Answered: 19 When a drop of oil is placed on the…

19 When a drop of oil is placed on the water's surface, the maximum area covered by the oil as it spreads will be only until the oil film is one molecule thick. True False 19

Chemistry & Chemical Reactivity

9th Edition

ISBN:9781133949640

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter20: Environmental Chemistry-earth's Environment, Energy, And Sustainability

Section20.2: The Aqua Sphere (water)

Problem 1RC

See similar textbooks

Related questions

Q: Giving your reasoning, rank the following dienes in order of increasing reactivity reaction. i) ii)…

Q: DNA uses RNA to get the information to the ribosomes so it can make the protein. Use the following…

A: there are complimentary base pair rule. C-G and A-T rule. But in RNA thymine is replaced by…

Q: 2. The solubility of an ionic compound IM₂X5 is 4.7 x 108 g/L and its molar mass is 356.2 g/mol.…

A: Given, The solubility of an ionic compound M2X5 is 4.7 × 10-8 g/L and the molar mass is 356.2 g/mol…

Q: The number of isomers of the complex ion [Co(en)3]³+ is 4 geometric isomers 2 optical isomers 2…

A: Here we are required to find the number of isomer .

Q: In the complex ion, [Fe(CN)6], the primary valence of Fe is +6 +2 +4 -4

A: Let 'x' be the primary valence of Fe in the complex [Fe(CN)6]4-. Total charge of the complex = - 4…

Q: 8.What is the main source of phosphate ions in our ground wate O decomposing animals decomposing…

A: (8) fertilizer (9) Soft water has low concentrations of calcium and magnesium ions. (10) Two of the…

Q: A piston has an external pressure of 14.0 atmatm. How much work has been done in joules if the…

Q: The rate of a liquid phase reaction of the type, A + B → Products; is found to be independent of…

Q: If a 0.520 ?0.520 m aqueous solution freezes at −2.80 ∘C,−2.80⁢ ∘C, what is the van't Hoff factor,…

A: • The values provided in the question are:- i) Freezing point of water (solvent), To = 0…

Q: What is the mass in grams of KBr in 0.400 L of a 0.350 M solution?

A: Given, molarity of KBr solution = 0.350 M = 0.350 mol/L Volume of the solution = 0.400 L mass (in…

Q: 2NO (g) AH 298 1 (a) + O₂(g) N₂(g) + 180 kJ mol-¹ From the equilibrium shown above, use Le…

A: Since you have asked a question with multiple sub-parts, as per our company guidelines we are…

Q: Given the H3PO4 – NaH2PO4 buffer system, which of the following is false when KOH is added into the…

A: KOH is added to the H3PO4 - NaH2PO4 buffer system. We have to tell the false statement regarding…

Q: NH₂ 1. NaNO₂, HCI 2. HBF4

A: The correct answer is given below

Q: Given & 4 trans-3-butyl-1- isopropylcyclohexane I give the most stable chair conformation of then…

A: Here we have write the most stable chair conformation of trans - 3- butyl-1-isopropylcyclohexane.

Q: . An ion has a 3+ charge, 25 electrons, and a mass number of 53. What is the symbol for this…

Q: 4.40 L of a gas is collected at 50.0 ᴼC. What will be its volume when cooled to 25 ᴼC

Q: Predict whether the entropy change of the system in each of the following is positive or negative.…

A: Given that - N2 (g, 10 atm) -----> N2 (g, 1 atm) Entropy is the randomness or disorder of…

Q: Predict charge on monoatomic ions. (a) How many protons and electrons are in a Bi³+ ion? #protons =…

Q: Consider the HCN-KCN buffer system, which species would react if a dilute aqueous HBr solution were…

A: given HCN-KCN buffer system if add HBr

Q: Chemistry Question 34 According to the balanced chemical equation in the previous problem, if the…

A: Given: The mass of NaN3 reacted = 225.0 g The number of moles of N2 formed = 4.321 mol We have to…

Q: Chemistry Balance the following reaction and construct an electrochemical cell that represents this…

Q: what is the wavelength of the HOMO- LUMO transition in this polyene dyes?

