a) A sinewave is having a frequency of 50 Hz and instantaneous voltage of 200 Volts at 1.2 milliseconds. Find:i) The maximum value of sinusoidal voltage waveform ?ii) The value of voltage at 1.8 milli seconds.b) An alternating voltage is given by v=100 sin(140 Ttt +0.25) volts. Find:(i) Peak to Peak Value of voltage ((ii) Average Value of voltage(iii) Phase angle in degrees with respect to 100sin(140Ttt).(iv) The instantaneous value of voltage when t=0 (*(v) Draw the sine wave of 100sin(140 Ttt). (*

In the question Following data is given f=50HzV=200 volts at t=1.2 msec a. i) According to this…

a) A sinewave is having a frequency of 50 Hz and instantaneous voltage of 200 Volts at 1.2 milli seconds. Find: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 1.8 milli seconds.

a) A sinewave is having a frequency of 50 Hz and instantaneous voltage of 200 Volts at 1.2 milli seconds. Find: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 1.8 milli seconds.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Armature reaction in an alternator affects generated voltage/phase Select one: O True O False

A: In this question we will write effect of armature reaction in an alternator....

Q: Q: For the sweep generator shown, if the transistor is triggered every 5msec. by the impulses shown.…

A: Solution- The transistor conducts in every 5msec.When the input is low, the current on the capacitor…

Q: Discuss about the performance characteristics of wind turbine

A: Introduction - Wind turbines use aerodynamic force by the propeller blades to convert wind energy…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.2 milli…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 100 Volts at 1.3 milli…

Q: Explain with neat sketch the operation of regulated DC power supply.

A: A fluctuating DC voltage supply may result in an unsuitable operation of electronic devices and…

Q: An alternator has 6 poles and runs at 1,000 rpm (a) what is its generated frequency? (b) What must…

A: (a) The speed of the alternator is given by the expression as shown below: Ns=120fP Plugging the…

Q: O What is the difference between AC and DC coupling?

A: Coupling is the process where we are giving the supply to the any electric circuit may be amplifier…

Q: . What are the various losses in an induction motor? On what factors do they depend

A: The fallowing are the various losses that occur in an induction motor:

Q: Derive expression for the output rms voltage for single phase ac voltage controller with resistive…

A: Types of converters AC to DC converter DC to DC converters DC to AC converters AC to Ac…

Q: How many poles are required on an alternator which runs at 300 rpm to develop

Q: For a system if the value of peak overshoot is 22 %, then the value of damping ratio Oi is

A: Peak over shoot pos = 22% = 0.22 Damping ratio Zeta

Q: Explain what is a stiff supply system ? What is its importance in harmonic environment? ARC

A: To explain the stiff supply system

Q: List three applications of electrical transformers.

A: Brief description : Transformers works based on the principle called electromagnetic induction and…

Q: An alternator has 8 poles. (a) At what speed must the machine be driven to develop 75 cycles? 40…

Q: Derive net RMS EMF induced in the stator winding, when there is an influence of 1st, 2nd harmonics.

A: EMF induced due to first harmonics is = RMS value is =

Q: Q3:B: Name general types of DC generators and make a sketch of their connections

Q: Given field excitation at 10A in an alternator that exerts current of 150A (short circuit) and a…

A: The solution is given below

Q: A three-phase motor supplied from a three-phase source is used to drive a pump. The rotor speed is…

A: Given a three phase motor supplied from three phase source is used to drive a pump. When the pump is…

Q: The AC Voltage controller shown below is used for heating a resistive load of 5 Ω and the input…

A: Given,Vs=120 Vf=60 Hzn=125 cyclesm=75 cyclesR=5ΩVm=2×120=169.70…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.3 milli…

A: The solution to both the parts is attached below.

Q: How to measure high alternating currents and high alternating voltages during the transmission and…

A: The device that is used to measure the high alternating current is known as the current transformer.…

Q: 1. Compare the reaction of Dc motor and dc generator. Also explain rule by which DC generator/motor…

A: The effect of the armature flux on the main field flux is known as armature reaction. It causes very…

Q: An 8-pole alternator runs at 750 rpm. and supplies power to a 6-pole induction motor which has at…

Q: 5. The single phase full wave AC voltage controller operates on a single phase supply voltage of…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: __ is used to convert AC to unidirectional current in DC machine.(estimated time 1 minute) a.…

A: A commutator in a DC Machine has substitute groups of Copper and mica. Presently when the armature…

Q: A DC machine running at 750 rpm has an induced emf of 200 V. Calculate (1) the speed at which the…

A: Given:

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 150 Volts at 1.2 milli…

Q: An alternator has a poles a) At what speed must the machine be driven to develop 60 cycles?…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 100 Volts at 1.3 milli…

A: From the the sinusoid expression....

Q: A bipolar AC generator is running at 3,600 RPM . What will be the frequency of the voltage wave…

A: solve prob..

