S4. Consider the system shown below. Let K 2 N/m, C = 2 kg/s, M = 1 kg,x(0)=-0.1 m, and v(0) = 1 m/s.9(a) Find the displacement of the mass x(t) after 1 second has elapsed, i.e., findx(1).(b) What frequency in Hz does this system vibrate at ?KmmmKmm3сH→x(+)MdtvW20diAnthheeler,ME3040

The mass is .The spring constant is .The damping constant is .The intial condition are .

Answered: 4. Consider the system shown below. Let…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A particle of mass m is constrained to move under gravity on a smoothsurface given by the equation: h(x, y) = x2 + y2 − xy. a) Use the Lagrangian formalism to find the equations of motion for theparticle.b) Consider small oscillations about the orgin, what are the frequenciesfor teh normal modes?(c) If one is to release the mass close to the origin, what must be the ratiobetween the x and y displacements so that only the higher frequency normal mode oscillation will be excited
3. A particle of mass 20 g is connected to one end of a spring on a frictionless horizontal surface and moving in a simple harmonic motion about the origin. The displacement given by x = 2 sin 3t , where x is in meters and time, t is in seconds. The motion starts when t = 0. (a) , What is the total distance travelled by the particle at time t = 3T/4, where T is the time period? (b) Find the kinetic and potential energy of the particle at time t = 3T/4. * What is the acceleration of the particle when it first comes to a rest? (c) t
Q6. For a point at distance 50 m and angle 450 to the axis which of the following are correct? Consider an infinite baffled piston of radius 5 cm driven at 2 kHz in air with velocity 10 m/s. You may choose multiple options. A. k = 18.32 and J1(ka sin(q))/ka sin(q) = 0.17 B. k = 36.64 and J1(ka sin(q))/ka sin(q) = 0.40 C.k=5.83 and J1(ka sin(q))/ka sin(q) = 3.16 D. None of the above Submit E
1. The figure shows a uniform rod with a mass of 3 kg and is pivoted at point A. There is a solid mass of 4 kg at point C. The value of the coefficient of elasticity of the spring k1 = 20 kN / m and k2 = 100 kN / m. Determine; a) the natural system Frequency b) The time taken by the system to complete one oscillating. 20 cm 80 cm k1 B k2 k2 k2
3. Consider the single degree of freedom spring-mass system shown in Fig. where k = 4 x 10$ N/m and m = 8 kg. It is being excited by a harmonic forcing function, F1e'o", at a frequency, wf. (a) If the excitation frequency is 200 rad/s, design a dynamic absorber to eliminate the vibration at coordinate x]. The only available spring for use in the absorber is identical to the one already used in the system. (b) If the 4x10° N/m absorber spring is used in conjunction with a 2 kg absorber mass, at what forced excitation frequency (in rad/s) will the steady-state vibration of coordinate x1 be eliminated? k m
3. A mass of 2 kg stretches a spring by m with a force of 10 N. A dashpot is attached that exerts a resistive force of 16 N and the speed is 2 m/sec. At t = 0, the mass is pulled left 1 m and released with a velocity of m/s to the right. Find the displacement function in the form: Ce-pt cos (w;t-a,). What are the systems pseudo-frequency and pseudo-period?
1. Find the natural frequency of the system for small oscillations. k=250 N/mm ww 12 kg 160 cm
3. Suppose the model of a vehicle suspension is given below. Write the equation of motion in matrix form (not in State Space form). Calculate the natural frequencies for k₁ k2 10 N/m, m2 = 50kg, and m₁ = 2000kg. -= - - 103 N/m, 1 x1(c) m1 www m1 Car mass k₁ Car spring k1 k₂ Tire stiffness www x2(1) m2 Tire mass м2 k₂ ↑
i, Consider the following 1-DOF system, where k :0-3 kg, calculate the natural frequency in rad/s and Hz. Also find the period of scillations and the maximum displacement if the spring isinitially displaced 10 am with no initial velocity. 857.8 N/m and m = 49.2 x
[2] Find the equivalent spring stiffness for the vibrating system shown in Fig.2. If kl - k3 - k5 - 2k and k2 - k4 - k6 -k, determine the system natural frequency in Hz k1 k3 k2 ks k4 k6 fig. 2 y
6. A 1kg mass is attached to a spring (with spring constant k = 4 N/m), and the spring itself is attached to the ceiling. If you pull the mass down to stretch the spring past its equilibrium position, when you release the mass and observe its (vertical) position, it's said to undergo simple harmonic motion. AT REST MASS PULLED DOWN wwww Under certain initial conditions, the mass's vertical position (in metres) relative to its equilibrium position at time t, y(t), can be modelled by the equation y(t) = cos(2t) – sin(2t), (Note that y measures how much the spring has been stretched, so y = 1 indicates the mass is Im below its equilibrium position, whereas y = -1 indicates it is 1m above its equilibrium position.) (a) Find expressions for the mass's (vertical) velocity v(t) (relative to its equilibrium position) and the mass's (vertical) acceleration a(t) (relative to its equilibrium position). (b) Is the mass moving toward the ceiling or toward the floor at t= T? Justify your answer with…
1) A 0.1 kg object oscillates as a simple harmonic motion along the x-axis with a frequencyf = 3.185 Hz. At a position x1, the object has a kinetic energy of 0.7 J and a potential energy 0.3 J. The amplitude of oscillation, A, is: (a) 0.12 m (b)0.22 m (c) 0.31 m (d)0.42 m

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

4. Consider the system shown below. Let K-2 N/m, C- 2 kg/s, M = 1 kg, x(0)=-0.1 m, and v(0) = 1 m/s. (a) Find the displacement of the mass x(t) after 1 second has elapsed, i.e., find x(1). (b) What frequency in Hz does this system vibrate at ? K mmmm K mm с इ J x(+)