A camera equipped with a 152 mm focal length lens is used to take a vertical photograph from a flying height of 2780 m above mean sea level. If the terrain is flat and located at an elevation of 500 m, the scale of the photograph will be (a) 1: 15000 (c) 1: 22000 (b) 1: 20000 (d) 1: 24500

A camera equipped with a 152 mm focal length lens is used to take a vertical photograph from a flying height of 2780 m above mean sea level. If the terrain is flat and located at an elevation of 500 m, the scale of the photograph will be (a) 1: 15000 (c) 1: 22000 (b) 1: 20000 (d) 1: 24500

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter14: Highway Surveys And Location

Section: Chapter Questions

Problem 10P

See similar textbooks

Related questions

Q: 4) 1. Problem 6.5 - Solve using the Brooks method. Name Act A D E G АCTIM (LS) 15 12 11 12 6 9.…

A: What has to be done in this table please clarify

Q: Select the loading diagram which results in the maximum reaction at support D. Select the loading…

Q: Q2: A small catchment of area 90 ha received a rainfall of 75 mm in 60 minutes due to a storm. At…

Q: In a circumstances in a private construction where there are any indications that the work done is…

A: Introduction- Construction- It is the process of planning and management of the construction of…

Q: 4.0 m A=?- 1.6 m P=? 3.6 m T=? -2.0 m

Q: 3. A beam is loaded as shown. El is constant. The vertical reactions at B and C are equal to 80KN.…

A: ###Determination of Macaulay Method###

Q: Three velocities of 0.20",0.24", and 0.16" have been determined for stream flow through using of a…

Q: Problem 1: Determine the d T-Beam giventhe following bf= 700 mm bw= 300 mm hf- 100

Q: Determine the joint displacements, member end forces, and support reactions for the beam shown.

Q: The cantilevered beam with fixed end support at A and rollers at B and C respectively, it carries a…

Q: Determine the allowable load on a 3 m long layered built-up column made up of 6 nominal 2”x 6”…

A: Solution-The given values are as follows,The length (L) =3m=300mm6 nominal 2”x 6” piecesThe actual…

Q: Draw the LOAD (w) and the BENDIN shear force diagram. Assume that r

Q: Determine the x- and y-coordinates of the centroid of the shaded ar ! 3", 3" 4" 1.25" 10" 1.25" 3" B…

Q: A 30 m diameter and 1m deep single stage high rate trickling filter has following data Sewage flow =…

Q: Question 3.1 A circular curve is used as part of the horizontal alignment of a 2-lane, one way road.…

A: *Multiple questions* As per our guidelines we are supposed to answer?️ only one question. Kindly…

Q: A hollow circular shaft has an outer diameter of 100 mm and a wall thickness of 25 mm. The allowable…

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

Q: V (kN)| 48 | 28 8 x (m) |-20 -32 2 2 - 1.0 1.0

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: A cohesionless soil is subjected to a shear test. The normal stress and shear stress on the failure…

A: To Determine Major principal stress.

Q: A cylinder weighing 20 pounds slides in a free pipe as shown in the figure. The clearance between…

Q: Part A Determine the moment of inertia of the beam's cross-sectional area about the y axis. Set a =…

Q: The long chord of a compound curve is equal to 250 meters. The PC this curve is at STA 10+000 and…

Q: Calculate the chainage of the tangent points of the compound curve from the following: Stat.…

Q: NZTA is a transport modelling approach that can be adapted to active transport modes and is similar…

A: The New Zealand transport agency (NZTA) is a transport agency of New Zealand which makes the process…

Q: Calculate the chainage of the tangent points of the compound curve from the following: Stat.…

Q: On a horizontal curve of radius 60 m, a gradient of 4.5% is provided along with the camber. A The…

Q: Using the method of double integration, calculate the mid-span deflection of the beam shown in…

A: Applying Double Integration method E = 20 GPa = 20 x 103 Mpa I = 1600 x 106 mm4 = Moment of Inertia…

Q: What the difference between below methods, which are used from different procedure in estimation the…

Q: A 3 m wide rectangular channel, as shown, carries a flow of 11.7m³/s. hydraulic jump Ус y2 2 Az =…

A: Given data: rectangular channel width = 3 m Discharge = 11.7 m3/s At section 3 hump = 0.4 m

Q: A stack in an urban area is emitting 80 g/s of NO. It has an effective stack height of 100 m. The…

A: Given:- The emission of NO by a stack in an urban area = 80 g/s The effective stack height = 100 m…

Q: Given the following cross-sections notes. It is required to determine the earthwork volume on a…

A: We have to determine volume by using end area method corresponding given data.

Q: Will rate immediately. Need ASAP a. which of the ff gives the maximum shear in the beam? b. which of…

Q: Find the value of pressure at dpeth of 12.5 m from free surface of water. Tale density of water 1000…

A: Given data, Depth at which pressure is determined = 12.5 m Density of water = 1000 kg/m³ To find…

Q: The critical slip circle for a slope is shown below along with the soil properties. (c = 30 kN/m²)…

Q: n the total head of the flow falls close to the

A: when cavitation occurs in a pipeline flow at the top of the mountain

Q: Consider an inner beam-column joint in the ground floor roof of a eight storey building in Noida,…

Q: Q2: A small catchment of area 90 ha received a rainfall of 75 mm in 60 minutes due to a storm. At…

A: General water balance equation is: P = R + ET + ΔS. A water balance can be used to help manage water…

Q: The major and minor principal stresses at a point are 3Mpa and -3MP respectively. The maximum shear…

