A 10-pole DC generator has a simplex lap-wound armature containing 100 coils of 10 turns each. The resistance of each turn is 0.01 Ω. Answer the following questions What is the number of conductors (Z) of the armature winding? What is the number of parallel paths of the armature winding? If the flux per pole is 0.006 Wb and the rotational speed is 950 rpm, what is internally generated voltage of this generator in volts? What is the internal resistance of the armature in ohms?

A 10-pole DC generator has a simplex lap-wound armature containing 100 coils of 10 turns each. The resistance of each turn is 0.01 Ω. Answer the following questions What is the number of conductors (Z) of the armature winding? What is the number of parallel paths of the armature winding? If the flux per pole is 0.006 Wb and the rotational speed is 950 rpm, what is internally generated voltage of this generator in volts? What is the internal resistance of the armature in ohms?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter33: Single-phase Motors

Section: Chapter Questions

Problem 36RQ

See similar textbooks

Similar questions

The armature of a two-pole generator is rotating at 3600 r/min. The armature has a simplex lap winding with a total of 1504 conductors. Determine the generated voltage when the flux per pole is 600,000 x 10-8 Wb. 5.5
A DC generator has an armature emf of 500 V when useful flux/pole is 20 mWb, and a speed of 625 rpm. The generated emf at a speed of 125 rpm and same flux is
A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of parallel path in the winding is A 12 B 8 C 16 D 4
AC Machinery Fundamentals A three-phase delta-connected six-pole winding is installed in 36 slots on a stator. There are 150 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1000 r/min. What are the resulting phase and terminal voltages?
Q- In a DC generator, what will be change in emf induced if flux is reduced by 20% and the speed is increased by 20%.
The strength of the rotating magnetic field in a three phase induction motor is equal to times the flux produce ...... ....... in one of the phase windings. 1.25 1 O 1.5
The simplex lap DC generator has 4 poles, 16 slots, with a constant rpm of 600 rpm and 4 conductors per slot. Determine the following: a. Flux per pole (Ø) b. Commutator Pitch c. Pole Pitch d. Coil Pitch
3. A group of electromagnets that create flux in a d-c generator (the field circuit) has an inductance of 18 henrys. If the 3.4 amp excitation is interrupted in 0.08 sec by the opening of the field switch, what average voltage is induced in the winding?
A three-phase Y-connected four-pole winding is installed in 24 slots on a stator. There are 40 turns of wire in each slot of the windings. All coils in each phase are connected in series. The flux per pole in the machine is 0.060 Wb, and the speed of rotation of the magnetic field is 1800 r/min. (a) What is the frequency of the voltage produced in this winding? (b) What are the resulting phase and terminal voltages of this stator
A 4-pole dc generator with duplex lap winding has 48 slots and 4 elements per slot. The flux per pole is 2.5 x 106 maxwells and it runs at 1500 rpm. Find the output voltage.
a 6-pole DC generator has a simplex lap-wound armature containing 288 coils of 10 turns each. The resistance of each turn is 0.01 Ω. The flux per pole is 0.006 Wb.
Shunt generator running at 1000 rpm, if flux is reduced by half, then what is the new speed 1000 r.p.m O 2000 r.p.m 500 r.p.m O Or.p.m