the overflow from thesecond of a cascade of thickeners, and the effluent from the mill is fed tothe first thickener. All the barium is dissolved in the mill. The strongsolution leaving the first thickener contains 20% w/w BaS by weight.Each thickener delivers a sludge with 1.5 kg liquid per kg of insolublesolid. Both liquids leaving each thickener are to have the same BaSconcentration. BaS lost with the final sludge should not exceed 1 kg perday.How many thickeners are needed?
3. Methane enters the furnace at a rate of 100 mol/min and is burned with air in a furnace, Dry excess air enters the furnace at 25°C and1 atm. The stack gas leaves the furnace at 473 K and 1 atm and contains CO2 at a partial pressure of 61.56 mmHg, CO at partial pressure of 6.84 mmHg, water, oxygen, and nitrogen. Calculate a. the percentage of excess air. b. the composition of stack gas in dry basis. c. the dew point of the stack gas. d. the volumetric rates of air and stack gas logP* = A – T+C P* [mmHg], T[°C] Water 8.10765 1750.286 235
Activity 2: Calculations based on fuel analysis Self-Assessment No. 2 1. 100 kmols of moist hydrogen gas containing 4% water by mole is burnt completely ina furnace with 32% excess dry air. a) Complete analysis b) Orsat analysis
In a metered-dose inhaler (MDI), such as those used for asthma medication, medicine isdelivered by a compressed-gas propellant. (The device is similar in concept to a can of spraypaint.) When the inhaler is activated, a fixed amount of the medicine suspended in thepropellant is expelled from the mouthpiece and inhaled. In the past, chlorofluorocarbons(CFCs) were used as propellants; however, because of their reactivity with the Earth's ozonelayer, they have been replaced by hydrofluorocarbons (HFCs), which do not react withozone. Now HFC use is also being reduced due to their high global warming potential. In one brand of inhalers, the original CFC propellant was replaced by HFC 227ea (C3HF7,heptafluoropropane). The volume of the inhaler propellant reservoir is 1.00×102 mL, and thepropellant is charged into the reservoir to a gauge pressure of 4.443 atm at 23°C. An onlinesearch for properties of HFC 227ea yields the information that the critical temperature andpressure of the substance…
The combustion gases from an industrial furnace using a hydrocarbon fuel and dry air enter the stack gas at normal barometric pressure and 3750F and have the following Orsat analysis: 12.2% CO2, 3.1% O2, 1.2% CO, and 83.5% N2. Determine the following: (a) The percent excess air (b) The volume of gases entering the stack, expressed as cubic feet per pound of carbon burnt in the furnace (c) The dew point of the stack gas (d) The atomic ratio of hydrogen to carbon in the fuel (e) The mol of stack gas per atom of carbon burnt
stack gas analysis: 83.08% N2, 7.5% CO2, 2.3% CO, 1.12% H2, 6% O2 with a saturation temperature of 54°C at 400°C and 760mmHg. a) %excess of air (1000 m^3 of air is supplied, produced 3100 m^3 of stack gas) b) chemical formula of the fuel burned c) analysis of the fuel mixture
PLEASE ESTABLISH BASIS ON THE STACK GAS A burner used Pittsburgh coal analyzing 14.1% ash, 2.1% N, 4.3% S. Excess air is supplied dry at 22⁰C and 1 atm. The stack gases at 285⁰C, 765 mmHg analyzes 9.65% CO2, 1.16% CO, 0.24% SO2, 0.58% H2 and 9.16% O2. Calculate: a) % excess air b) complete ultimate analysis of the coal, c) m3 air/kg coal and d) m3 stack gas /kg coal.