Q: have would could he would were If I were rich, I - travel around the world If he worked hard, he -…

Q: 1. Let a = 2 m, w = 5 kN/m, v = 8 kN/m. El is constant. A simply supported beam with overhanging…

Q: : 1. Determine the value of “b” in millimeters. 2. Determine the net area for tension in plates in…

Q: A. Determine the service load P, that the connection can carry based on yielding of gross section…

Q: A 30 m diameter and 1m deep single stage high rate trickling filter has following data Sewage flow =…

Q: Describe the major characteristics of the primary transportation modes

A: The procedures used to carry items from the maker to the ultimate destination are referred to as…

Q: A closed water tank 80cm-high, 120cm long, and 50cm wide is to be transported. The acceleration is…

Q: 60 mm 110 mm 110 mm 3 110 mm 4. 150 mm

Q: O -index is 0.5 cm/h and the base flow at the outlet is The drainage area of a watershed is 50 km2 D…

Q: Two plates each with thickness t = 16 mm are bolted together with 6– 22 mm diameter bolts forming a…

A: Answer: We are given data thickness t = 16 mm bar diameter = 22 mm Number of bar = 6 Bolt hole…

Q: Determine velocity KE-2300 J m-23 kg

A: Given, Kinetic energy, K.E =2300 J mass, m =23 kg We know, K.E =12mv2

Q: Find mass of car K.E=2300 J velocity=15 m/s

A: The given question is related with mechanics . In this question we are provided with value of…

Concept explainers

Photogrammetry

Photogrammetry is a technology of taking measurements of physical objects present in the environment, using photographs. It includes the process of recording and analyzing a three-dimension image in the two-dimension form. Photogrammetry was invented around 150 years ago in 1851 by Aimé Laussedat, he was also known as the father of photogrammetry, but this method was not in use until 50 years after its invention. This method was first used in Germany by Dr. Albrecht Meydenbauer in 1893 who was the director of the Royal Prussian Photogrammetric institute founded by him.

Question

A camera equipped with a 152 mm focal length lens is used to take a vertical photograph
from a flying height of 2780 m above mean sea level. If the terrain is flat and located
at an elevation of 500 m, the scale of the photograph will be
(a) 1: 15000
(c) 1: 22000
(b) 1: 20000
(d) 1: 24500

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A camera with a focal length of 20 cm fitted in an aircraft is used for taking vertical aerial photographs of a terrain. The average elevation of the terrain is 1200 m above mean sea level (MSL). What is the height above MSL at which an aircraft must fly in order to get the aerial photographs at a scale of 1 : 8000? (a) 2600 m (b) 3000 m (c) 3200 m (d) 2800 m
Question- A vertical photograph was taken at an altitude of 2000 m above mean sea level. If the scale of photograph for a terrain lying at an elevation of 250 m is 1: 1000. Find the focal length of the camera.
Question 6 A road section of length 2km scale 16 cm on a vertical photograph. The focal length of the camera is 320mm. If the terrain is fairly level, then the flying height will be km.
1. A camera was equipped with a 152mm (6”) focal-length lens is used to take a vertical photograph from a flying height of 2780m above mean sea level. If the terrain is flat and located at an elevation of 500m: a.) What is the scale of the photograph? b.) What would be the scale at mean sea level?
A vertical photograph is taken at an altitude of 1200 m above mean sea level of a terrain flying at an elevation of 80 m. The focal length of camera is 15 cm. The scale of the photograph will be nearly
An area of 10 km x 20 km is to be surveyed using aerial photogrammetry Average scale of photograph is 1:10,000 at ground elevation of 400 m above the datum. Focal length of camera used is 20cm and size of photographs are 23cm x 23cm. The speed of aircraft is 270 kmph. The forward lap in photographs is 70% and side lap is 30% Determine the flying height, exposure interval and number of photographs required to complete the survey.
Photogrammetry Question 3: A tower appears in two successive photographs taken at an altitude of 4000 m above the datum. The focal length of the camera is 160 mm. The parallax for the top and bottom of the pole is 72 mm and 63 mm respectively. If the height of the tower is 25 m then calculate the length of the air base(m).
A flagpole appears in two successive photographs taken at an altitude of 2,000 m above datum. The focal length of the camera is 120 mm and the Length of the air base is 200 m. The parallax for the top of the pole is 52,52 mm and for the bottom is 48,27 mm. Find the difference in elevation between the top and the bottom of the pole.
The vertical photograph was exposed with a 60 cm focal length camera at a flying height of 3,000 meters above datum. What is the photo scale at point a if the elevation of point A on the ground is 300 m above datum?
The vertical photograph was exposed with a 50 cm focal length camera at a flying height of 5,000 meters above datum. If the photo scale is 1 : 2500. What is the elevation of the point from the ground surface?
An area of 10 km x 20 km is to be surveyed using aerial photogrammetry. Average scale of photograph is 110.000 at ground elevation of 400 m above the datum. Focal length of camera used is 20 cm and size of photographs are 23 cm x 23 cm. The speed of aircraft is 270 kmph. The forward lap in photographs is 70% and side lap is 30%. Determine the flying height, exposure interval and number of photographs required to complete the survey
Compare the scales of photography for the area recorded and the strip widths given by cameras A and B at the same flying heights. Camera A Camera B Format 180 mm x 180 mm 230 mm x 230 mm Focal length 210 mm 150 mm How many photographs would be taken by the camera A in covering a strip 16 km long at a flying height of 1350 m? The longitudinal overlap is 60%.