A box of mass 10 kg sits on a frictionless table. You push down on the box at angle of 30° with a force of 50 N. 30° 10) What is the acceleration of the box? A) 2.5 m/s² B4.3 m/s² C) 7.5 m/s² D) 9.8 m/s² E) 12.5 m/s² F = 50 N Box Table

A box of mass 10 kg sits on a frictionless table. You push down on the box at angle of 30° with a force of 50 N. 30° 10) What is the acceleration of the box? A) 2.5 m/s² B4.3 m/s² C) 7.5 m/s² D) 9.8 m/s² E) 12.5 m/s² F = 50 N Box Table

Name: A box of mass 10 kg sits on a frictionless table. You push down on th
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: A box of mass 10 kg sits on a frictionless table. You push down on the box at angle of 30° with aforce of 50 N.30°10) What is the acceleration of the box?A) 2.5 m/s²B4.3 m/s²C) 7.5 m/s²D) 9.8 m/s²E) 12.5 m/s²F = 50 NBoxTable

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Introduction

Section: Chapter Questions

Problem 56AP: Assume it takes 7.00 minutes to fill a 30.0-gal gasoline tank. (a) Calculate the rate at which the...

See similar textbooks

Similar questions

Scurrilous con artists have been known to represent gold-plated tungsten ingots as pure gold and sell them to the greedy at prices much below gold value but deservedly far above the cost of tungsten. With what accuracy must you be able to measure the mass of such an ingot in and out of water to tell that it is almost pure tungsten rather than pure gold?
Physics Review A soap bubble hovers motionlessly in the air. If the soap bubbles mass, including the air inside it, is 2.00 104 kg determine the magnitude of the upward force acting on it. (See Section 4.5.)
A 62.0-kg survivor of a cruise line disaster rests atop a block of Styrofoam insulation, using it as a raft. The Styrofoam has dimensions 2.00 m 2.00 m 0.090 0 m. The bottom 0.024 m of the raft is submerged. (a) Draw a force diagram of the system consisting of the survivor and raft. (b) Write Newtons second law for the system in one dimension, using B for buoyancy, w for the weight of the survivor, and wr for the weight of the raft. (Set a = 0.) (c) Calculate the numeric value for the buoyancy, B. (Seawater has density 1 025 kg/m3.) (d) Using the value of B and the weight w of the survivor, calculate the weight w, of the Styrofoam. (e) What is the density of the Styrofoam? (f) What is the maximum buoyant, force, corresponding to the raft being submerged up to its top surface? (g) What total mass of survivors can the raft support?
Assume it takes 7.00 minutes to fill a 30.0-gal gasoline tank. (a) Calculate the rate at which the tank is filled in gallons per second. (b) Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)
Suppose you hit a steel nail with a 0.500-kg hammer, initially moving at 15.0 m/s and brought to rest in 2.80 mm. (a) What average force is exerted on the nail? (b) How much is the nail compressed if it is 2.50 mm in diameter and 6.00-cm long? (c) What pressure is created on the 1.00-mm-diameter tip of the nail?
Two identical steel balls, each of mass 67.4 g, are moving in opposite directions at 5.00 m/s. They collide head-on and bounce apart elastically. By squeezing one of the balls in a vise while precise measurements are made of the resulting amount of compression, you find that Hookes law is a good model of the balls elastic behavior. A force of 16.0 kN exerted by each jaw of the vise reduces the diameter by 0.200 mm. Model the motion of each ball, while the balls are in contact, as one-half of a cycle of simple harmonic motion. Compute the time interval for which the balls are in contact. (If yon solved Problem 57 in Chapter 7, compare your results from this problem with your results from that one.)
Assume it takes 7.00 minutes to fill a 30.0-gal gasoline tank. (a) Calculate the rate at which the tank is filled in gallons per second. (b) Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)
A ball of radius 12cm weighing 200N is connected to a vertical wall using a 35cm string. Find the tension in the string and the reaction of the wall against the ball. 20 12cm to add notes A Notes Comments 1943 30°C AQI 71 A d ENG 08-09-2021 35 ст
0-27Sm 275 mm 30° El 30° 0.5m FHE O A) d=(0.275)*sin30=0.1375 500 mm D H 0-5m 500 mm O B) d=(0.275)*cos 30=0.238 B. 300 mm u = friction coefficient on the crate surface (at A and at B) O C) d=(0.5)*cos 30=0.433 The system can hold the crate as shown in the figure. The system is in equilibrium. Ignore weight of the system. O D) d=(0.5)*sin30=0.25 the weight of the crate is 200 N. N =normal force at A O E) d=(0.3)*sin30=0.15 N, =normal force at B 8 What is the moment about C for the system of ECA? Mc = Fg *(0.5) *cos30° +Fg *(d)-N,*(0.5)-UN,*(0.3)= 0→d = ? %3D
A 1.45 m high hot water tank springs a leak half way down. What will be the speed at which the water leaves the tank? O A) 14.2 m/s O B) 10.1 m/s O C) 3.77 m/s O D) 5.33 m/s
The inside of the space shuttle is pressurized to 1.01x105 N/m2 while in deep space (outside pressure = 0). What is the outward force acting on the windshield of the craft if the windshield has a surface area of 0.5 m2? a) 5.05 x 10^5 N b) 1.01 x 10^5 N c) 2.02 x 10^5 N d) 4.04 x 10^5 N If you could draw the free-body diagram that would help me learn. Thank you,
Question 1 The average density of the sea is 1.024 x 10° kg/m³. If you are given 0.5 L of the sea water, how many grams of sea water do you have? (1.00 L = 1000 cm', and density is mass per unit volume.) a) O 512.0 g b) O 5120 g c) O5.120 x 10° g d) O 51.20 g e) O 0.5120 g Review Later