A: Fieser Kuhn rule for conjugated polyenes: λmax = 114 + 5M +n (48 -1.7n)-16.5 Rendo-10 Rexo M is…

Q: erentiate between El and E2 reactions by giving one example of each. EI E2 d) Draw the molecular…

Q: a. 1. A 1.23 M solution of CeHsONa was prepared at 25.0°C. Kb = 7.7 x 10-5 Determine whether the…

A: We have to find pOH of the solution

Q: E2 erentiate between El and E2 reactions by giving c one example of each.

A: Note: you have uploaded three different questions at same time, but we can answer only first one (as…

Q: Which of the following substances aside from diketohydrindamine is also produced from the reaction…

A: Ninhydrin is reacted with amino acid to at the end it's colour changes to pink which denotes the…

Q: P₁V₁ = P₂V₂ A gas occupies a volume of 12.5 L under a pressure of 40 mmHg. What will its volume be…

Q: . • An ion has a 3+ charge, 25 electrons, and a mass number of 53. What is the symbol for this…

Q: If the energy released by an electron making a transition from one hydrogen atom orbit to another is…

A: Given, Energy (E) = 3.02 × 10−19 J Wavelength (λ) = ? Note: planck constant (h) = 6.626 × 10-34 J.s…

Q: Predict the major organic product of the reaction. Ignore stereochemistry. Include hydrogen atoms in…

Q: 4. Using the Arrhenius equation, one can design experiments to find the activation energy, Ea. k =…

Q: NH₂ 1. NaNO₂, HCI 2. HBF4

A: Diazotization is a chemical process in which primary aromatic amine is converted into the diazonium…

Q: how to convert 598000 seconds to days

Q: Bovine serum albumin (BSA) is a biochemically useful protein. A 0.303 g0.303 g sample of bovine…

Q: Calculate the volume of Ba(OH)2 0.20 mol/L necessary to neutralize 300.0mL of H3PO4 0.30mol/L.

A: Barium hydroxide reacts with phosphoric acid to form barium phosphate and water. The equation for…

Q: Consider the following reaction: If 10.0 g of KF are used, how many grams of CaF2 can be formed?…

A: Given, Ca(NO3)2(aq) + 2KF(aq) → CaF2(s) + 2KNO3(aq) mass of KF reacts = 10.0 g mass (in grams) of…

Q: Which of the following ligands is an example of an ambidentate ligand? nitrite, NO₂ chloride, Cl…

A: A coordination compound is formed by a complex ion and a simple oppositely charged ion. In a complex…

Q: predict the conjugate base of CF3CO2H

Q: 1. 50.00ml of 2.000M ammonium nitrate is titrated with 0.800M NaOH. (a) What is the pH at the…

Q: A 50.00-ML water sample was titrated with 0.0250 M EDTA to determine its calcium content. The…

A: The question can be solved using the law of equivalence. The detailed solution is shown below.

Q: Directions: Solve and show your solution. Write the interpretation of your answer. 2.) What is the…

A: Equilibrium constant for a reversible chemical reaction is defined as the ratio of concentration of…

Q: can this be solved again?

Q: has a 3+ charge, 60 electrons, 146 neutrons. What is th

A: Answer: 1) number of proton = number of electrons+ charge = 25+3= 28 . Then symbol of this element:…

Q: NH₂ 1. NaNO₂, HCI 2. HBF4

Q: How does radioisotopes in medicine relate to the grade 12 unit of Structure and Properties of…

Q: . In a hospital an oxygen cylinder contains 423 L of pure oxygen at a pressure of 136 atm. What is…

A: In this question, we will determine the volume of oxygen gas at 1.00atm when temperature and number…

Q: The purest acetic acid is often called glacial acetic acid because it is purified by fractional…

Q: 7. How much heat is required to change 100 lbs of ice at 10°F to steam at 212°F? Assume the…

Q: NaHCO3 from label of Alka Seltzer tablet: 1916mg Data Sheet: Run #1 Run #2 Run #3 Run #4 Run #5 Run…

A: #Calculation for Run#1: The balanced equation for the formation of CO2(g) from NaHCO3(aq) and acetic…

Q: How many grams of KCl are there in 10 mL of 20% solution.