Q: Suppose we have an ac current flowing through a coil wound on an iron core. Name two mechanisms by…

A: The two mechanisms in which energy is converted to heat in the core material are: 1) Core loss or…

Q: An audio power amplifier delivers an 80-volt peak 35 Hz sine to a subwoofer. If the subwoofer…

A: Given data, Peak voltage Vp=80 V Frequency f = 30 Hz Impedance Z=4∠-300

Q: Draw and explain a typical power curve for a wind turbine and write the definition of the four…

Q: A three-phase motor supplied from a three-phase source is used to drive a pump. The rotor speed is…

Q: Introduction and explanation about alternator regulation

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 100 Volts at 1.4 milli…

A: Given: A sine wave whose frequency 100Hz and its instantaneous value is 100V at t=1.4msec. According…

Q: the single-phase ac voltage controller has a 240 V rms 50 Hz source. The load resistance is 20002…

Q: A 3-phase, 60 Hz, Y-connected, AC generator has a stator with 60 slots, each slot contains 12…

A: Principle of Machine: In any electrical machine either it's a DC machine or AC machine, the EMF in…

Q: 2. Suppose 2000 turns of copper wire are wrapped around one portion of an iron hoop, and 3000 turns…

Q: Name the component operating with ac power which best compares to the buck chopper.

A: A buck chopper is dc to dc converter which works as steps up and steps down voltage and current…

Q: A 6-pole alternator running at 1000 rpm, supplies an 8 pole induction motors. Find the actual speed…

Q: The field windings of a series motor have a resistance of 120 ohms at 15 o C. After running for two…

A: In this question we need to find a temperature rise of a field winding of series Motor. The given…

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 150 Volts at 1.5 milli…

A: The solution is attached below for the given problems

Q: 13.a. Eddy-current loss in the stator core can be reduced by using A. alloys with low resistivity.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

a) A sinewave is having a frequency of 50 Hz and instantaneous voltage of 200 Volts at 1.2 milli
seconds. Find:
i) The maximum value of sinusoidal voltage waveform ?
ii) The value of voltage at 1.8 milli seconds.
b) An alternating voltage is given by v=100 sin(140 Ttt +0.25) volts. Find:
(i) Peak to Peak Value of voltage (
(ii) Average Value of voltage
(iii) Phase angle in degrees with respect to 100sin(140Ttt).
(iv) The instantaneous value of voltage when t=0 (*
(v) Draw the sine wave of 100sin(140 Ttt). (*

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. A sinusoidal waveform is displayed on a c.r.o. screen. The peak-to-peak distance is 5 cm and the distance between cycles is 4 cm. The 'time'switch is on 100 µs/cm and the 'volts/cm' switch is on 10 V/cm. Determine (i) angular frequency (ii) peak (iii) rms value of voltages (iv)Time period and (v) form factor.
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?
Listen Regarding a Sine wave of an A.C. voltage (pictured below for reference), changing the Volts per division setting results in which of the following? O a) Changes the actual frequency of the waveform. O b) Changes the actual period of the waveform. O c) Changes the actual voltage level of the waveform. O d) Has no effect on the actual voltage level, period or frequency of the waveform.
3. For the sinusoidal waveform shown in Figure, determine (a) Time period, (b) its frequency, (c) peak- to-peak voltage, (d) average voltage and (e) r.m.s. voltage. 2!05 02 Sms 100 us 50 ma 500 ms
Draw a sinusoidal voltage waveform with peak value of 200 volts and has an instantaneous value of 100 volts at t increasing positively at t frequency and period of the said waveform. 1 milliseconds. The wave is O with a magnitude of 0 volt. Calculate also the
The effective voltage of alternating current is __________ times its highest or peak voltage. Select one: A. .9 B. .707 C. 100% D. E=IXR
Courses / EEPW2113U / Moving Forward a) A sinewave is having a frequency of 100 Hz and instantaneous value of 200 Volts at 1.1 milli seconds. Find ) The maximum value of sinusoidal voltage waveform and i) The value of voltage at 1.9 milli seconds. (i) Maximum value = (ii) Value of voltage at 1.9 ms = The r.m.s. value of a sine wave is 276 A. Its peak value(Vp} is a. 552.00 EN
9:01I EV Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms Sketch the Square waveform. [1]
3-9 An rms ac voltmeter and a peak-to-peak-reading ac voltmeter are to be used to determine whether three ac signals are sinusoidal. Deter. mine whether the signals are sinusoidal if the following readings are obtained First signal Second signal Third signal peak-to-peak reading = 35.26 V rms reading. - 12.00 V peak-to-peak reading - 11.31 V rms reading = 4.00 V peak-to-peak reading = 25.00 V rms reading -8.83 V
The ripple factor for pure dc is Answer:
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
Explain in detail about current harmonics.