A car passes over a hill as shown. Determine the following. a. Equation for the maximum speed of the car and still maintain contact with the road (in terms of r and g) b. Traveling at the same speed, what is the equation for the normal reaction of the road to the car when it passes the lowest point? c. If r = 50 m, determine the maximum speed in mph without catching air. d. The maximum normal force in Newtons at the low point if the car weighs 3000 lbs r +

A car passes over a hill as shown. Determine the following. a. Equation for the maximum speed of the car and still maintain contact with the road (in terms of r and g) b. Traveling at the same speed, what is the equation for the normal reaction of the road to the car when it passes the lowest point? c. If r = 50 m, determine the maximum speed in mph without catching air. d. The maximum normal force in Newtons at the low point if the car weighs 3000 lbs r +

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

The chain OA is 25 ft long and weighs 5 lb/ft. Find the maximum force in the chain and the distance H.
A 2.0 kg object is moving to the right with a speed of 1.0 m/s when it experiences the force shown in the graph at right. What are the object’s speed and direction after the force ends? Paste the completed Bar Chart below. 1. identify the system 2. draw a quick sketch of the initial state of the object(s) 3. do a momentum bar chart
Hazel stands on the edge of a lookout admiring the view of a waterfall. The lookout is supported by a horizontal beam and a strut that makes an angle of 70° with the vertical. Hazel's mass is 60 kg 70° What is the horizontal force along the beam at the spot where she is standing? Use g = 9.81 m/s? for the acceleration due to gravity. Give your answer to the nearest Newton. Select one: a. 1721 N • b. 214 N c. 1617 N d. 626 N
1- (KINETICS) An elevator weight 25 KN and is moving vertically downwards with a constant acceleration. Write the equation of the elevator cable tension. Starting from rest it travels a distance of 35 m during an interval of 10 s. Find the cable tension during this time. Neglect all other resistances to motion. What are the limits of cable tension?
The figure below shows a diver going through general motion. The diver's center of gravity can be assumed to undergo a projectile motion. Assume that the diver takes off from a diving board such that his center of gravity is a height ho = 11m above the water level and enters the water at a horizontal distance 1 = 4m from the end of the board. If the total time the diver remains in the air is t2 = 2.3s, calculate the speed, vo, and angle of takeoff ,O, of the diver's center of gravity. Also determine the height, hi, the diver reaches at the top of the dive. (Note that tr is NOT half of t2.)
QUESTION 2 A canon fires a projectile at an angle of 23 degrees with the horizontal with an initial velocity magnitude of 22.2 m/s. The projectile ultimately hits the ground in the East of the launch point. Find the magnitude of the accelaration vector 2.35 seconds after the projectile was fired. Assume the effect of air resistance is negligible. Enter the accelaration in unit of m/s.
1) We would like to design a wagon system as below when filling coal into the furnace at the Coke factory inside Kardemir. In this system, we want the wagon to reach a speed of v= 2 m/s in t=4 seconds. It will then shoot at constant speed. How much engine power is required to tow a wagon with W= 390 kgf under these conditions P=? (Losses will be ignored). (The slope angle of the ramp is α= 11 degrees.)
The motor exerts a constant force of T (N) on the cable. The final speed of the crate of mass m (kg) is v (m/s). Find the equatlon tidl will define the distance x (m) down the plane that the crate will move, starting from rest. The coefficient of kinetic friction between the plane and the crate is 0.3. The final state is at h = 0 m. 0 (degrees) is the angle between the plane and the horizontal. g = 9.81 m/s?. Crate Motor O !mv /(9.81 * m * sind +T - 0.3 * 9.81 * m * cos0) m O mv / (9.81 * m * sin0 +T+0.3 * 9.81 * m * cos0) m O mv /(-9.81 * m * sin0 – T + 0.3 * 9.81 * m * cos0) m O mv /(9.81 * m* cos0 + T – 0.3 * 9.81 * m* sind) m Clear my choice
If there is n friction in the system, the Lagrange's equation will be based only on kinetic energy and protentional energy only. Select one: O True O False III O
A crane is lifting a system with a constant speed. The weight of each object is shown. Neglect the mass of the cables. Note that K stands for Kipps [1K = 1,000lbs] and is a unit of force. Do NOT convert or multiply by g. cable 1 How many forces are acting on the ring? 4. ring (2K) 6 How many forces are acting on the spreader bar? cable 2 cable 3 How many forces are acting on the load? 3. 45° 45° Are the forces on the system balanced? yes v spreader bar (20K) cable 4 cable 5 How much tension in is cable 1? K How much tension in is cable 2? K load (48K) BARNHART K How much tension in is cable 3? K How much tension in is cable 4? K How much tension in is cable 5? check answers'
A helicopter with a mass of 10,000 kg takes off straight up at t=0. The thrust of the engine is defined given as a function of time: FT= 95 0.18t- (kN). Where t is in units of seconds. How fast is it rising and what is its elevation at t=4s?
Problem 3: Use conservation of energy to find the speed and equations of motion to find the tension. This pendulum is made up of a 20-pound weight at the end of a cord that can be considered weightless. If the pendulum is released from rest from position 1, find its speed and the tension on the cord when it reaches position 2. 1 30° 2 6 ft