Answered: 27. Determine the capacitance required…

27. Determine the capacitance required to establish a capaci- tive reactance that will match that of a 2-mH coil at a fre- quency of 50 kHz.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Related questions

Q: How much current is flowing thru a lamp having a 60 ohm resistance when connected across a 110 volt…

Q: Given two vectors Y = 5ax+ 7ay - 5az and S = 7ax - 10ay - 5az, find the angle between Y and Ś using…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: ) Minimize the logic expression Y = BC + AC + AB using Boolean Algebra rules (Please show the…

Q: Design a BCD to excess 3 combinational logic circuit. Take a picture of the derived truth table

Q: A spectrum analyzer is used to measure the magnitude of a certain signal with respect to its…

Q: A zener diode is rated at 6.8 Vdc, 1 watt. What is the maximum zener current the diode can safely…

A: Given, Vz = 6.8 Volt, Pmax = 1 Watt, To calculate maximum zener current that diode can safely…

Q: P5.4 A temperature sensor was connected to a 16-bit A/D converter with 0 to 5 V analog range. The…

A: Solution- Given, It is a 16 bit AD converter., its capability to store a maximum of 216 = 65536…

Q: 3 2 + V2 is v5 70 24 V + Vi

A: We need to find out current and voltage and power for given circuit

Q: 2 MN 1.4 ΜΩ 2 µA 1.3 μΑ 3 ΜΩ () 41 μΑ 2.7 ΜΩ

Q: Calculate the current across the 20 ohm resistor. 20 otm www 30 ohm 200V

Q: IV. SOLVE THE CURRENT IN R4, I. (CURRENT DIVIDER) V. SHOW ALL COMPUTATIONS. R, = 60 2 ww R2 = 40 N…

Q: 10 ww 10 ww 10 10 100 V 10 50 V ww +

Q: 3) Find gm, Zi, Zo, Av (3mS, 8.2MN, 4.7kN, -2.56) + 12V IDSS= 9 mA 4.7ΚΩ Vp = - 3 V VGSQ = -1.5V 20μ…

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalized radiation…

A: HPBW means Half-Power beam Width and FNBW means First Nulls beam Width

Q: Question 17 Determine the collector voltage Vc 10 V 4.3 k2 I, B = 100 390 k2 +10 V (A) 10 V (B)…

A: In this question, We need to choose the correct option What is value of voltage At the collector?…

Q: Three unequal single phase loads so connected across the lines of a blanced 3 phase, 230 volts…

A: The phase voltage is equal to line voltage in a delta connection. The detailed solution is provided…

Q: Which component of impedance is not dependent on the frequency of the source of voltage? A.…

Q: Part B: Poly-Phase Circuits 1. A three-phase, 330V, 60HZ source is connected to a balanced, purely…

A: The solution is given below

Q: An impedance coil having resistance 28.8 Ohm and inductance 0.024H is connected in series with a…

Q: Please answer with complete solution :)

Q: 60 100 200 s00 fodo What is the actual reacing? 20 50 30 t0 2k k 00 200 100 2 20 100 40 200 10 160…

A: Multimeter Can measures AC voltage DC Voltage Resistance Continuity between points Capacitance…

Q: An LTI system has frequency response H(2) = 1+72n 1+70.512 a. Plot |H(N)| and /H(2) b. Is this…

A: Given,

Q: What advantage does polyphase equipment have over those used in 1-∅ service? Explain in not less…

Q: If the frequency were halved, what would be the new impedance of the series RLC circuit? Given:…

Q: Two impedances A and B are connected in parallel across a 120 Volts AC supply. The total current and…

A: The solution is given below

Q: Question 11: Sketelh a eircuit that uses three full-adders and three NOT gates to calculate the 2's…

Q: Prove that a NAND gate is a Universal gate?

Q: In case of PD-control, a. the derivative term looks at the past of the error. b. the effect of…

A: Any control system is defined by the transfer function. The system is desired to produce desired…

Q: inverse laplace of (s/2+5/3)/(s^2+4s+6)

Q: A three-phase circuit has two parallel connected balanced loads. The first balanced delta load with…

A: The solution is given below

Q: Using mesh analysis solve for 11 12 13 14 5+j5 3-j3 3-j3 20V 25V/10) 1-j2

A: In this question, We need to calculate the mesh current in shown in the circuit using the mesh…

Q: 5.4 Figure P5.4 illustrates a parallel T null circuit. Find the frequency , at which the V.0. R R…

A: Given the circuit, as shown below: We need to find the frequency ω0 at which the Vo→0.

