12:33 wamap.org A Two squirrels are sitting on the rope as shown. The squirrel at A has a weight of 1.45 lb. The squirrel at B found less food this season and has a weight of 0.95 lb. The angles and are equal to 48.50 and 58.2° respectively. Determine the tension force in each of the rope segments (T₁ in segment AC, T₂ in segment AB, and T3 in segment BD) as well as the angle a in degrees. a Note the figure may not be to scale. l5G C B сс BY NC SA 2013 Michael Swanbom

12:33 wamap.org A Two squirrels are sitting on the rope as shown. The squirrel at A has a weight of 1.45 lb. The squirrel at B found less food this season and has a weight of 0.95 lb. The angles and are equal to 48.50 and 58.2° respectively. Determine the tension force in each of the rope segments (T₁ in segment AC, T₂ in segment AB, and T3 in segment BD) as well as the angle a in degrees. a Note the figure may not be to scale. l5G C B сс BY NC SA 2013 Michael Swanbom

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.125P: The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A...

See similar textbooks

Similar questions

In Sample Problem 5.5, compute the tension TAD using one scalar equilibrium equation.
In Sample Problem 5.4, determine the tension TAC using the equation MDB=0.
The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
The uniform 18kg Bar OA is held in the position shown by a smooth pin at 0, and the cable AB which is in tension as shown. A 1.5 m 60° 00 B -1.2 m Which of the following is the correct expression for the expression for the Tensile force (T) acting at point A Select one: fthese options
4 A ski resort chair lift has towers spaced 38 m horizontaly appart. The upper tower is 15 m higher than the previous tower. If the chairs are 12 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? 1:37:01 Book The mass of each chair is 350 Kg and the height above the lower tower for each chair's attachment to the cable is 0.58537 m, 4 m, 9.4244 m. Lower Tower Cable Tension = Upper Tower Cable Tension = kN. KN.
A ski resort chair lift has towers spaced 44 m horizontaly appart. The upper tower is 15 m higher than the previous tower. If the chairs are 14 m horizontally appart and the first chair is 5 m past the lower tower what is the tension on both ends of the cable? The mass of each chair is 350 Kg and the height above the lower tower for each chair's attachment to the cable is 0.55624 m, 4 m, 9.33 m. Lower Tower Cable Tension = Upper Tower Cable Tension = KN. kN.
Calculate the following reaction forces for the A-frame shown below. Take the lengths a, b and c as 115 mm, 90 mm and 50 mm and the force P as 1.8 kN. 1. The normal reactions at A and E B A \60° 60° a 2. The pin reactions at C on CE. 2 Day 45% b E
The light boom AB is attached to a verticalwall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P= 20i - 14j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN. 2 m C. 4m 6 m Answer: Calculate the magnitude of the tension in cable BD in kN.
Example -2: Determine the tension in cables BA and BC necessary to support the 60-kg cylinder. w=mg TA Tc 45° fy co THD 60 (9.81) N TBD = 60 (9.81) N 60 (9.81) N (b)
L from Pivot 1. A uniform bar with mass M =3.25 kilograms is the top end of the bar. A cable connects to the bar as shown in the diagram. the 75.0 40.0° a. Calculate the tension in the cable required to keep tne bar in static equilibrium. Pivot preso your your answe stem right when n terr b. Calculate the force (both magnitude and direction) exerted by the pivot.
The man in the picture below has a weight (not a mass) of 600Newtons. Find the tension in all three ropes. Hint: draw two free body diagrams, one for the man, one for the "knot" where the three ropes join together. 37.0° 600 N
For the log brace shown, select the set of 3 Free Body Diagrams that would be used to solve for the tension in the rope EF given the weight of the log. Assume the ground and log are frictionless. 4 ft A 1.25 ft 25 ft 1.5 ft 3 ft G H O B 2.5 ft 1 ft ***select 3****