3 liter per 26 sec is discharged from nozzle to impact 60°target if the distance between nozzle and target equal four times a nozzle's diameter and the diameter for nozzle equal 1cm depend on this information to answer following questions: 1. determine the velocity at nozzle 2. determine the impact force 3. if we change the target to hemispherical, determine the ration between two forces

3 liter per 26 sec is discharged from nozzle to impact 60°target if the distance between nozzle and target equal four times a nozzle's diameter and the diameter for nozzle equal 1cm depend on this information to answer following questions: 1. determine the velocity at nozzle 2. determine the impact force 3. if we change the target to hemispherical, determine the ration between two forces

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

A ballistic pendulum is a device often used for measuring the velocity of a projectile. Assume to projectile fully embeds itself in the pendulum. If the projectile mass is 25 grams, the pendulum mass is 2.5 kg, and the vertical displacement of the pendulum after the collision is 12 cm, find the velocity of the projectile just prior to the collision. cm cm
QUESTION 2 A canon fires a projectile at an angle of 23 degrees with the horizontal with an initial velocity magnitude of 22.2 m/s. The projectile ultimately hits the ground in the East of the launch point. Find the magnitude of the accelaration vector 2.35 seconds after the projectile was fired. Assume the effect of air resistance is negligible. Enter the accelaration in unit of m/s.
Graph below represents the force on a 12 kg air mass as it passes through a jet engine. Immediately after entering the engine, the force is 9,039 N, and the force tapers linearly to zero once the air reaches the back of the engine 2.3 m later. If the air enters the engine with velocity 252 m/s, what is its exit velocity? (Please answer to the fourth decimal place - i.e 14.3225)
A bullet is fired with muzzle veloity of 600 m/s. If the length of the barrel is 750 mm. What is the average acceleration?
A helicopter with a mass of 10,000 kg takes off straight up at t=0. The thrust of the engine is defined given as a function of time: FT= 95 0.18t- (kN). Where t is in units of seconds. How fast is it rising and what is its elevation at t=4s?
Q1 A balloon is rising vertically above a level, straight road at a constant rate of 1 ft sec. Just when the balloon is 65 ft above the ground, a bicycle moving at a constant rate of 17 ft sec passes under it. How fast is the distance s(t) between the bicycle anoballoon increasing 3 sec later?
The figure below shows a diver going through general motion. The diver's center of gravity can be assumed to undergo a projectile motion. Assume that the diver takes off from a diving board such that his center of gravity is a height ho = 11m above the water level and enters the water at a horizontal distance 1 = 4m from the end of the board. If the total time the diver remains in the air is t2 = 2.3s, calculate the speed, vo, and angle of takeoff ,O, of the diver's center of gravity. Also determine the height, hi, the diver reaches at the top of the dive. (Note that tr is NOT half of t2.)
My calculated value of acceleration is 12.2 m/s^2 when I drop the object from a height of 3 m. And I need help with the question that is in the attached image.
in a slapshot, a hockey player accelerates the puck from a velocity of 8.70 m/s to 35.50 m/s in the same direction. If this shot takes 3.90x10^-3 s, calculate the distance over which the pug accelerates
4. 3) The hydraulic cylinder D extends, moves the rigid rod ABC, and causes the collar A to move with velocity and acceleration both to the left. If the dimensions 4 = 1.0 ft, and 2 = 1.6 ft, VA = 3.6 ft/s, aa = 2.2 ft/s2, and the angle 0 = 27°, determine the speed of point C. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. %3D В 12 D Your Answer: Answer units 1,
OR Fig. 3 A robotic arm shown in Fig. 3 is programmed so that the 0.4-kg part A traces the radial path defined by r = 1–- 0.5 cos (2nt) meter and tranverse path of 0 = 0.5 – 0.2 sin (2nt) rad respectively. a) Calculate the velocity magnitude of part A at 1= 3 seconds. b) Determine the radial and transverse components of the force exerted on A by the robot jaws at 1= 2 seconds. Show the necessary Free-Body and Kinetic diagram to support your analysis.
The pressure altimeter is an aneroid barometer that measures the pressure of the atmosphere at the level where the altimeter is located. Consider a jet airliner moving at 447 mph in a direction 60 degrees cast of north, has a speed relative to the ground of 503 mph due east. Recall from physics I that a plane has both an absolute speod relative to the ground, and a speed relative to the air. The values are different in the presence of wind. Draw a cartesian vector diagram of the jet, both with respect to the Earth and ait. a) Caleulate thex and y components of the geostrophic wind the plane is flying in. Use 3 sig figs for all. b) If the pilot simply flies along the pressure surface, calculate the rate of change in altitude of the plane using the characteristic Coriolis parameter defined in clas Vg x: type your answer. Vg y: type your answer. Rate of change of altitude (in m/km): type your answer