Q: 8-15. Fill out the table for the circuit diagram at the right. Show your solution on the space.…

Q: Problem Solving: Solve the following word problems showing detailed solution (with equatio and…

A: In this question, We need to determine the calculate the equivalent resistance R as shown in the…

Q: Calculate the average output voltage based on a 2Vp (use the half-wave rectifier)

Q: 2. Switch of mobilé P1. Use nodal analysis to find the current i 12 mA 2 kn 2 mA E3 k 1 kn 6 mA -1

Q: 3. Determine the total resistance and the total current. 152 lon 502 1oov(+ 15n 1on

Q: A B

Q: E̲x̲p̲r̲e̲s̲s̲ ̲t̲h̲e̲ ̲f̲u̲n̲c̲t̲i̲o̲n̲ ̲F̲(̲A̲,̲ ̲B̲,̲ ̲C̲,̲ ̲D̲)̲ ̲=̲ ̲D̲(̲A̲’̲ ̲+̲ ̲B̲)̲ ̲+̲…

Q: L{sinh 3t + sin 3t}

Q: Two wattmeters are used to measure the total power drawn by a balaced delta connected load. If the…

A: For balanced loads The power drawn is same Power drawn by three phases is the sum of two wattmeters…

Q: 1. A 100kW, 230V, shunt generator has an armature resistance and field resistance of 0.050 and…

Q: Given B =100 a. re = 4.5 A and Yo a40k2, %3D sketch the approxinate hy brid equivalent circuit

A: In this question we will draw approximate hybrid equivalent circuit.....

Q: For photovoltaic (PV) systems the shading of the panels should be avoided, because: a. The…

A: Photovoltaic system: In this system, solar panels are connected to each other and they produce…

Q: Obtain the transfer function E,(s)/E(s) of the system shown in Figure Rz

A: The given circuit is shown below:

Q: Find V2 (volt) unit if E1=9V, E2=-5.4V, R1=4.6k2, and R2=1.9kQ. (Answer should roundof to 2 decimal…

A: In this question, Find the value of voltage V2 as shown in the circuit? Assume forward bias…

Q: 15 Q b 25 Q lab Iab _2 V= 18 VE 15 V Icb Iba 20 Ω: Ibc 10 0 Ibd a la 30 2 lac C Idc 50 Ω Icd lad 14…

Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.

Q: A balanced abc-sequence Y-connected source with Van = 100430°V is connected to a A-connected…

A: In this question, we will find phase and line currents for given star connected source and delta…

Q: Solve for the values of the following current using gaussian method. Solve for I1, I2 and I3.

Question

i need the answer quickly

27. Determine the capacitance required to establish a capaci-
tive reactance that will match that of a 2-mH coil at a fre-
quency of 50 kHz.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The opposition of a capacitor to the flow of a. c. current is called: Ca) reluctance. Ob reactance. C) resonance. d) resistance.
Regarding behavior of inductors and capacitors in circuits, select the correctstatement -a) Voltage leads current in a capacitive circuit,b) Current leads voltage by 180 degrees in a pure capacitor,c) Voltage leads current by 45 degrees in a pure inductor,d) Current leads voltage in an inductive circuit,e) Current lags voltage in a pure capacitor by 90 degrees,f) Current lags voltage by 90 degrees in a pure inductor
Q Search The following instrument readings were obtained from a DC test and an AC test performed directly on a practical inductor (RL): DC test results. Voltage applied across inductor = 24 Vdc Current through inductor = 0.8 Ade. 60 Hz AC test results. Voltage applied across inductor = 120.5 Vac Current through inductor = 1.03 Aac. 20. What is the resistance of the practical inductor? А. 10 2 В. 15 Q С. 20 Q I. D. 25 N E. 30 Q 21. What is the inductance of the practical inductor? A. 100 mH В. 200 mH C. 300 mH D. 400 mH
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
Solve for the current going through each passive component and the voltage at the capacitor.
A 10 Q resistor is placed in series with a coil of self resistance RL and inductance L and a pure capacitor 'C' across a 50 V variable Ans: 40 Q, frequency supply. The current is maximum and has value of 1 A when the frequency is 500 Hz. At this frequency, voltage across the capacitor is 300 V. Calculate (i) capacitance of the capacitor (ii) resistance and inductance of the coil (iii) Power consumed in the circuit (iv) Voltage across the resistor and the coil. 1.06 µF, 95.5 mH,50 W,10 V,302.7 V
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
27. Determine the capacitance required to establish a capaci- tive reactance that will match that of a 2-mH coil at a fre- quency of 50 kHz.
An inductor is attached to an AC voltage source. Which change will result in a halving of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequency
low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
In the compuntation of experimental time constant of an RC circuit in the charging phase, explain the reason why we should not directly plot the capacitor voltage as a function of time in solving?
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.