Answered: 17.) Two sinusoidal currents are given…

17.) Two sinusoidal currents are given by, i1 = 240 sin (wt + π/7) and i2 = 230 sin (wt + π/9). Calculate the phase difference between them in degrees. Your answer

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: 3. A single phase inductive load of 7500 kw has a lagging pf of 0.8. Draw the power triangle and…

A: Power Factor:- It is the ratio of real power to apparent power. It indicates utilization of power…

Q: R₂=560K HE hie= 5002 hfe= 75 hoe=5μs Find: Zin, Zout, Av Vcc=50V RC= 3,5 k it out Rel=30052 Rez=5001

A: Given

Q: An NPN Transistor has a DC base bias voltage, Vb of 10v and an input base resistor, Rb of 100kQ.…

Q: For single-sideband production in AM SSBSC, three transmitter configurations are typically used: the…

A: According to the question, we need to select the correct option. For single-sideband production in…

Q: you may be a victim [Q1] In the following circuit, use the shown node as reference, do the…

Q: An AM signal has a carrier frequency of 400 MHz and amplitude of 5 Vp. It is modulated by a…

Q: The approximate equivalent resistance between terminals A and B for the following infinite ladder…

A: Given circuit,

Q: 10) In the calculation of E and B for time-varying fields, the calculation of magnetic vector…

Q: With a PNP circuit, the most positive voltage is probably: O ground VC VBE VCC

Q: A charge of 20 units is placed 5 cm from a like charge of 3 units in mica. The force of repulsion is…

A: Given data Q1=20 Q2=3 D=0.05 m

Q: An AM transmitter antenna current is measured with no modulation and found to be 2.6 amperes. With…

Q: (₂ X(s) For the given system, find: 1- Transfer function H(s). 2- Differential equation. -2t 3-The…

Q: 1) The value of temperature at a balance bridge. 2) The output voltage signal at 0°C, 20°C, 40°C,…

A: Solution- 1) For balanced bridge, 10 k ohm10 k ohm =10 k ohmRvRv =10 k-ohm at 160°C , RV = 10kohm…

Q: 4. Sketch the output V for the given network below. + 1kQ2 +8 V -8 V 10 + Si 41

Q: Figure shows a stranded conductor identical strands each of having 7. radius r. Find the self…

A: Self GMD: this is also called as geometric mean radius. This is calculated for every phases. it does…

Q: Show whether π - x⁴, -1< x < 1 A fourier series odd or even function

A: A function is said to be even function then f(-x) = -f(x) A function is said to be odd function…

Q: 14.) True or False: A load with low power factor draws less current than a load with a high power…

A: A load with low power factor draws high current than a load with high power factor for the same…

Q: 4. An RC filter stage (R = 33 02, C = 120 µF) is used to filter a signal of 24 V dc with 2 V rms…

A: It is given that: R=33ΩC=120μFVdc=24 VVrms=2VIL=100 mA

Q: Find the net Active, Reactive and Apparent powers.

A: Active Power- It is power utilized by the load. Reactive power- It is the power which remains within…

Q: Given the block diagram below, determine the system function H(z). x[n] + y[n] a. 1+0.25z2-2 b.…

A: for calculate trasfer funtion H(z)= Y(z)/X(z) by using masson gain formula trasfer funtion…

Q: The carrier and one complete sideband are sent in this type of amplitude modulation, but only a…

Q: A carrier is modulated by three audio tones. If the modulation indexes for the tones are 0.3, 0.4,…

Q: Q3) For the given circuit, provide the following: Use the conventions covered in lecture (current…

Q: Determine the Q point of the transistor circuit shown in Figure. Given B= 200 and VBE = 0.7V. 33092…

Q: 10.23: For the following electric circuit, find Z and Y (1200+j850)2 (1500+1900) parameters? Also,…

Q: A three-phase source has a phase sequence of EAB - EBC - ECA and delivers the following delta load…

Q: Determine the z-transform of the sequence x[n] = (-)" cos(³)u[n] a. √2 1+42¹ ROC: |Z| > -1 Z + O b.…

A: In this question we need to find a z transform of the given signal.

Q: connected to an abc-sequence balanced three-phase source with e₁ = 120√2 cos(120nt + v through…

Q: An AM signal has the following characteristics: fc = 150Mhz Vm= 40V fm = 3MHz Vc = 50V What is the…

Q: An AM signal has the following characteristics: fc=150Mhz Vm= 40V fm = 3MHz Vc = 50V What is the…

A: Given, the value of carrier frequency is 150 MHz The value of the modulation voltage is 40 V The…

Q: Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the…

Q: How to calculate the discharge rate of battery? There are 2 batteries in parallel connection that…

A: It is asked to discuss how to calculate the discharge rate of a battery.

