Answered: 5) The inductor in the figure A below…

5) The inductor in the figure A below is 47 uH with a tolerance oftl0%. Given the current waveform in figure B, graph the voltage for the minimum and maximum inductor values.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 4000 Hz, what sampling rate should be used to retain all necessary information in the digital data?…

Q: Example1.Two 220-V, d.c. generators, each having linear external characteristics, operate in…

Q: D. 5. All three sets of windlll must have the same A. voltage phase B. motor terminal C. bleed…

Q: Current can not flow through an insulator because they have O a. free electrons O b. no free protons…

A: The electrons in the insulator's atoms are strongly bonded, which means they don't have any free…

Q: 3. Find the equivalent resistor for the figure below. Write which one is in series or parallel. 20 2…

A: Given circuit:

Q: By means of DFT and IDFT, find in details the circular convolution between the following two…

Q: Electrical Networks Dr. Mustafa Rashid H.W 2.4: For the A- A circuit of figure 2.25, calculate the…

A: Given: circuit diagram

Q: . Comment the resultant signal of the circuit shown in Fig. (6-3) Vin Vc AC Channel A Channel B Fig.…

A: We need to comment on the resultant signal of the circuit.

Q: ) A heater with resistance 10 N is driven by an AC voltage source (120 V). For the circuit shown…

A: As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q: find the DTFT of the following two-sided sequence x(n) = (0.25)"|

A: given x(n)=0.25n here we have to determine the DTFT of x(n)

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 5OA. If d'Arsonval…

Q: From the given circuit, determine v, for all time interval when V, = 30 [u(-t) + u(t – to)] V to =…

A: In this question, We need to determine the voltage Vc across the capacitor as shown the circuit.…

Q: Q3: If h[n] = A 8[n] + (1/3)" u[n] is the unit sample response of an LTI systems, s[n] is the step…

A: In this question we need to find a value of A .

Q: 1. A 5-kVA, 110/110-V, single-phase, 50-Hz transformer has full-load efficiency of 95% and an iron…

A: Given:5 kVA, 110-110V, single phase, 50 Hz transformer,full load efficiency of 95%, Iron loss,…

Q: These instruments help aircraft avoid collision with other aircraft. * Magnetic compass ILS DME TCAS…

A: We need to answer which of the given instrument helps aircraft to avoid collision with other…

Q: Q) Consider the circuit shown in Fig.1. The input to the circuit is the voltage source v(t)=7.68cos…

A: Given Input voltage and output voltage.we need to determine capacitance. Please find the below…

Q: *53. For the waveform of Fig. 104: a. Carefully sketch the squared waveform. Note that the equation…

Q: 6Ω 3Ω ww 12 V (+ 12Ω 2 A RL

Q: D7.3. Express the value of H in rectangular components at P(0, 0.2, 0) in the field of: (a) a…

A: Rectangular Components: "Rectangular vector components are defined as the sections of a vector that…

Q: Problem 7 Consider the circuit shown in Fig. (5) Assume that E = 1.25 p.u., and V 1.00 p.u. %3D a-…

Q: The switch in the circuit below closes at time t=0, and a long time passes such that steady-state…

A: We need to find out voltage across R3 .

Q: Electrical Engineering some applications that benefit greatly from CMOS based amplification

Q: Show that the response of the system h[n] = a"u[n] to the i/p, x[n] = B"u[n], where Ja| < 1, \B| < 1…

Q: Calaulate the Current in the lles by Applying Thevenin thearem ? 2202 2402 75A lov lo02 ition

A: We need to find thevenin equivalent circuit

Q: For the circuit shown, R, R, • R1 = 39 kN • R = 18 kO • R3 = 22 kO • R4 = 47 kn irs R4 Is = 0.54 mA…

A: Given, R1=39 kΩR2=18 kΩR3=22 kΩR4=47 kΩIs=0.54 mA

Q: Q.3)) Design a synchronous 3-bit twisted ring counter with illegal state recovery circuit. Draw a…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Why is Vrn 11000/ sqrt 3. Why is it not multiplied by 3? Also is Vph 11kv or is 11kv a line voltage

A: In this question we will write about how voltage is taken by given....

