Answered: A block of density 1110.0 kg/m3 floats…

A block of density 1110.0 kg/m3 floats in an unknown fluid with three-fourths of its volume below the surface. What is the density of the fluid? kg/m3

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 39PE: If your body has a density of 995 kg/m3, what fraction of you will be submerged when floating gently...

See similar textbooks

Related questions

Q: Give the representation, equations and solution. Use elimination, comparison of su Graph using one…

A: Let the two numbers be x and y. As per the problem x+y=25 and x-y=7 We have to plot these two…

Q: Problem 2. Power A 3.00 x 102 Watts electric wheelchair and its occupant has a combined mass of 175…

Q: The linear attenuation coefficient for 2.0-MeV gamma rays in water is 4.9 m-1 and 52 m-1 in lead.…

Q: Refer to the circuit below. R1 = 10 ohms, and R2 = 20 ohms. What is the voltage across R2? Round off…

Q: You push on a rectangular door at the location of the knob (see diagram for top view). The door s…

Q: dimensional analysis to find how the speed vvv of a wave on a string of circular cross section…

A: Given the speed v of a wave on a string of circular cross section

Q: Question 1 Two of the three resistors in Figure 1.1 are unknown but equal. The total resistance…

Q: Printir The next six questions pertain to the situation described below. A circuit is constructed…

Q: Suppose that you have found a way to convert the rest energy of any type of matter directly to…

Q: Consider a bike gear such as the two shown. Let's consider a gear that has a radius of 15…

A: Given: The radius of the gear is 15 cm. The speed of the gear is 4.9 m/s constant.

Q: The acceleration of a particle at any time t ≥ 0 is given by a = 12 ti + 9sin3tj + 9cos3tkIf the…

Q: b) You pass 633 nm laser light through a narrow slit and observe the diffraction pattern on a screen…

Q: Two students, Nora and Allison, are both the same age when Allison hops aboard a flying saucer and…

A: Write the expression for the time dilation and substitute the required values to determine the age…

Q: Find the momentum A car that has a mass of 1205 kg and a velocity of 15 m/s?

Q: Determine the a.) Dot Product and b.) Cross product of the following given vectors. Given: A = 5i –…

A: Given: A=5i-2k+2jB=2i+1k+2j

Q: The figure shows wire 1 in cross section; the wire is long and straight, carries a current of 4.06…

Q: You place a crate of mass 43.2 kg on a frictionless 4.99-meter-long incline. You release the crate…

Q: An air-filled parallel-plate capacitor has plates of area 2.00 cm2 separated by 1.80 mm. The…

Q: apart (Figure 1). What is the magnitude of the magnetic field at a point midway between them if…

A: Given D=20 cm Top wire carries a current, IT=22 ABottom wire carries current, IB=13.5 A

Q: A metallic sphere (B = 27 x 106 °C) has an initial diameter of 2.250 cm at room temperature.…

A: Thermal expansion is the tendency of an matter to change its length, area, volume in response to…

Q: The resolving power of a refracting telescope increases with the diameter of the spherical objective…

A: The resolving power of a refracting telescope increases with the diameter of the spherical objective…

Q: A crate of mass 20.9 kg rests on a level surface, with a coefficient of kinetic friction 0.225. You…

A: Given: The mass of the crate is 20.9 kg. The applied force is 244 N. The coefficient of the kinetic…

Q: Four children stand at edge of a circular horizontal platform that is free to rotate about a…

Q: A parallel plate capacitor is fully charged at a potent ial V. A dielectric with constant = 4 is…

Q: As a beam of star light passes by the Sun, the Sun: Group of answer choices a)acts like a lens and…

A: When a beam of star light passes by a sun ,then it is bent due to gravity of Sun .

Q: Sarah live alone in the 3rd floor of a 5 story townhouse where each story is 4.11 meters high. She…

A: Potential energy = mgh

Q: Calculate the induced emf if the overall change of magnetic flux in a coil with 17 turns is 4.5 x…

A: When the magnetic flux changes with time, then it causes to induce an emf in a loop. Given(s):…

Q: A straight conductor carrying a current i = 9.8 A splits into identical semicircular arcs as shown…

Q: A person carries a plank of wood 2.00 m long with one hand pushing it down at one end with a force…

Q: A 1.00-mm-radius, cylindrical copper wire carries a current of 8.00 A. If each copper atom in the…

Q: What is wrong with this refrigerator whose diagram is shown below?