Q: Check the linearity, casualty, stability and the time variance of the following: 1. y(n) = 1/4…

A: Given systems 1. y(n) = 1/4 x(n-2) + 2 x(n-1) + x(n/2) 2. y(n) = l/nx(n+4) 3. y(n) = 0.25 x(n-1) +…

Q: What oscillator frequency is needed to heterodyne 626 kHz up to 3.58 MHz? Select your answer. 11.366…

A: In this question, We need to choose the correct options If heterodyne frequency range is given then…

Q: (1). Filters that provide the desired frequency response but have a constant time delay in the…

A: These are the few questions related to the basic functionality of filters . Depending upon the…

Q: Does maximum power transfer imply maximum efficiency of power transfer? Explain

A: In this question we will write that maximum power imply maximum efficiency or not....

Q: determine the current in each branch using Nodal Analysis

A: It is given that: Zx=100∠0°

Q: The "power cube" transformer for a portable CD player has an output of 5.7 V and 550 mA (both rms)…

A: Given, A power cube transformer has Secondary voltage, V2=5.7 V Secondary current, I2=550 mA Primary…

Q: 9.26. Draw the schematic of a four-input ECL NOR gate. 9.27. Draw the schematic of a five-input ECL…

A: Logic Gate: A logic gate is a virtual or physical device that performs a Boolean function, which is…

Q: * As BJT transistor property is that the small emitter current control the much larger collector…

Q: An iron ring elecromagnet has a relative permeability of 1250 when it is excited by a coil having…

Q: The core of a 30, 50-Hz, 11000/550-V, A-Y, 300 kVA, core-type transformer operates with a flux of…

A: In this question we will find full load high voltage phase current....

Q: An unbalanced star-connected load is supplied from a 400-V, 3-ph, Y-connected alternator through…

Q: The ideal value of modulation index is O a. equal to 1 O b. less than 1 O c. equal to 0 O d. greater…

A: Answer: a equal to one

Q: Using Nodal Analysis, solve for the values of the voltages VÃ and V. 2 A 5Ω 3Ω Va ww V₂ 4Ω 6 A 12 V…

Q: Draw the small signal equivalent circuit. Determine the following: Zo Zin Av (voltage gain) Ai…

A: The required parameters can be calculated by using the DC and AC analysis of the cascade amplifier.

Q: For the circuit shown find the maximum and * minimum values of zener diode current. IL I 5 ΚΩ www •…

Q: A balanced delta-connected load with impedance per phase of 30/30° is an abc-sequence balanced…

A: In this question we need to find a line current , load phase current and total complex power.

Q: A preselector and an amplifier stage make up the RF portion. The RF amplifier determines the…

A: RF is a radio frequency amplifier is amplifier used for the conversion of low-frequency signals to…

Q: a) An amplitude modulated (AM) signal is made up of a carrier (with constant frequency) in which its…

A: Given, An AM signal,

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

17.) Two sinusoidal currents are
given by, i1 = 240 sin (wt + π/7)
and i2= 230 sin (wt + π/9).
Calculate the phase difference
between them in degrees.
Your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re )e,=45° e,=20 Vz=10 V2=8 Figure 7 a. Va(t)=. b. V2(t)=. c. What is the rms voltage of V1 = d. What is the rms voltage of V2=_ e. What is the frequency in Hz = f. What is the angular frequency =. In terms of lagging and leading what is the exact phase relationship between V, (t) and V2(t) g.
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find The average power delivered to * .the circuit I 92 100 0 v 82 -j72 b ww
Please answer these question complete solution and readable (I'll rate it if it is complete solution) Two sinusoidal currents are given as i1= 10√2 sin wt, i2 = 20√2 sin (wt +60). Find the expression for the sum of these current.
Find the following phasors. J.1 Vt 2.1 Vz 25 13
The current through a 20 2 inductive reactance is given. What is the sinusoidal expression for the voltage? Sketch the u and i sinusoidal waveforms on the same axis. a. i = 25 x 10-³ sin 2001 b. i = 40 x 10-³ sin(wt + 60°) c. i = = -6 sin(wt - 30°) S
Two sinusoidal currents are given by the equations i₁ = 50 sin (wt +) and i₂ = 25 sin (2wt). The phase difference between them is degrees.
A sinusoid V1 =V m1 cos (at + 35") leads another sinusoid v,=V m2 sin (at + $) by 120 degrees. What is P in degrees?
18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage V= sin2t? Vs (1 + j1) Q (a) -F 4 (b) (c) (d) 1F /-
Two sinusoidal currents are given by the equations: il = 10 sin (ot + 1/3) and i2= 15 sin (oot-/4) ne phase difference between them is-degrees (b) 75 (a) 105 (c) 15 $ (d) 60
1.18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage .= sin2t? S I C (1 + j1) 2 el eareern Vs slinw
The circuit in figure 2 is operating in the sinusoidal steady state, I1=0.520 A and V1-50290° V. Use superposition to find phasor response I, L1 R2 j25 500 Ix R1 250 11 C1 V1 -j50 Figure 2