Q: 9. Giren the nerork of Fig 2 Determine ZT. b. Find L C. Calculate Vgand V- d Find Pand F + -+ Vc- C…

A: In this question, We need to determine the impedance ZT and current I?

Q: b) A lk resistance is connected across the secondary winding of a 200V/400V transformer with the…

Q: Qi the open-lood Ptonrus funetion fur unity feed hack system is G(S) = 2 ,determen Bode ? slles)…

Q: Q3 A d.c. Motor takes an armature current of 110 A at 480v. The armature circuit resistance is 0.2…

A: The solution is given below

Q: ind the mobilities, and resistivities of silicon samples at 300 för éäch öf the following impurity…

A: Please refer the attached images for the complete answer..

Q: o +15 V 250k 2.2k 22k C 1815 If the base current is 10 µA and the collector voltage is 10 V, the…

Q: circuit connection diagram on how to synchronize an alternator to the grid using lab volt. using…

A: The purpose of the synchronization is to ensure that during the circuit breaker closure (closing the…

Q: roblem 3 nd the characteristic equation and its roots for the circuit shown. 10 10 μF Vs 1 mF

Q: : Fill in the blanks for the following 1- The three main steps of PCM system are 2- The Nyquist…

A: 1. The three main steps of PCM are Sampling, Quantization and Coding. The given signal should be…

Q: (a) The plane defined by y – x = 6 separates medium-1 (y – x > 6) of permeability u = µo from…

Q: From the given circuit, determine v, for all time interval when V, = 30 [u(-t) + u(t – to)] V to =…

A: In this question, We need to determine the voltage Vc if time to= 10ms.

Q: Express the sequences shown in Fig. In terms of unit step functions. ... Consider a discreto-time…

Q: A hydroelectric station is supplied from a catchment area of 150 km with annual rainfall of 200 cm…

A: Given a hydroelectric station is supplied from, Catchment area = 150 km2 Annual rainfall = 200 cm =…

Q: Which statement about the photodiode array is NOT correct? All are accurate Not all are accurate A…

A: Photodiode: Photodiode is a semiconductor device it converts light into current. Current generates…

Q: + + vdt) L 5H i(t) (1 0,1F R Vg(t) 10

Q: Proof the expression for string efficiency.

Q: 1. Referring to Figure Q1, apply Mesh Analysis to calculate current (I) for each loop by applying…

A: The solution is given below

Q: A 15 mH is connected in series with another coil. The total inductance in series addition and series…

A: Given a series connected inductance coil having, Inductance, L1=15 mH Total inductance in series…

Q: Exumple - Find the exponential Fourier Series and plot the Frequency spectrum for fall ware reeti…

Q: A transformer is used to reduce the voltage of a supply from 120V a.c to 12V a.c. Explain how a…

A: Brief description : In the above given question they are discussing about the transformer.…

Q: Q3 A 20 h.p., 250 V shunt motor has an armature circuit resistance (including brushes and…

A: The solution is given below

Q: Explain how wiring the control components for sump pumps and fill tanks differs.

A: Wiring: Electrical wiring involves the installation of cabling and associated equipment in a…

Q: I. Explain how the electron gun creates a beam of electrons. Add to the diagram if that will help…

A: The given diagram of an experiment with electrons is shown below, Here, A beam of electrons is…

Question

5) The inductor in the figure A below is 47 uH with a tolerance oftl0%
Given the current waveform in figure B, graph the voltage for the
minimum and maximum inductor values.
i(t)
v(1) L 3
(a)
15
10
5
-5
-10
-15
10
20
30
40
50
60
70
80
Time (ms)
(b)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

plot for minimum inductance

VIEW

ii) For maximum inductor value

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
List the five capacitor replacement rules.
Three capacitors 6, 10 and 15 uF are connected in series across a 100 volt supply. Find the voltageacross the 10uF capacitor.
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higher
The anode of a diode is connected to one terminal of a 1-KΩ resistor. The other terminal of the resistor is connected to the ground and the negative terminal of a 12-volt DC source is also grounded. The three components are connected in series. How much is the load current with the ideal diode?
What is the equivalent resistance ?? and what is the total inductance ??
4) Determine the value of branch current, I1 and I25) Determine the value of voltage across resistor, R1, R2 and R36) Determine the value of voltage across capacitor, C1 and C27) Determine the value of voltage across inductor, L.