Answered: A 480 V, 60 Hz, three-phase source is…

A 480 V, 60 Hz, three-phase source is connected to a delta-connected load, in which each element has an impedance of 9+j3 (ohms). Determine the magnitude of the line current, in A.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Great algebraic explanation, what would the conclusion be?

A: The solution is provided in the following section.

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: 28. Find the magnitude of a curl of the vector at point (1,1, −0.2); F = 30 ax + 2xy ay + 5xz² a₂ a.…

A: 28. Find the magnitude of curl of the vector at point (1,1,-0.2) ; F=30 ax+2xy ay+5xz2 az Options…

Q: Q3) Find which of following systems are Memory and Memoryless systems? Answer Two only a) y(t) = 3x…

Q: (6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 4Ω ΤΩ 34 16Ω Figure 6 Μ 5Ω 12 V 10 Ω

Q: Question 32 Consider the following statements: In a series RLC resonant bandwidth is Inversely…

A: In this question. We will write relation between bandwidth and quality factor...

Q: Vin For the circuit shown, assume that Vo = 3V and that the transistor is described as follows:…

Q: Q.3) The input voltage to a Full-wave rectifier employing a center - tapped step-down transformer…

A: Rectifier is a circuit which converts AC into pulsating DC. Full wave rectifier has two output…

Q: For the following circuit, number of nodes is R₂=402 www E₂=6V R3=30 ww R₁ = 102 E₁=2V R₁ = 20 E3 =…

A: In this question, We need to choose the correct options What is number of nodes is?

Q: 23. If the impedance of the circuit is 50ohm and the resistance is 8ohm. Find the power factor A.…

A: 24. Given: Impdedance,Z=50ΩResistance,R=8Ω

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

Q: The supply frequency is 50 Hz. What will be the rotor voltage frequency if the motor speed is equal…

Q: A FET has lpss=4lp and gmo = 10mS then gm express answer in mS

A: FET: It is a semiconductor transistor known as field effect transistor. It works due to single…

Q: 43. Poisson's equation is equals to: a. V.VV = Pv b. V.VV=_Pv C. V.VV = 0 d. V.VV=- £ Pu 44. Which…

A: Q.43) ans:(b) Poisson's Equation states that the Laplacian of the electric potential is equal to…

Q: A- Assume you have a Frequency Modulator where its instantaneous frequency varies with the message…

Q: Q4: Answer the following, choose A or B A. For the following circuit, Determine the value of the…

Q: Calculate the bit-force generated by a 440 V DC electric motor. The armature has a resistance of…

A: Given data : Supply voltage Vdc=440V Armature resistance Ra=0.25Ω Speed of motor N=750rpm Motor…

Q: inductance. Determine its impedance considering the circuit is at resonance condition.

A: At a particular frequency value the inductive reactance and capacitive reactance of the circuit…

Q: What are the characteristics of an ideal operational amplifier?

Q: For the following circuit, number of nodes is R₂=402 www E₂=6V R₂=30 W R₁=102 E₁ = 2 V R₁ = 20 E3= 1…

Q: Q6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 4Ω ΤΩ 34 ΑΜ 16 Ω ΤΩ 12 V ΤΟ Ω

A: We need to find out output voltage for given circuit

Q: B) State the junction bias conditions for a bipolar junction transistor operating as an amplifier.…

A: The BJT can be used in three different types of configuration which are listed below :…

Q: 1. Find the value of "R" that makes the circuit in resonance. 2. Determine the total current at…

Q: Determine the value of the current (I) and the drop voltage across the resistance (V1) Rs www 1502…

Q: A- Assume you have a Frequency Modulator where its instantaneous frequency varies with the message…

Q: 3 A Certain JFLT VGS (off) = -8 V and IDSS =10mA when VGS =0, what . is ID for Yos above ¥? YD=15V…

A: The drain current in the JFET is given by the expression as shown below: ID=IDSS1-VGSVP Plugging…

Q: Please solve asap my deadline is very close

Q: The magnetizing equivalent circuit of transformer can be found by open circuit test O True O False

A: Open circuit test is conducted in the presence of rated flux in the transformer core. In order to…

Q: Provide the zero and pole, that is available for the circuit. Calculate the frequency fo

A: The given circuit can be drawn as shown below, Vin=VPsin2πft,⇒Vin=2sin2000πt.

Q: The synchronous generator will have voltage and frequency depend on O Field current and speed. O…

A: In this question we will write about synchronous generator frequency and voltage...

Q: calculate (vo,VS) R12 Ma Rs VS. A lkn 10uF Yo=& Figure (3) B-160 -Vcc=20V Rc=4kQ H Vout 1uF Rl >2kQ

Q: For the system in Fig. 14.87, find the sinusoidal expression for the unknown voltage v if ein 60…

A: In the given questions, we need to calculate voltage Va. Va can be calculate by converting the…

Q: 11- What is the current through the motor winding of Fig. 12-54 when the gate voltage is low? When…

A: Given: Consider the following circuit: To find: 11- What is the current through the motor winding…

Q: A load of 10 MW operating at a power factor of 0.5 lagging is connected to a 400 V, 60 Hz source.…

A: given: P=10MWCosϕ=0.5V=400V where, P is Power V is voltage Cosϕ is Power Factor.

