2. In the network shown, given ɛ = 36 V, R1 = 40, R2= 6.000 and R3=3.00n.What is the potential difference difference Vab between points a and b when theswitch S is open and when closed?R3%3DR1Calculate the current through all resistors at open and closed switch S.What happens to the current for each resistor if S is closed? Does it increase orR2decrease?

To solve above question, concepts required are: Kirchhoff's law: There are two Kirchhoff's law.KCL:…

2. In the network shown, given & = 36 V, R = 40, R2= 6.000 and R3=3.00n. What is the potential difference difference Vab between points a and b when t switch S is open and when closed? R1 R1 ww Calculate the current through all resistors at open and closed switch S. What happens to the current for each resistor if S is closed? Does it increase decrease? R2

2. In the network shown, given & = 36 V, R = 40, R2= 6.000 and R3=3.00n. What is the potential difference difference Vab between points a and b when t switch S is open and when closed? R1 R1 ww Calculate the current through all resistors at open and closed switch S. What happens to the current for each resistor if S is closed? Does it increase decrease? R2

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Similar questions

In the figure the current in resistance 6 is i = 1.43 A and the resistances are R₁ = R₂ = R3 = 1.68 2, R₂ = 15.1 Q2, R5 = 7.41 Q2, and R6 = 4.57 2. What is the emf of the ideal battery? E www R₁ O a. 25.7V O b. 52.3 V O C. 47.2 V O d. 21.4 V O e. 6.54 V R3 www R₂ www R₁ R₂ 16 R6
Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH
Which one or ones of the following statements about Kirchhoff's rules are correct? I) The junction rule is based on the law of conservation of energy. II) The loop rule is based on the law of conservation of energy. III) The number of required equations to find the unknown currents has to be as many as the number of all possible loops. O A) Il and II B) II O C) I and II O D) II O E) I
A voltage-multiplier has a Vm = 60 V peak sinusoidal secondary voltage. During the positive half-cycle, D1 conducts and D2 is cut-off, charging C1 up to what voltage level? C1 HE (A) OV B) 60 V V Ⓒ120 V (D) 180 V Vp 1:1 Vm = 60 V D1 D2 не C2 Ideal diodes C3 HE D3 D4 C4 :
Problems I A potentiometer with a uniform resistamce per unit length of track has a total resistance of 2 k2 and a supply voltage of 10 V is connected across it. The output from the potentiometer is connected across a load of resistance 5 k2 What will be the error due to this loading when the slider is at the mid-point of the potentiometer track? -2 A potentiometer with a uniform resistance per unit length of track is to have a track length of 100 mm and used with the output being measured with an instrument of resistance 10 k2. Determine the resistance
dhjdhjhdjdhjfhfjdbfejfheidadadisfdfodf,fdhjfhdfj The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhsfhfeirwdiwudwiwui
150 100 + VA- a -4V AVA -7V 81. B b Figure 2 shows a simplified model of a gas-discharge lamp. One characteristic of these lamps is that they exhibit negative resistance; in other words, as current increases the voltage drops further, making such lamps inherently unstable. As such, a current-limiting ballast is required. For the connection shown in the figure: 1. Find the equivalent Thevenin circuit of the lamp. 2. Find the ballast resistance needed to limit the current drawn from a 24-volt source to 6 amperes.
Urgent please In the circuit shown in the figure, the RL load is connected to a 20 V source when switch K is in position 1; In this position, draw the waveforms of the welding voltage, the voltage at the R end, the voltage at the L end and the current 1.
Find the potential difference between point a and point b for the situation shown below. Here ₁ = 12.0 V, E₂ = 8.77 V and R₁ = 4.13, R₂ = 5.44 , and R3 = 2.28 0. Va - Vb = R₂ V R3 R₁ W
R2 Q1 ... VCC R1 Show your complete solution. Use two decimal places for your final answer. Calculate the value of RC in ohms. at VCC=18 V, IB=26 uA, and VC=7V and B=69
V = 36 V Refer to the figure at the right. iz What is the potential of point a with respect to point b when switch S is open? 3 0 What is the current through switch S S When it is closed? What is the equivalent resistance of this combination of resistors when S is closed?
1 The NTC-type thermistor (NTC- negative thermal coefficient) has the characteristic curve shown below. F (a) (b) (c) (c) Resistance (k) 8 7- 6- 5- 4- 3- 2- I 0 10 20 30 40 50 60 70 80 90 Temperature (°C) What is the temperature when the resistance of the thermistor is 5 ks2? What is the resistance of the thermistor when the temperature is 80°C? Determine the value of the variable resistor that gives an output voltage of 3.0 V when the [Ans: 2000 £2] temperature is 80°C. Resistance = What happens to the value of the output voltage as the temperature falls and the TH variable resistor remains at a fixed value? Explain your answer.