Q: In the figure, point P2 is at perpendicular distance R = 25.8 cm from one end of straight wire of…

Q: Calculate the current through each resistor in the figure if each resistance R=1.38 kn and V= 12.0 V…

Q: system is released from rest, a) What is the constant acceleration of the system? b) What is the…

Q: I. DATA SHEET COMPLETION: Complete the following tables. Show your complete solution for each item.…

Q: An Unidentified flying object (UFO) is travelling across our atmosphere with a speed of 0.75c. The…

Q: Choose the graph that represents the current and voltage phasors at t 15ms.

Q: Determine the distance between the electron and proton in an atom if the potential energy ?U of the…

A: Q. Given that Potential energy of electron and proton is U = 16 eV

Q: Point charges of 1 nC and −2 nC are located at (0, 0, 0) and (1, 1, 1), respectively, in free space.…

Q: 5. With a wheel and axle, a force of 80 N applied to the rim of the new wheel can lift a load of 640…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Our electric consumption is measured using kilowatt hour, kW-h. On average, a simple Filipino…

A: Here we have to answer what is measured by kW.h unit.

Q: If the beam attached to a hinge is 4 meters long and weighs 600 Newtons, and the sign weighs 400…

Q: A group of students conducted an experiment to determine the density of an unknown liquid. In the…

A: Given data as per question density of wood = 1.5g/cm3 area = 6.25cm2

Q: A wire 1.97 m long carries a current of 14.5 A and makes an angle of 31.2° with a uniform magnetic…

Q: escribe your approach to calculation of the gravitational field strength on a planet with a given…

Q: One long wire lies along an x axis and carries a current of 48 A in the positive x direction. A…

A: Given For wire 1Current, I1=48 A Wire 2 is perpendicular to the xy plane, passes through the point…

Q: Two vehicles collide in a head on collision. The 1990 kg car is moving eastward traveling at 26…

Q: 1. What is the rate of heat production of a device with a resistance of 0.20 2 as a 10-A current…

A: (1) the rate of heat produce dH/dt = 20joule/sec (2) the rate of heat produce dH/dt= 1690joule/sec…

Q: A parallel plate capacitor has a potential difference between it's plates of 1.2 V and a plate…

Q: high energy electron enters earth’s atmosphere from space and comes straight down toward a spot on…

A: Earth magnetic field lines are perpendicular at equator so when electron comes towards the equator…

Question

A block of density 1110.0 kg/m3 floats in an unknown fluid with three-fourths of its volume below the surface. What is the density of the fluid?
kg/m3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A table-tennis ball has a diameter of 3.80 cm and average density of 0.084 0 g/cm3. What force is required to hold it completely submerged under water?
Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
Water is moving at a velocity of 2.00 m/s through a hose with an internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
(a) What is the density of a woman who floats in freshwater with 4.00% of her volume above the surface? This could be measured by placing her in a tank with marks on the side to measure how much water she displaces when floating and when held under water (briefly). (b) What percent of her volume is above the surface when she floats in seawater?
Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
. A juniper-wood plank measuring 0.25 ft by 1 ft by 16 ft is totally submerged in water, (a) What is its weight? (b) What is the buoyant force acting on it? (c) What is the size and the direction of the net force on it?
If your body has a density of 995 kg/m3, what fraction of you will be submerged when floating gently in: (a) Freshwater? (b) Salt water, which has a density of 1027 kg/m3?
(a) What is the fluid speed in a fire hose with a 9.00-cm diameter carrying 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?
A hollow copper (Cu = 8.92 103 kg/m3) spherical shell of mass m = 0.950 kg floats on water with its entire volume below the surface. a. What is the radius of the sphere? b. What is the thickness of the shell wall?
An incompressible, nonviscous fluid is initially at rest in the vertical portion of the pipe shown in Figure P15.61a, where L = 2.00 m. When the valve is opened, the fluid flows into the horizontal section of the pipe. What is the fluids speed when all the fluid is in the horizontal section as shown in Figure P15.61b? Assume the cross-sectional area of the entire pipe is constant. Figure P15.61
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid with 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube is used with a radius 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half the length, and the pressure difference is increased by a factor of 1.50.
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?