Q: Example 3.8: ELECTRICA Consider the circuit in Fig. 16.12(a). Find the value of the voltage across…

A: given here a transient analysis circuit and asked to find the voltage across the capacitor.

Q: Q3) Given the circuit in Fig. 3. calculate the current i, through t, using mesh analysis 3A fis 6 A…

A: Note: Since the voltage across the current sources are unknown, hence mesh analysis is not…

Q: A single phase half-bridge voltage source inverter (VSI) has a resistive load of 2.4Ω and input dc…

A: Single phase half bridge is a voltage source inverter. The input power of the inverter is a DC…

Q: 4. A disturbance is a desired input signal that affects the system output signal. 5. An advantage of…

A: We need to tell about whether the given statement are true or false

Q: Problem 1: A lossless transmission line has characteristic impedance Z. 50 2 and its input impedance…

A: Given Few parameters of a lossless transmission line.we need to determine the load impedance…

Q: 25. A parallel plate capacitor has 19 interleaved plates each 75 mm by 75 mm separated by mica…

A: For the given number of interleaved plates we need to calculate capacitance of the capacitor.

Q: B-For the lossless transmission lines circuit shown below, design the value of Rx for proper series…

A: Given data, Impedance Z0=100ohm

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A: In this question we need to find a efficiency of the given transformer

Q: a. True. b, False. 5. Thevenin's theorem provides a method of reducing a more complex circuit to a…

A: There are number of theorems that are use to reduce complexity of network, namely, Superposition…

Q: Vin For the circuit shown, assume that Vo = 3V and that the transistor is described as follows: Kn =…

A: For the above given question we need to perform AC and DC analysis of the given amplifier.

Q: Sketch the polar plot for the system. having 10. G(s) H(s) = 2 (5+2) (5+4)

Q: Determine the Fourier transform for the signal x(t) given in Figure Q1(a). An arbitrary system has…

Q: Q5) (A) If the length of the transmission line is one-quarter wavelength (1=2/4). Derive an…

A: Given We need to derive input impedance of quarter wavelength transmission line. Please find the…

Q: . Biot-Savart law in magnetic field is analogous to which law in electric field? a. Gauss's Law b.…

A: Biot-severt law is an equation that gives the magnetic field produced due to a current carrying…

Q: Consider a CT-LTI system described by the differential equation d'y(t)_d²y(t)_5dy(t) _2 +6y(t) =…

Q: 5. Find Vo for the circuit given below. 10K w 9 V 20K 10 V 30K 12 V 40K 100K 9+Vcc 8-Voc 6V 20K Ans…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

A 480 V, 60 Hz, three-phase source is connected to a delta-connected load, in which
each element has an impedance of 9+j32 (ohms). Determine the magnitude of the
line current, in A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
Three Impedances each of (8 - j24)2 are connected in mesh across a three-phase 420V ac supply. Determine the phase current, line current, active power, reactive power drawn from supply. Also draw the Phasor diagram for the mesh connection and marks the Line current ,phase current line voltage and phase angle between phase current and pahse voltage. phase current (Ip) Line current real power reactive power
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
Need asap pls help. Solve for the voltages across and currents through each component. Show the complete solution and explain. The total power should be zero..
Which cannot be said since Z is an inductive load in the circuit given below? A) load voltage period is 0.02sec. B) Load voltage peak value is 311V. C) Load voltage frequency is 50Hz D) Load voltage average value is 220V.
A voltage and current applied to a single phase load is v= 26 cos (300t+35) and i= 19 cos (250t- 20). Find the single and three phase active and reactive power of the circuit if the voltage and current are in sine waveform
Three identical impedances are connected in star across a 440 V, 3 phase, 50 Hz supply. The line current is 40 A and the pf is 0.8 leading. Find the value of resistance and capacitance in each phase.
find total equivalent resistance and reactance and total impedance transferred in primary side.
Consider a 10 kVA, 200/400 V, 50 HZ: single-phase tranformer has the folloving test results:0.C. test: 200 V, 0.6A, 63 W (L.V.side)S.C. test : 20 V, 25A, 85 W (H.V. side)Deternine:i- The eficiengy at 75 % offiull-load at 0.9 leading power factor.ii -The secondary terminal voltage on fill-load at tunity power facton
A single phase circuit has an apparent power of 5 kVA and a reactive power of 4 kVAr. Then find (i) power factor (ii) active power (iii) resistance of the circuit when the applied voltage is 200 V.
A voltage and current applied to a single phase load is v= 195 sin (300t+35°) and i= 175 sin (250t- 40°). Find the single and three phase active and reactive power of the circuit if the voltage and current are in cos waveform. Active Power Reactive Power Three Phase Active power Three phase Reactive Power
A three-phase 400 V, 60 Hz delta connected load has three equal impedances each of (10+j50) Q2. What is the value of inductance?