A 6.9 cm diameter horizontal pipe gradually narrows to 5.0 cm. When water flows through this pipe at a certain rate, the gauge pressure in these two sections is 35.0 kPa and 20.0 kPa, respectively. Part A What is the volume rate of flow? Express your answer to two significant figures and include the appropriate units. HA ? Av = Value Units

A 6.9 cm diameter horizontal pipe gradually narrows to 5.0 cm. When water flows through this pipe at a certain rate, the gauge pressure in these two sections is 35.0 kPa and 20.0 kPa, respectively. Part A What is the volume rate of flow? Express your answer to two significant figures and include the appropriate units. HA ? Av = Value Units

Name: A 6.9 cm diameter horizontal pipe graduallynarrows to 5.0 cm. When wa
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: A 6.9 cm diameter horizontal pipe graduallynarrows to 5.0 cm. When water flows through thispipe at a certain rate, the gauge pressure in thesetwo sections is 35.0 kPa and 20.0 kParespectively.Part AWhat is the volume rate of flow?Express your answer

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 79P: What is the fluid speed a hose a 9.00-cm diameter 80.0 L of water per second? (b) What is the flow...

See similar textbooks

Similar questions

A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
What is the fluid speed a hose a 9.00-cm diameter 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?
(a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one in figure 14.32(b), is given by v=( 2gh)1/h , where h is be height of be manometer fluid, p' is the density of the manometer fluid, p is the density of the moving fluid, and g is be acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in text) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
A glucose solution being administered with an IV has a flow rate of 4.00 cm3/min. What will the new flow rate be if the glucose is replaced by whole blood having the same density but a viscosity 2.50 times that of glucose? All other factors remain constant.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
How would you determine the density of an irregularly shaped rock?
What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the iceberg is 917 kg/m3.
Verigy that the SI of hpg is N/m2.
A teenager is stealing gasoline from his father's car with a siphon with diameter of 12 mm. The heights in the figure are: z1 = 970 mm and z2 = 181 mm. Calculate the volumetric flow rate out of the tank. Round off the answer to two decimal digits in l/s, but enter your answer without the unit. Z₁ Answer: 22
Given: Pi constant to be used: 3.14159Capillary tube: radius = 0.02 cm; length = 9 cm; pressure = 0.7 mmHgLiquid sample: density = 4 ml; time of flow = 4.5 seconds 1. What is the pressure in MKS unit? Your answer here will be used for the next item(s). 2. What is the pressure in CGS unit? Your answer here will be used for the next item(s). 3. What is the viscosity of the liquid? Your answer here will be used for the next item(s). 4. If the weight was given as 8.5 grams, what will be the density of the liquid? Your answer here will be used for the next item(s). 5. What is the kinematic viscosity of the liquid? 6. What is the fluidity of the liquid?
Question: Where did you get the 13,885.33 tonnes? Please provide explanations and can you illustrate the problem? Problem: A ship arrives at the mouth of a river in water of density 1016 kg per cu. m with a freeboard of ‘S’ m. She then discharges 150 tonnes of cargo, and proceeds up river to a second port, consuming 14 tonnes of bunkers. When she arrives at the second port the freeboard is again ‘S’ m, the density of the water being 1004 kg per cu. m. Find the ship’s displacement on arrival at the second port. Thank you so much. I am having a hard time to understand it an illustration and detailed explanation will be very helpful. Thank you.
Problem 2: The hydrometer shown in Figure below is a device for measuring the specific gravity of liquids. The bulb contains lead shot, and the specific gravity can be read directly from the liquid level on the stem after the hydrometer has been calibrated. The volume of the bulb is 20 mL, the stem is 15 cm long and has a diameter of 5.00 mm, and the mass of the glass is 6.0 g. (a) What mass of lead shot must be added so that the lowest specific gravity of liquid that can be measured is 0.9? (b) What is the maximum specific gravity of liquid that can be measured?