1) a) The frequency of the source voltage in the circuit in the figure is500Ω 1μFadjusted until i, is in phase with Vg. What is the value of o in radiansper second?b) If V-20cosot V (where @ is the radian frequency found in part Vg[a]), what is the steady state expression for Vo(t) ?ig0.5H 3 Vo1000Q

Answered: Image /qna-images/answer/cce18460-64d0-46ca-9f1e-6bffe3f61901.jpg

500Ω ΙμF 1) a) The frequency of the source voltage in the circuit in the figure is adjusted until i, is in phase with Vg. What is the value of w in radians per second? b) If V,-20cosøt V (where @ is the radian frequency found in part [a]), what is the steady state expression for Vo(t) ? + 0.5H 3 Vo 1000E

500Ω ΙμF 1) a) The frequency of the source voltage in the circuit in the figure is adjusted until i, is in phase with Vg. What is the value of w in radians per second? b) If V,-20cosøt V (where @ is the radian frequency found in part [a]), what is the steady state expression for Vo(t) ? + 0.5H 3 Vo 1000E

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Similar questions

For a series RLC circuit with a sinusoidal input voltage, the amplitude of the current passing through the circuit (I, in mA) is plotted as a function of frequency for two cases: Curve 1 with R1, L1. and Curve 2 with R2. L2 as shown in the next figure. The value of the capacitor used in the circuits is C=0.01 micro Farads. If the value of R2 =1600 Ohm then the input voltage (in volts) is: 7.5 25 110 Frequency H2 O a. 4 O b. 16 sin(9888 t) O c. 8 O d. 8 cos(6.28 f t) O e. 8 sin (6.28 R t)
1. What is the shortest time required for a 4.3-krad/s sinusoid to increase from two-fifths to four-fifths of its peak value ? CHOICES: A. 120 s B. 140 s C. 160 s D. 180 s E. NOTA
18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage V= sin2t? Vs (1 + j1) Q (a) -F 4 (b) (c) (d) 1F /-
Date Pags 2) A sinusoidal alteznating voltage has value of 200V and 50 Hz It cEOSses an EoMo S. a fzequency of the zeso axi in a pasitive disection when t=0. Detezmine ņ the Aime when voltage fizst teaches the instan Zenemus value of 200 V and 2) the whe time when Valtage madei mum. after passing throag its positive ualu e eeashes the value Of 141.4V.
For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and the volt/cm switch is on 1 V/cm. a) the frequency will be Hz b) the r.m.s value will be In CRO the beam can also be shifted vertically by applving a suitable DC voltage to the
A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth harmonic, both of the harmonics being initially in phase with each other. (a) Determine the rms value of the fundamental and each harmonic. (b)Write down an expression to represent the complex voltage waveform if the frequency of the fundamental is 31.83 Hz.
An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in series. The voltage across the capacitor: Select one: a. Leads the current in the capacitor by exactly 90o b. Is in phase with the sinusoidal voltage source c. Is in phase with the voltage across the resistor d. Leads the current in the circuit by 90o e. Lags the current in the circuit by 90o
A sinusoidal 50 Hz voltage of 200 V (rms) supplies the following three circuits which are in parallel: (a) a coil of inductance 0.03 H and resistance of 3 ohms, (b) a capacitor of 400 microFarad in series witha resistance of 100 ohms and (c) a coil of inductance 0.02 H and resistance 7 ohms in series with a 300 microFarad capacitor. Find the total current supplied?
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
Given the circuit, solve for:a. Total currentb. Total apparent powerc. Total real powerd. Total reactive powere. pf of the circuitPlease, I need a complete solution. I promise to give it a thumbs up! :)
Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this load is an AC voltage supply with 120V RMS at a frequency of 50 Hz. Please find; A) Peak current (m) and RMS Current (ms) Values B) Draw peak voltage and current phasors on phasor diagram with everything labelled C) Find the value of an inductor that when connected in parallel will improve the power factor to 0.95.
The voltage across a 50 resistor is 30 sin (377t-20). Find the sinu: expression for the current. O a. 6 sin(377t + 20) Ob. 6 sin(377t - 20) Oc. 30 sin (377t - 4) Od. 6 sin (377t)