A 400/230V, 50Hz, single phase transformer has 200 turns on high voltage side. Find turns ratio, transformation ratio, and number of turns on low voltage winding. Also find the flux developed in the core

A 400/230V, 50Hz, single phase transformer has 200 turns on high voltage side. Find turns ratio, transformation ratio, and number of turns on low voltage winding. Also find the flux developed in the core

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.28MCQ

See similar textbooks

Related questions

Q: 35. According to Lenz law, the induced voltage will oppose the flux producing it. a. True b. False

A: In this question we need to choose correct option.

Q: What are the characteristics of an ideal operational amplifier?

Q: The magnetizing equivalent circuit of transformer can be found by open circuit test O True O False

Q: 10/0°v Ⓒ 102 mon јгол -j25 ww 15.2 52 :-√30 5/0° v

Q: Given the circuit below, find ared prot the volage vo (t) fort = 0 (e(t) = Ovirt > 210 202 S UP 구역…

Q: inductance. Determine its impedance considering the circuit is at resonance condition.

A: At a particular frequency value the inductive reactance and capacitive reactance of the circuit…

Q: Ro Find the voltage V₂ by the corrent Source Iz 2 find the voltage V3 by the voltage Source Vz 3…

Q: 26. A parallel plate capacitor is made from 25 plates, each 70 mm by 120 mm interleaved with mica of…

A: For the above given question we need to calculate thickness of the mica sheet.

Q: 20] For the system given below, find the sinusoidal expression for the unknown current i, if 201060…

Q: 1. Determine the resonant frequency of an RLC series circuit with 15Ω resistor, 20µF capacitor, 20mH…

Q: Evaluate the following complex numbers: (a) [(5 + j2)(−1 + j4) − 5/60°]* 10 + j5 + 3/40° (b) +…

A: (a) The given expression is, z=(5+j2)(-1+j4)-5∠600* On converting all the terms into a rectangular…

Q: Theveni'ns theorem is not applicable when: 1) Load is coupled with the network 2) Linear 3) Time…

A: Thevenin’s theorem : It is possible to simplify any linear complex circuit, to an equivalent circuit…

Q: 22. For the circuit shown beside, find v₁ and v₂ ford> 0 if the circuit is in steady- state att 0.…

A: To find V1 and V2 for t > 0 in the circuit

Q: Three responses are in figure below is true or False? Initial disturbance Initial disturbance f Time…

A: 1. This is false as it is overdamped to the desired value that is 0. If it was undamped then value…

Q: Write TRUE if the statement is correct but if it’s false, change the underlined word or group of…

A: In this question , we will write about MOSFET related question.... Note :- as per our guidelines , I…

Q: Q.5) Simplify the following Boolean expression using Boolean algebra ONLY: (AB+ AB)(A + B)

A: Given, Boolean expression: AB¯+A¯B¯A+B

Q: 1. In a linear circuit the super position principle can be applied to calculate the ______ Group of…

Q: A load of 10 MW operating at a power factor of 0.5 lagging is connected to a 400 V, 60 Hz source.…

Q: 16.2 Circuit Element Models Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt-…

Q: a) I₁=5A, 1₂ = 7A, and I = 12 A. Find the B field at point a. CO ****** 13 I₁ 12 2 cm grid www.

A: Whenever current passes through the loop a magnetic field is generated , which produces a torque as…

Q: COMPLETE TABLE

A: These are all practical transistors. We can get the related data about each device from its…

Q: Question 22 The average value of the sinusoidal wave current is 15A. The maximum value is... 12.32A…

Q: Find the Fourier Series for the following common repetitive waveforms. a. Half-wave rectified sine…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: Ix: Find the current colt) in the col. shown given that is (t) = 5 cos 4t A 6 102 beaut 2H je A+jB…

Q: 1. Which of the following is the derived unit for Tesla (T)? a. Weber per meter squared b. Weber per…

A: In this question, We need to choose the correct options We need to find the unit for the Tesla?…

Q: A DSP system is described by the following differential equation with zero initial condition:…

A: Impulse response is the system output when it present with a very short input signal is called…

Q: 41. Let J = 10y²z a¸ − 2x²y a₂ + 2x²z α₂; and find the total current crossing the surface x = 3, 2 ≤…

Q: 21. a conductor has a conductance of 70µS is used to supply a load. Find its equivalent resistance…

Q: An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source.…

A: Given information is that an inductive load is connected in series to thyristor. The supply voltage…

Q: Generate a plot converting plot for a 5-bit successive approximation ADC converter if the input…

A: Given data : Number of bits N=5 Input signal V1=2.25V input range V2=5V

Q: Question 16 The average current of sinusoidal wave is 50A. Compute for current. O 74.23A O 54.12A

A: In this question average current of sine wave is given....We will find maximum current ....

Q: if the wind turbine power = 9.9 watt and the speed of turbine = 184.052 rpm swap area = 0.6m what…

A: Wind turbine:- Wind turbine is used to convert wind energy into electricity. Vertical axis wind…

Q: Question 32 Consider the following statements: In a series RLC resonant bandwidth is Inversely…

A: In this question. We will write relation between bandwidth and quality factor...

