5. Two point particles, one with charge +8 × 109 C and the other with charge -2 × 10⁹ C, are separated by 4m. What is the electric field in N/C midway between them?

Q: A 1:1 transformer has a 4-ohm primary impedance. What is the value of the primary impedance seen at…

A:

Q: Señal QPSK de entrada -sen ot+cos at BPF Canal I -sen at + cos at Divisor de potencia Detector de…

A: Canal I means in-phase channel and Canal Q means quardrature-phase channel Input to QPSK…

Q: The potential difference (VA - VB) between the points A and B in the given figure is. VA A I=2A 22…

A: Given circuit,

Q: In order to connect a LED to one of the pins: O You need to define that LED as an OUTPUT in the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 2- A message signal given by m(t) = 3 cos (400 t+n/2) is sampled with the minimum sampling rate…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: Use a 0.05-µF capacitor to design a high-pass filter to have cutoff frequency of 100 krad/s. Draw a…

A: The required circuit can be designed with the help of capacitor and resistor. The capacitor will…

Q: minals (see fig 3) ? alent circuit for the network in fig 4. through terminals A B and C in fig 5. -…

A:

Q: Discuss different solar photovoltaic technologies in detail.

A: By directly collecting solar photons—light particles that function as individual units of energy—and…

Q: 3. Use the mesh-current method to find io in the circuit 80 V Ans. % = 1 A 5Ω 70Ω 10Ω ww 5Ω 12Ω

A: For the given electrical circuit we need to calculate the value of io by using mesh analysis method.

Q: Problem 1: D1.8. Transform the following vectors to spherical coordinates at the points given: (a)…

A: It is given that: a)10ax at P x=-3,y=2,z=4b)10ay at Q ρ=5,ϕ=30°,z=4c)10az at M r=4,θ=110°,ϕ=120°

Q: An AM broadcasting station is transmitting a frequency of 950 kHz with a total bandwidth of 10 kHz.…

A: In this question,  We need to determine the cut off frequency and modulating frequencies?  We know…

Q: f(t) = Asin(Bt)u(t) − Cu(t) + Dt² where A=2, B=5, C=-4, D = 4. A manufacturing process is…

A:

Q: D dal signa =[n] = (3 =) = [u]- -[n] = (-

A: Given as, fs=10Hz Ts=1fs=0.1sec t=nTs=0.1n As per rule, allowed to answer first three subparts and…

Q: 4. Write nodal equations for V1, V2, V3, V4. Do not simplify. 50 Vi V3 2H Заст 1412 V₂ 육 V4 222

A: Given data, Circuit diagram is given as,

Q: Write a note on history of wind power

A: History of wind power : Wind energy is in use from 5000 BC wind energy is discovered by James Blyth…

Q: Write down the types of solar photovoltaic cells based on material used for their fabrication A.…

A:

Q: Converter control in solar photovoltaic

A: The photovoltaic effect, which is the conversion of light (photons) to electricity (voltage), gives…

Q: Why transformer rated in KVA ?

A: Transformers are a type of energy converter that move power from one side of a circuit to another…

Q: 3.15P) The excess electron concentration and Electic field is plotted in a bar of an n-type…

A: Semiconductor: Any member of a family of crystalline solids known as a semiconductor falls into the…

Q: T 15 cm 50 cm 15 cm —15 cm- 1 Ø ↓ Metal 2 i₁ 50 cm- -15 cm Metal 1

A: Formula N= no. of turnsI= currentϕ= fluxR= relucatnceNI=ϕRR=NIϕ=lengthμ0μr A

Q: In the circuit below Vin(t) = 10V, and has been present for a very long time. in $1 1 Ω In 2 1F HH…

A: For the above given circuit diagram we need to derive the instantaneous voltage expression for both…

Q: Using op amps with Vsat = +/- 13 V, design a square/ triangular wave function generator circuit to…

A: Triangular Wave Generator Using Op amp- A Triangular Wave Generator Using Op amp can be formed by…

Q: a. The value of excitation current required for full load current at 0.7 pf lagging (over-excited).…

A: The alternator is a machine which converts mechanical energy to electrical energy. It generates…

Q: Describe power system interconnection ecperience in the world

A: The network of the power system is connected to other networks. It denotes that every generator is…

Q: The color code of a resistance is given below. The values of resistance and tolerance, respectively,…

A: Given: Resistor with color code,

Q: For the given circuit and input waveform determine the output waveform. a. b. C. d. 15 a b -10 20 20…

A:

Q: . Calculate the minimum bilateral Nyquist bandwidth, FN, and baud, for a modulator 8-PSK with 20…

A:

Q: R1 R2 wwwwwww C1 R3

A:

Q: What is current transformer? 2 difference between current and potential transformers.

A: A step-up transformer that lowers the current while raising the voltage is a current transformer.…

Q: Magnetic field intensity is given by H = 2 cos (2 x 10 ⁹ t -ky) a A/m in air medium. What must be…

A: Given, Magnetic field intensity, H = 2 cos 2×109t-ky az Am

Q: Apply Laplace transform to find the transfer function H(s). y"(t) − y'(t) — 2y(t) = x'(t) − x(t)

A:

Q: 1) Calculate the bandwidth and baud rate for an FSK signal with mark frequency 34 kHz, space…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: b) A manufacturing process is represented by the following block diagram where G₁(s) = 4/s, G₂(s) =…

A:

Q: Why do we use vectors in electromagnetic fields?

A: In this questions we need to tell about the why we are using vector quantity in electromagnetic.

Q: Use a 36-mH inductor to design a low-pass filter having a cutoff frequency of 36 kHz. Draw a…

A:

Q: 7. Space diversity s also known as

A: The solution is provided in the following section.

Q: b) A manufacturing process is represented by the following block diagram where G₁(s) = 4/s, G₂(s) =…

A:

Q: 5. Use the mesh analysis to find the branch currents it, iz, and is in the given circuit. 500 Ω m 20…

A: Circuit diagram is given as,

Q: 5. Find the z-transform of the following finite duration signals and indicate their ROC a. x(n) =…

A:

Q: Hz? Assume X₁ XL = 300, 30Ω

A: Given as, XL=30Ω,Rw=10Ω,fr=10 MHz.

Q: A 150 V, 1400 rpm shunt DC motor is used to supply rated output power to a constant torque load. On…

A:

Q: Find the output waveform from the given circuit and input waveform. 2V KO 10 k V m 20

A:

Q: 3.0 Ω μέλη ΑΛΛ 40Ω 2.0 Ω ΜΕ 5.0 Ω 10 Ω ' 12 V

A:

Q: In the circuit shown below, the AC voltage is V0 cos(ωt). Find: (a) The current I(t) through the…

A: Detailed solution is attached in the form of notes. Please go through it. Thank you.

Q: 4. Use mesh-current method to find v. and vx. 24V 1 + 10 A Ans. vx = 18 V and vo = 20 V 40 U + Ux +…

A:

Q: Discuss solar energy in future power system

A: In the given question we need to discuss solar energy in future power system.

Q: hort term and long term effects of wind energy on power system

A: SHORT TERM AND LONG TERM EFFECTS OF WIND ENERGY ON POWER SYSTEM: 1. The following factors are…

Q: Derive conditions for economics dispatch when generating stations are connected in parallel

A: Economic load dispatch means runs the generators at a condition where cost of power generation is…

Q: the past is said to be O Memoryless O Stable O Time Invariant O Invertible. O Linear O Causal O None…

A: We need to select correct option for given statement

Q: According to the NEC, allowance for the future expansion of installations is A. an exception. B. in…

A: Answer:A:- an exception