A: Given : Volume of solution = 10 ml Concentration of KCl in the solution = 20%

Question

please skip if you already answered this

19
When a drop of oil is placed on the water's surface, the maximum area covered by the oil as it spreads will be only until the oil film is one molecule thick.
True
False
19
00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Refer to Figure 11.12 to answer these questions: (a) You heat some water to 60 C in a lightweight plastic bottle and seal the top very tightly so gas cannot enter or leave the carton. What happens when the water cools? (b) If you put a few drops of liquid diethyl ether on your hand, does it evaporate completely or remain a liquid? Figure 11.12 Vapor pressure curves for diethyl ether [(C2H3)2O], ethanol (C2H5OH), and water. Each curve represents conditions of T and P of which the two phases, liquid and vapor, are in equilibrium. These compounds exist as liquids for temperatures and pressures to the left of the curve and as gases under conditions to the right of the curve. (See Appendix G for vapor pressures for water of various temperatures.)
solution is a homogeneous mixture. Can you give an example of a gaseous homogeneous mixture? A liquid homogeneous mixture? A solid homogeneous mixture?
A representation of liquid water is shown below. Which of the three representations that follow best describes the water after it has boiled into steam?
Directions Through the given situations below, answer the following questions 1 A mixture of monosodium glutamate, white sugar, salt and benzoic acid is to be melted by a group of Grade 7 students to determine the behavior of the mother during melting Predict how the mixture will look like as it is being heated. Explain your answer SUBSTANCE Sali White sugar Monosodium glutamate Benzoic acid MELTING POINT 801 C 186 C 232 C 122 C 2. Theo wants to observe what will happen to substance X (melting point is at 78 C) after heating it on an evaporating dish. After heating for a few minutes, substance X starts
What applications does water potentially have based on its chemical and physical properties?
X 26. In the question above, two liquids react together to form solid. What term is given to this process? Precipitation Effervescence O Clumping Freezing
Part C- Polarity Demonstration The results for the demonstration for polarity of various substances presented in the image below. Note that each vial has two liquid layers, water and oil. (Oil is a hydrocarbon chain.) Use this image to complete the following question. oil oil oil oil oil water water water water water With sodium chloride With iodine (dark purple solid) With copper With sulfur Blank (yellow solid) sulfate (light blue solid) (no solute) (colorless, ionic solid) Classify each of the compounds on display as a polar liquid, non-polar liquid, polar solid or non-polar solid. Saved Normal BIIU X2 X² - fr DI e Polar liquid: Polar solid: Non-polar liquid: Non-polar solid: MacBook Air
Flocculation is best described as: O A way to kill pathogens in drinking water O A way to remove dissolved chemicals from water O A way to cause suspended particles to clump and sink in water O A way of filtering large particles out of drinking water
What is the objective of water quality management? A. Control the discharge of pollutantsB. Pollutants are discharged into flowing streamsC. Selective pollutants are releasedD. Only highly toxic pollutants are released
12. A 15.00g sample of a solid substance is placed in 100.0 g of water at 25°C, and all of the solid dissolves. Then another 2.00 g of the substance is added, and all of it dissolves. A final 2.00 g is added, and none of it dissolves. a. Is the first solution saturated, unsaturated, or supersaturated? b. Is the second solution saturated, unsaturated, or supersaturated? C. What can you tell about the final solution that is in contact with the solid?
These three statements about Substances A, B, and C are true: The average kinetic energy of Substance B is higher than that of Substance A. Particles of Substance C are the least mobile. Particles of Substance A are more mobile than those of Substance C. According to these statements, what phases are the substances in? Match the phases to the substance Substance a substance b substance c 1.gas 2.solid 3.liquid