In a steam turbine steam at 20 bar, 360°C is expanded to 0.08 bar. It then enters a condenser, where it is condensed to saturated liquid water. The pump feeds back the water into the boiler. Assume ideal processes, find per kg of steam the net work and cycle efficiency.

In a steam turbine steam at 20 bar, 360°C is expanded to 0.08 bar. It then enters a condenser, where it is condensed to saturated liquid water. The pump feeds back the water into the boiler. Assume ideal processes, find per kg of steam the net work and cycle efficiency.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The higher temperature of a refrigerating system operating at a Reverse Carnot Cycle is 240 °F and…

A: Higher temperature in the cycle, TH=240oF=388.706 KLower temperature in the cycle, TL=266.483…

Q: A diesel engine has a compression ratio of 20:2 with an inlet of 90 kPa, 170C, state 1, with volume…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 2250…

A: Given data Cycle with two reheat operationsTurbine inlet condition - 2250 psia and 1060°F1st…

Q: The Figure shows a steam engine based on insulsted turbine. The boiler has a volume 100 liters and…

Q: In a steam turbine steam at 2 MPa, 360°C is expanded to 8 kPa. It then enters a condenser, where it…

A: From the steam table at 2 MPa pressure and 360°C temperature in superheated region h3 = Enthalpy at…

Q: A smaller power plant produces 25 kg/s steam at 3 MPa, 600°C in the boiler. It cools the condenser…

A: Draw a temperature-entropy diagram i.e. T-s diagram for the problem. Here, points 1, 2, 3, 4, 5,…

Q: H.W A smaller power plant produces steam at 3 MPa, 600 C, in the boiler. It keeps the condenser at…

Q: In a 14 TR ammonia refrigeration plant, the condensing temperature is 250C and evaporating…

A: TH=25°CTL=-10 °CSub-cooled by 5 °CTH'=20°Cx1=.97Assume vapor leaving the compressor is saturated…

Q: What is the pump work in kJ/kg?

A: To find pump work in kJ/kg

Q: Steam is delivered by a steam generating unit at 1100 psia and 900 °F. After expansion in the…

A: Steam power plant works on Rankine cycle. The steam power plant has four main components: (i)…

Q: Airborne heat used to heat a home refrigerant circulating in the cycle of the pump-134a 600 kPa…

A: Given data: Heat from outside air is used to heat a home. For the heat pump, refrigerant R-134 a is…

Q: |A Refrigerator system operates on the reversed Carnot cycle. Given higher temperature is 60°C,…

Q: A Carnot Refrigerator cycle absorbs heat at 270K and rejects it at 300K. Find the following: 1.Find…

A: Refrigerator is a device which maintains a body temperature lower than the normal temperature or…

Q: As shown in the figure, the stable operating air conditioner While the environment is 32oC, it keeps…

A: Given: The environment temperature, To = 32oC The temperature inside the indoor, Ti = 21oC The rate…

Q: A carnot heat pump is operating to keep a room at 20C. The unit is taking in air from a -30C…

Q: In a Steam Power Plant steam enters the turbine at 6 bar and 400 C and is expanded isentropic ally…

A: Answer: (a) Condition of steam : Mixture of saturated water and saturated vapor with dryness…

Q: In the open-circuit steam plant, boiler feed water at atmospheric pressure 1 bar and 35oC is pumped…

Q: Problem 3. A vapor power plant produces 25 kg/s steam at 6 MPa, 500°C, in the boiler. It cools the…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: The given schematic diagram of the thermodynamic cycle represents a simple Rankine cycle with…

Q: 2. Steam at 4 Mpa and 400°C is received by a regenerative cycle. Before condensation at 0.005 Mpa,…

A: The T-s diagram of the system is

Q: 3. A smaller power plant produces 25 kg/s steam at 3 MPa, 6000 C in the boi cools the condenser with…

A: “Since you have posted multiple questions, we will solve the first question for you. To get the…

Q: A Carnot heat engine is designed to produce 70 hp at 3000 RPM. If the energy source is at 1500°F and…

A: Given: Source temperature , T1= 1500 °F Sink temperature , T2 = 90 °F Output power = 70 hp The…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 2250…

Q: A smaller power plant produces 25 kg/s steam at 3 MPa, 600 C in the boiler. It cools the condenser…

A: Given: T2 = 600oC P2 =3000 kpa mass flow rate; m =25kg/s use the mollier chart, at point 2,…

Q: 2). A steam power plant uses steam at boiler pressure of 150 bar and temperature of 550°C with…

A: Given data A steam power plant undergoes reheat rankine cycle. The boiler pressure = 150 bar The…

Q: Derive an expression for the optimum pressure, ratio of simple gas turbine plant and also find…

A: Here the assumption taken for the Derivation for the optimum pressure ration and maximum work…

Q: Steam is delivered into an engine at 5.4 Mpa and 600°C. Before condensation at 31°C, steam is…

Q: Two-stage compressor that has an intercooler (intercooler) takes in air at 300 K, 100 kPa, and…

A: Given data as per question Pressure at point 1=100 kpaPressure at point 2 =2.2MpaTemperature at…

Q: a boiler is producing steam at pressure of 15 bar and quality as 0.98 dry. If the water supplied…

A: Given data:

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 2250…

A: Given dataCycle with two reheat operationsTurbine inlet conditions = 2250 psia and 1060°F1st…

Q: A steam power plant works between 40 bar and 0.05 bar. If the steam supplied is dry saturated and…

A: Saturation Pressure: The pressure exerted by the vapour on the liquid when both liquid and vapour…

