15 O 13 O 13 ㅋ Jij A Find the main efforts C ज 13 7 15

Q: Bookmark Question Challenge This Question Safety glasses are required to be worn: Owhenever there is…

A: ● Safety glasses are used for protection. ● Foreign material are unwanted material which arise due…

Q: Thermodynamics Question: Can you please reduce the first law energy balance for: Ideal gas is…

A: First law of energy Apply the following conditions to first law of energy i) isothermal compression…

Q: A pump is used to circulate hot water in a home heating system. Water enters the well-insulated pump…

A: Given: The flow rate of the water, Q = 0.42 gal/min The inlet pressure, Pi = 14.7 lbf/in² The inlet…

Q: The beam shown will be constructed from a standard steel W-shape using an allowable bending stress…

A: GIvenσb=40.4ksiP=51 kipsL1=6.6 ft=6.6×12=79.2inL2=19.8ft=19.8×12=237.6 in

Q: Refrigerant-134a is in an insulated canister with temperature 25 C. There is a partition in the…

A:

Q: Q5. As shown in the image below, two objects, A and B, are connected using the cable and pulley…

A:

Q: If the wt% Ethanol is 27% what is the specific gravity?

A: Given: weight % of Ethanol= 27% Find: Specific gravity of Ethanol Solution: To solve the problem, it…

Q: Problem 4 The block D has a weight of 400 lb. The block B has a weight of 280 lb. Find the weight of…

A:

Q: Water cooled steam condenser receives exhaust from multi-stage turbine at saturation temperature of…

A:

Q: determine magnitude of F so that resultant couple moment is 350 lb*ft counterclockwise. please show…

A:

Q: I want some explain about Force vortices acting around a point

A: Vortex flow Vortex flow can be defined as the circular motion of the fluid and all closed paths…

Q: Consider a pumping system used in a cooling water loop. Water is drawn from a tank, which maintains…

A:

Q: Q17. As shown in the image below, the football player at A throws a football C with a velocity of VA…

A:

Q: Please use maximum shear stress theory

A:

Q: Given: 9 4 = ( 3 5 ₁ 7); B = (8 1₁1 A 2 - 4 6 Find A A.BT, B.A B 3 6 -7

A: Find the value of the following i) A - B/3  ii) A.BT iii) B.A Where A and B are the matrix.

Q: Why did you not use the area for computing the overall heat transfer coefficient

A: Given question is related to Heat transfer.

Q: An 2.00 kg box is initially at rest on a ramp inclined at 23° below the horizontal. The coefficient…

A:

Q: Take that wo = 5.0 kN/m (Figure 1) Figure 500 kN-m Part A FR = Submit ON Part B. μA Replace the…

A:

Q: 4.8 Develop the control volume difference equation for one-dimensional steady conduction in a fin…

A:

Q: Find the support reactions for the simple beam below у X 750 lbs. A 4 ft. 750 lbs. 6 ft. B

A: The simply supported beam is 10 ft long and subjected to two concentrated loads. It is required to…

Q: Given the 0.063 m length of the syringe. F=1N   a. provide an equation to calculate its water flow…

A:

Q: how can i see the rest of the answers

A:

Q: A cylindrical hole is bored through a steel block, and a cylindrical piston is machined to fit into…

A:

Q: Saturated steam at 55°C is to be condensed at a rate of 10 kg/h on the outside of a 3-cm-outer-…

A: Solution: Given Data: TS=55oCm=10 kg/hd=3 cmTO=45oC   To Find: Length of the tube when the tube is:…

Q: After load P is applied to the pin-connected structure, a normal strain of = +650 μe is measured in…

A:

Q: In fig., the value of P & u, to impend slipping respectively is: 30 cm 30° W = 20 KN cyl P

A: Given data  Weight of cylinder = 20 kn Find the value of load p and coefficient of friction.

