A 10-turn square coil of area 0.053 m? and a 9-turn circular coil are both placed perpendicular to the same changing magnetic field. The voltage induced in each of the coil is the same. Calculate the area of the circular coil in m². Give your answer in 3 decimal places. Answer:

A 10-turn square coil of area 0.053 m? and a 9-turn circular coil are both placed perpendicular to the same changing magnetic field. The voltage induced in each of the coil is the same. Calculate the area of the circular coil in m². Give your answer in 3 decimal places. Answer:

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter24: Magnetic Fields

Section: Chapter Questions

Problem 11STP

See similar textbooks

Similar questions

nswer A square coil with 475 turns of wire has a length of each side of 7.52 cm. A current of 0.546 amp flows through the coil. The coil is placed in a magnetic field of 0.585 T with the plane of the coil at an angle of 34.3 degrees to the direction of the field. What is the forque in Newton-meters on the coil by the magnetic field? (Enter your answer with 3 digits right of decimal, and do not enter unit.) A Moving to another question will save this response. KQuestion 7 of
What is the magnetic field at point P shown below if a=3.39mm, b = 6.81mm, and the current 1=5,075A? Define positive as out of the page. Assume 3 significant digits and units of Tesla. b Pl —a—
If the magnetic field at the center of a single loop wire with a radius of 2.4cm is 0.014T, calculate the magnetic field if the radius would be 6.8cm with the same current. Express your result in units of T with 3 decimals.
A 8-turn generator coil with area 0.155 m^2 rotates in a 1.20 T magnetic field. At what frequency should the coil rotate to produce a peak emf of 150, expressed four sig figs with approp units. Attached are self notes. If you help me with the symbology... I know that f = frequency. I am not at clear the other symbols.
Design a current loop that, when rotated in a uniform magnetic field of strength 0.67 T, will produce an emf E = E, sin(wt), where E, = 110 V and w = 120n rad/s. First, choose the number of turns the loop should have. (Enter a positive integer less than 100.) turns Then calculate the needed area of the loop (in m2). (Use the number of turns you entered above.) m2
What is the magnetic field at point P shown below if a=3.39mm, b = 6.81mm, and the current 1=5,075A? Define positive as out of the page. Assume 3 significant digits and units of Tesla. b .... —a— 1
Figure 1 is a sectional view of two circular coils with radius ?, each wound with ? turns of wire carrying a current ?, circulating in the same direction in both coils. The coils are separated by a distance ? equal to their radii. In this configuration the coils are called Helmholtz coils; they produce a very uniform magnetic field in the region between them. (a) Derive the expression for the magnitude ? of the magnetic field at a point on the axis a distance ? to the right of point ?, which is midway between the coils.
Criterion A: Knowing and understanding i. state scientific knowledge. (Max. 2 points) A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: AP = D = BLA Round your answer to 3 significant figures. BA 2.5 Wb A 0.031 T A = m² || ||
Estimates: since the force it takes to separate one magnet from your refrigerator is nearly the same as the force it takes to separate two magnets stuck together, that force F is 5 N and the area of a refrigerator magnet is 8 cm?. Assume that when these magnets are stuck together or to the refrigerator, they are separated by an effective distance d = 25 um. Use the formula derived above to estimate the magnetic field strength of the magnet. Express your answer to one significant figures and include the appropriate units.
If the temperature of the surface of the object is 568.1 °F , then calculate its value in K. O a. 606.39 O b. 499.18 O c. 570.83 O d. 24.83 A magnetic field of 7.1 T passes through a single loop square coil of side length 4.4 x 10-2 m which makes 46.8° angle with the area vector of the coil. Find the magnetic flux associated with the coil in Wb/m²? O a. 0.940951 O b. 0.013746 O c. 0.029546 O d. 0.009410
Question 1. Plot a Graph with the data in Table 2, use Magnetic Force as the vertical axis and Current as the horizontal axis. Perform a linear least squares fit on the Graph, record the slope, intercept, and correlation coefficient in the Table 3. [Refer to Appendix 3_ Graphical Analysis of Experiment Results.docx]. Assume the horizontal copper trace on the Magnetic Force Board perfectly perpendicular to magnetic field, determine the magnitude of the magnetic field B, show your calculation in Table 3. Current (A) Table 2 0 0.25 0.5 0.75 1 -0.5 -1 Table 3 Mass of Magnet Assembly (gram) (Measured from scale) 0.000 0.039 0.080 0.122 0.162 -0.094 -0.222 Graph: Measure magnetic force versus Current Slope: Intercept: Correlation coefficient: Calculate magnetic field strength from the slope of your graph: Magnetic Force FB (Newton) 0 0.3822 0.784 1.1956 1.5876 -0.9212 -2.1756
Group A of Grade Five -Narra, started their experiment in Science about the effect of the number of coils to the strength of the electromagnet at exactly 11:30 am and finished at 12:30 pm. How long did they perform the experiment?" 1. What is asked in the problem?2. What are the given facts?3. What is the process/operation to be used?4. What is the number sentence?5. Show your solution.6. What is the complete answer