A copper conductor is connected in parallel with twice

Q: The magnetic force acts on the wire 1 +5 cm- 20 A 5 A 10 cm 2 cm None of the choices 0.1 mN 0.0286…

A: we need to find out magnetic force acts on wire 1.

Q: cable consists of braided copper and covered two pair conductors with shield.

A: STP cable consists of braided copper and covered two pair conductors with a 22AWG shield.

Q: For a particular length of the conductor, the capital cost of the conductor is proportional to the…

A: For a particular length of the conductor

Q: The return wire of the system is also used as an earth wire

A: In a power network  ,  Earthing system plays a vital role for network protection . It connects all…

Q: 6- Check if each of the following is orthogonal or not: [1 ii – A = G ) 1 i- A = iii – A =6

A: We will find whether the following matrices are orthogonal or not.

Q: 2-8. The following voltage waveform is seen on an oscilloscope connected to the input of a length of…

A: Given below clear explanation

Q: Fault currents are in quadrature with load currents when O a. resistance of the lines are neglected…

A: Resistance- Resistance in electrical system is a characteristics of material which resists electric…

Q: +5 cm- A 15 A 10 c

A: Given circuit shown

Q: 1 Calculate 4 -9 (6-175)=3 2

A:

Q: In delta connected system the voltage between any pair of terminal is voltage.

A: In delta connection as we know that line voltage is equal to the phase voltage.because only one…

Q: what is meaning of contamination of condensate water and reasons and how to solve this fault, 2-…

A:

Q: An ideal transformer has a 150-turn primary and 750-turn secondary. The primary is connected to a…

A: The solution is given below

Q: Ic (mA) 2.5 2.0 1.5- 1.0- 0.5 ol 0.7 V FIGURE 4-12 IB = 25 μA B = 20 μA IB = 15 μA IB = 10 μA IB=5…

A: Mode of operation of BJT Active region  Saturation region  Cut off region

Q: Force on .. s against field direction. +q b- No one of them

A:

Q: Zero Flag explained in a few lines

A: In microprocessors and microcontrollors there required a status flag for every operation performed…

Q: b- If accidentally, one of the secondary windings get disconnected, what would be the load voltages…

A: Step 1: Label the Transformer winding to have reference and somewhat re-arranged it to easily…

Q: The unit of measuring the Permeans of an electro-magnetic circuit is: Henry/m zenon Henry m/Henry…

A: The solution is given below

Q: Question 5

A: There are three types of buses-  Load bus Slack bus / swing bus Generator bus 1. Load bus- A bus…

Q: WHEN DECIDING ON THE DIRECTION FOR THE CURRENT, THE USUAL PRACTICE OR CONVENTION IS THAT CURRENT…

A:

Q: What is the Value of the magnetic filed in micro T at r=0m? If the wire r1= -3m I1= -4A And r2= 5m…

A:

Q: The magnetic force acts on the wire 2 +5 cm- 20 A 15 A 10 cm 2 cm 0.0286 mN 0.1 mN None of the…

A:

Q: Which DMM measurement would you expect based upon the red and black leads in this image? 12 V 8 V 4V…

A:

Q: Question: SCRS with rating of 70 0 V and 250 A are used in a string to handle 5 number of series and…

A:

Q: Question 8 The magnetic force acts on the wire 3 +5 cm- 20 A 15 A 10 cm 2 cm 0.1 mN 0.0286 mN

A: given current carrying square loop.

Q: why is there two types of coaxial cables ones with an Impedance 75 ohm (r) and ones with Impedance…

A: Coaxial cables:- A form of copper cable known as coaxial cable is specifically designed with a…

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

A:

Q: 62 子84 Vt Reg'd: Vt when the current passing through

A:

Q: If Kirchhoff's current law is apply to the magnetic circuit shown in the figure below then it can be…

A:

Q: If the area of cross section of a conductor is decreasing, then the resistance of the conductor will

A:

Q: The voltage across the short is 12 ohm 135 V

A: Solution: Given data Supply Voltage = 135v Resistance R= 12 ohm

Q: V₁ =12V R1 m 33052 R2 47052 R3 2202

A:

Q: . Bulb 1, 2,3 controlled by switch 1 in a parallel connection, bulb 4 controlled by switch 2 in…

A:

Q: In delta connected load, voltmeter measures 56 V. What will be the phase voltage

A:

Q: Please explain to me that KVL and KCL ,how I chose the direction for current +or -

A: In this question we discuss about KVL and KCL

Q: One of the following is the most frequent occurring fault in the power system. Two open conductor…

A: There are two types of faults namely unsymmetrical fault and symmetrical fault.

Q: Example 1-10 (SI) For the cast-iron core shown in Figure 1-9, find the flux density. It has uniform…

A: Given Data:A rectangular cast-iron core with a coil having,Number of turns Current through the coil…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.