A circular cylinder of 1.0 m diameter and 10 m length is rotated at 420 r. p.m. about its axis when it is kept is air stream with 11.0 m/s velocity perpendicular to its axis. Determine: (i) Circulation around the cylinder, (ii) Theoretical lift and lift co-efficient, (iii) Position if stagnation points,

A circular cylinder of 1.0 m diameter and 10 m length is rotated at 420 r. p.m. about its axis when it is kept is air stream with 11.0 m/s velocity perpendicular to its axis. Determine: (i) Circulation around the cylinder, (ii) Theoretical lift and lift co-efficient, (iii) Position if stagnation points,

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The stagnation pressure in a Mach 2 wind tunnel operating with air is 750 kPa. A 4-cm-diameter sphere positioned in the wind tunnel has a drag coefficient of 0.95. Calculate the drag force on the sphere. FD N
The shock waves on a vehicle in supersonic flight cause a component ofdrag called supersonic wave drag Dw. Define the wave-drag coefficient asCD,w = Dw/q∞S, where S is a suitable reference area for the body. Insupersonic flight, the flow is governed in part by its thermodynamicproperties, given by the specific heats at constant pressure cp and atconstant volume cv. Define the ratio cp/cv ≡ γ . Using Buckingham’spi theorem, show that CD,w = f (M∞, γ ). Neglect the influence of friction.
The orientation of a hole can make a difference. Considerholes A and B in Fig. which are identical butreversed. For the given air properties on either side,compute the mass flow through each hole and explainwhy they are different.
The average wind speed at a proposed HAWT wind farm site is 12.5 m/s. The power coefficient of each wind turbine is predicted to be 0.41, and the combined efficiency of the gearbox and generator is 92 percent. Each wind turbine must produce 2.5 MW of electrical power when the wind blows at 12.5 m/s. (a) Calculate the required diameter of each turbine disk. Take the average air density to be ? = 1.2 kg/m3 . (b) If 30 such turbines are built on the site and an average home in the area consumes approximately 1.5 kW of electrical power, estimate how many homes can be powered by this wind farm, assuming an additional efficiency of 96 percent to account for the powerline losses.
Gas Dynamic Lab: 04: Select the correct answer for the following questions. 1. Lift is the component of this force that is .. . to the oncoming flow direction. (a) parallel, (b) with angle, (c) perpendicular 2. Does lift and drag of an airfoil depend on angle of attack? (a) True (b) False 3. Is airfoil shape similar to blades of the propeller? (a) True (b) False 4. Is airfoil can be characterized by the relation between the angle of attack, lift coefficient and drag coefficient? (a) True (b) False 5. The symbol means in the figure. (a) lift force (b) drag force (c) normal force Angle of attack
Calculate the minimum flight speed of an aircraft at constant altitude. Consider and aircraft with maximum take-off mass of 40,000kg CL=1.2 and a cruising altitude of 20,000m. The total lifting surface is 200m. Using properties of air from tables at standard atmosphere with 20,000m and -56.50°C. Da. 161.14m/s Ob. 181.14m/s Oc 171.14m/s Od.191.14m/s
**75. ssm A uniform rectangular plate is hanging vertically downward from a hinge that passes along its left edge. By blowing air at 11.0 m/s over the top of the plate only, it is possible to keep the plate in a horizon- tal position, as illustrated in part a of the drawing. To what value should the air speed be reduced so that the plate is kept at a 30.0° angle with re- spect to the vertical, as in part b of the drawing? (Hint: Apply Bernoulli's equation in the form of Equation 11.12.) A Moving air 130.0 Hinge Edge view of plate (a) (b)
Write the practical application of the Aerodynamics. How to Calibration of Air Velocity from Pressure Using Sub-Sonic Wind Tunnel? Write the components of Sub-Sonic Wind Tunnel?
In Batangas, one of its power plant has been thoroughly monitored for a possible conversion into a wind power plant. A propeller wind turbine is to be used. Survey showed that Batangas City has an average air velocity of10km/hr at 30 . The existing power plant has an output of 30MW. For the proposed wind power, the mechanical electrical efficiency is 70%. And the impeller diameter is assumed not more than 10m. Determine the following:a. Theoretical Wind Power Outputb. Electrical Power Outputc. Number of turbines to be installed
(1) Experiments show that in a slightly Viscorur flund at on a молод high speeds the drag force fo exerted on body depends on several parametes. An engineer assumes that the drag force fo is a functon of the budy width normal to the upstream Velocity, I upstream Velouty, ✓, the upstream flud veElucay P viscosity, M, speed of sound, I and the airfoils surface roughnars. " use the Buckingham ♬ Theorem to determine the functional dependence of to on non-dimensional flow similarity parameters (2:) Lot the transition to turbulence occur when I = 1.01m, V= 1·01m/s and M₁P = 1:01·10⁰5 m² s. Calculate the transchen Reynolds number, Retrains.
An aircraft with symmetric airfoil of wing area 20 m2, flyingwith velocity 60km/hr experiences lift coefficient of 0.8. Considering the aircraft flying at sea level conditions, determine the mass of the aircraft.
A thermistor probe, in the shape of a needle parallel tothe fl ow, reads a static temperature of -25°C wheninserted into a supersonic airstream. A conical disturbancecone of half-angle 17° is created. Estimate (a) theMach number, (b) the velocity, and (c) the stagnationtemperature of the stream.