Q: and adjusted for maximum power transfer. Find the maximums Power 2

A: First we need to find the Z-parameters of the given two port network. After we will calculate the…

Q: Rin (emitter), Av, A₁, Ap

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: (a) The typical starting current for induction motor (i.e., at s=1) is five to eight times of the…

A: Induction motor:- It is a AC motor that runs at lower speed than synchronous speed so it is also…

Q: Referring to this figure, find Zo if yos = 20 µS. express answer in kiloohms 2102 C₁ ť V Z I MQ 2V…

Q: Using Bio-Savart law, calculate the Magnetic Field (B) at an axial point P a distance x from the…

A: Boot Savart Law is directly proportional to the current in the elemental part , length of the…

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data, For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: 1. Create and simplify the mechanical rotational system within the armature (dc shunt generator)…

A: A shunt generator is a type of dc generator in which the field winding is connected in parallel with…

Q: Differential compound generator has bett voltage regulation than that when it is shu connected. O…

A: In this question we will write voltage regulation of dc shunt generator and differential compound…

Q: A coil having a resistance of 2002 and an inductance of 150 mH is connected series to a 50 μF…

A: Resonant frequency is the natural frequency of object it vibrate at a high amplitude. resonant…

Q: Vin For the circuit shown, assume that Vo = 3V and that the transistor is described as follows: Kn =…

A: For the above given question we need to perform AC and DC analysis of the given amplifier.

Q: Question 14 The rms value of half wave rectified sine wave is 100A. Its maximum value is 199 A 202 A…

A: Q.14) ans:( d) 200A For half wave rectifier, RMS value of load current = Io(RMS) = Jpk /2

Q: For the oscilloscope trace of a sine wave. Each horizontal division represents 200μs and each…

Q: 22. Calculate the charge stored on a 3 - pF capacitor with 20 V across it. a. 0.150 pC b. 0.06 nC C.…

Q: An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? Group of answer…

A: In this question we will find speed of given machine.....

Q: 2. Which a. of the following BEST describes a conductor? At the surface, there are bound and free…

A: There are various types of materials which are categorized on the basis of their electrical and…

Q: A- Assume you have a Frequency Modulator where its instantaneous frequency varies with the message…

Q: 5- convert 38.347)10

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

. A 400/230V, 50Hz, single phase
transformer has 200 turns on high
voltage side. Find turns ratio,
transformation ratio, and number of
turns on low voltage winding. Also find
the flux developed in the core

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
An ideal transformer has no real or reactive power loss. (a) True (b) False
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
The core of a transformer operating at 50 Hz has an eddy current loss of 100 W/m3 and the corelaminations have a thickness of 0.50 mm. The core is redesigned so as to operate with the same eddycurrent loss but at a different voltage and at a frequency of 250 Hz. Assuming that at the new voltage themaximum flux density is one-third of its original value and the resistivity of the core remains unaltered,determine the necessary new thickness of the laminations. Clear and detailed solution.
A 3000/200V ,50hz. , single phase transformer has a cross sectional area of 150 cm2 for the core. If number of turns on the low voltage winding is 80, determine number of turns on the high voltage winding and maximum value of flux density in the core.
A transformer has primary and secondary turns of 1250 and 125 respectively. It has core cross-sectionof 36 cm2 and its rms flux density is to be limited to 1.4 T (to prevent core saturation). Whatmaximum 50 Hz voltage can be applied on the primary side and the corresponding open-circuitsecondary voltage?The core has a mean length of 150 cm and its relative permeability can be assumed to be 8000. Whatwould be the rms exciting current when the transformer’s primary winding is excited at a voltage ascalculated above? Also calculate the magnetizing susceptance as seen from primary and secondarysides.If the transformer were to be excited at 60 Hz, 1. What should be the maximum primary voltage for thecore flux density limit not to be exceeded? 2. What would be the magnetizing susceptance as seen oneach side in this case?
talk about coreless transformer
2. What is the material commonly used for construction of transformer core? Draw the B - H curve for this material?
In a single-phase transformer supply voltage 230V, 60 Hz. The supply voltage side has 500 windings and its stepped-up voltage is 444V. Write the formula and determine the maximum amount of flux achieved by the transformer and also calculate the load winding.
A single phase 60 Hz transformer has its core volume of 1.5x10-3 cu m. The maximum flux density is 1.0 tesla and the hysteresis constant of the core is 6000. find the hysteresis loss.
the core loss of a single phase transformer is 55W at 40 Hz at 90 at 60 Hz, both measured at the same maximum of flux density (a) find the eddy current frequency of 50Hz (b) find the hysteresis loss in watt at a frequency of 50 Hz (c) find the core loss in watt at a frequency of 50Hz (Take note: 4-5decimal places and box the final answe) Subject: Electrical Apparatus and Divices
A small single-phase 60 Hz transformer has 10.2 W at no load. The core has a volume of 750 cm3. The maximum flux density is 10,000 G and the hysteresis constant of the core is 0.0005. Using the Steinmetz law on hysteresis loss, find the eddy current loss.