Q: a) Compression tests are generally performed on brittle materials-why? b) How a cast iron specimen…

A: (a) Compression tests are generally performed on brittle materials because brittle materials are…

Q: For the conduction of the water there is a height difference of 38 m. The results obtained from the…

A: Solution: Given Data: ∆H=38 m   To Find: Available driving load/Total available Head

Q: A simply-supported rectangular steel bar with a height of 32 mm and width of 6 mm is loaded with two…

A:

Q: With a neat sketch explain the operation of a stratified charge engine.

A:

Q: A small winch is used to raise a load W=124 lb. Find the magnitude of force P that should be appli…

A: Given,  W= 124 lb

Q: Design a knuckle joint subjected to axial tensile force of 50 kN. Determine the dimensions for the…

A:

Q: 1. Pick up 2 types of pneumatic actuator given in the lesson. Explain the actual application of the…

A: Since you  have asked two questions, as per our honor code we have to answer only first unless…

Q: Problem 3: The crank AB is rotating with a constant angular velocity of 3 rad/s about the fixed…

A: The schematic diagram of the given system is From figure, AC=600 mm AB=300 mm θ=25° Angular…

Q: The magnitude of the force F is 680 lb. Determine the moment about point O, then the scalar…

A:

Q: Referring to Figure 1,   Explain the sensor mechanism in terms of block diagram.  Indicate all…

A: Given questions : Explain the sensor mechanism in terms of block diagram.  Indicate all basic…

Q: Which is a more precise (or exact) measuring tool, the top-loading balance or the graduated…

A: Graduated cylinder is a more precise measuring tool in comparison to the top loading balance.

Q: 1. A flow rate 450 L/s (water at 20°C) is carried in a 50-cm-diameter pipeline (ductile iron-new)…

A: GivenQ=450 L/s=0.450 m3/sd=50cm=0.5mL=1.5kM=1500m

Q: Air flows into the duct of air-conditioner at 101 kPa and 10° C at a rate of 17 m³/min. The diameter…

A: Given data: P=101 kPaTi=10°CQ=17 m3/mind=23 cmQ˙=5 kW Need to determine the speed of air enters and…

Q: Q4.:Block A in Fig 2 weighs 50 N and block B weighs 35 N. The blocks are connected by a flexible…

A:

Q: Briefly discuss the following, d)  Why alignment of the specimen is is important in compression…

A:

Q: 2. It is known that the kinetics of recrystallization for some alloy obeys the Avrami equation, and…

A: Given data: n=5At t=100 min, y=0.3 Need to determine the rate of recrystallization at the given…

Q: of the plane on which these maximum values occur.   **The answer is tensile stress is 0 ksi at 90…

A: Given data  Force p = 252 kips  Area = 6 × 6 in ^2 Find the stress and angle

Q: The figure below shows a mixing tank initially containing minitial = 2000 lb of liquid water. The…

A: Given:Initial mass of water, mi=2000 lbMass flow rate from 1st inlet pipe, m1=0.8 lb/sMass flow rate…

Q: Consider a pumping system used in a cooling water loop. Water is drawn from a tank, which maintains…

A:

Q: Airplane A is flying north with a constant horizontal velocity of 496 km/h. Airplane B is flying…

A: Given data  Velocity of A = 496 km/h Velocity of B = 461 km/h Find the relative velocity of B . And…

Q: How is explaining why the PeepsTM get bigger in the vacuum chamber? What gas law is demonstrated in…

A:

Q: If the temp is 22 degrees C & the pressure is 770mm mercury , the correction to an ionization…

A: Given data as per the question Temperature =220cstandard ambient temperature =220cPressure =770…

Q: Problem Statement: A crate is initially at rest on a sloped surface, when a force is applied: F(t) =…

A:

Q: 2. A double-channel shape, 2C10 x 20 steel, Fy = 50 ksi and Fu = 70 ksi, is used for a built-up…

A: Nominal yielding strength, Pn =  Fy×A Fy =  yield strength = 50 ksi (given data) A = cross-sectional…