Q: 4. A Diesel engine, which uses air, has an inlet at state #1 of 100 kPa, 300 K and a compression…

Q: A steam power plant uses steam at boiler pressure of 150 bar and temperature of 550°C with reheat…

Q: A 10,000-kW turbogenerator operating at rated capacity receives 52,000 kg/h of steam at 2.90 MPa and…

Q: 3. A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and 37.50308414 atm…

Q: A Carnot Refrigerator cycle absorbs heat at 270K and rejects it at 300K. Find the coefficient of…

A: Refrigerator is a device which maintains a body temperature lower than the normal temperature or…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 90 bar…

Q: a) Find the amount of heat (kJ / kg) entering the cycle. b) Find the thermal efficiency of the…

Q: A Carnot cycle has an initial temperature sink of 1000F and cycle efficiency of 70%. Find the…

A: Given Data : Carnot cycle Sink temperature Ts=10000F Cycle efficiency…

Q: A diesel power plant uses fuel that has a density of 892.74 kg/m3 at 15.66oC. Find the heating…

A: Given Data: The density of fuel, ρ=892.74 kg/m3

Q: Provide given and step by step manual solution for below problem. The efficiency of Carnot cycle…

Q: A diesel engine has a compression ratio of 20:2 with an inlet of 90 kPa, 170C, state 1, with volume…

Q: The cycle comes with a net power cycle of 25.40 kW. The heat that goes out is 42.30 kW. Find the…

A: Given:Wnet=25.40 KWQo=42.30 KW

Q: turbine. It expands to 40 r and 280 °C. It is then reheated to 490 °C and expands to 8 bar and 270…

A: As Given Data:- P1 = 250 bar , P2 = 40 bar and P3 = 8bar T1 = 500°C, T2 = 280°C, T3=270°C

Q: , find the refrigerant effect of the ideal vapour

A: Given data; An ideal vapor compression cycle operates between the temperatures limits, T1=-200C…

Q: A steam power plant has a steam generator exit at 4 MPa, 600 ℃ and a condenser exit temperature of…

A: Given data: Exit state for steam generator or turbine inlet state P1 = 4MPa , T1 = 600°C…

Q: A Refrigerator system operates on the reversed Carnot cycle. Given higher temperature is 60°C, lower…

A: Given Data Th=60°C=333 K TL= 10°C =283 K QL= 15 TR

Q: H.W 2 A smaller power plant produces steam at 3 MPa, 600 C, in the boiler. It keeps the condenser at…

Question

In a steam turbine steam at 20 bar, 360°C is
expanded to 0.08 bar. It then enters a condenser,
where it is condensed to saturated liquid water.
The pump feeds back the water into the boiler.
Assume ideal processes, find per kg of steam the
net work and cycle efficiency.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the open-circuit steam plant, boiler feed water at atmospheric pressure 1 bar and 35oC is pumped into an oil-fired boiler which produces dry-saturated steam at 10 bar. This steam enters a steam turbine and is expanded isentropic ally to atmospheric pressure and freely discharged into the atmosphere. Find The thermal efficiency of the plant. The work ratio The specific steam consumption
3.) A 7.162M British Thermal Unit per hour is required for a gas turbine power plant in Batangas wherein hot air enters at the compressor section at 3.4 psig, 300K. Considering a pressure ratio of 9 and the turbine area receives the hot gases at 1742 deg F, find the required air flow in lb/min.
A geothermal power plant has the thermal energy at well head of 1,289 KJ, mass of the liquid of 82 kg, and specific enthalpy at final stage of 4.12 KJ/KG, what is the value of work at the heat utilization system of the plant?
Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the firstturbine until it is just dry saturated, then it is re-heated to 400 °C and expanded through the second-stage turbine. The condenser pressure is 0.04 bar. what is the temperature in degrees celcius at state 4? find the thermal efficiency of the system in percentage to 2.d.p?
A refrigeration system has a heat rejected of 430 kw.If COP is 7,find the mass chilled water in the evaporator for a temperature decrease of 16°℃.
1. A sample of gas A evaporates over water in a closed system. What is the pressure of gas A In kg/cm2 if the total pressure is 780 torr and water vapor pressure is 1 atm?
The turbine section in a jet engine receives gas (assume air) at 1200 K, 800 kPa with an ambient atmosphere at 80 kPa. The turbine is followed by a nozzle open to the atmosphere and all the turbine work drives a compressor receiving air at 85 kPa, 270 K with the same flow rate. Find the turbine exit pressure P₂ so the nozzle has an exit velocity of 800 m/s.
A diesel power plant uses fuel that has a density of 892.74 kg/m3 at 15.66oC. Find the heating value.
2.A steam throttling valve with inlet conditions of 2MPA and 400C is connected to the inlet of the turbine. The turbine has 200kW power output and heat abstracted of 100kW. If the mass flow rate is 1kg/s and the exit temperature of steam is 300C, find the exit turbine pressure.
A 7.162M British Thermal Unit per hour is required for a gas turbine power plant in Palawan wherein hot air enters at the compressor section at 3.4 psig, 300K. Considering a pressure ratio of 9 and the turbine area receives the hot gases at 1742 deg F, find the required air flow in lb/min.
A steam power plant has a steam generator exit at 4 MPa, 600 ℃ and a condenser exit temperature of 45 ℃. Assume all components are ideal and find the cycle efficiency and the specific work and heat transfer in the components, (wt, wc, qh, ql, ηth=?).
An Otto cycle has a heat rejected of 300 kJ and work of 700 kJ. Find the cycle efficiency.