122 RL V, SW

Q: find I cpawer n 1A

A: Given circuit:

Q: 1 kS2 t=0 1 kN 2 kN + 20 V ( 10 μF 2 k2 '1 k2

A:

Q: The process of developing engineering devices, products, and systems that use the available resource...

A:

Q: Given a causal LTI system h(t) = e-ktu(t), where k>0, determine the zero state response of the syste...

A:  

Q: Use nodal analysis method to find V1,V2,V3 in the circuit shown

A:

Q: What are the expected readings of the following in the figure below? (R = 6.50 0, AV = 5.50 V) R. AV...

A:

Q: An armature has a resistance of 0.2 ohm at 15 degrees Celsius and the armature copper loss is to be ...

A:

Q: If the ammeter parameters due to insertion include 1200 internal resistance and a load resistance of...

A: Given, Internal resistance, Rint=120 Ω Load resistance, RL=2 kΩ Let the source voltage is V

Q: Problem 1: Determine IB, IE, I10 kN, VB, VC, and VE in the circuit. Assume Bdc = 100.

A:  

Q: EX :(9):- Consider a noiseless channel with a bandwidth of 3000 Hz transmitting a signal with two si...

A: a. The  maximum bit rate is the Nyquist bit rate and is given by the expression as shown below:  Bit...

Q: 2, Find Inverse Laplace transform for the following functions: s+7 4 a) F(s) = %3D s2 - 6s + 8 s2 + ...

A: The solution is given below 

Q: 3. The fuel-cost functions in S/h for two 800 MW thermal plants are given by F = 400 + 6.0P, + 0.004...

A: Generator- A generator is a machine that generates electricity by converting mechanical energy into ...

Q: Consider the following short circuit transformer as shown in figure below which operate at: the shor...

A: The solution is given below 

Q: Explain about the topic of DSB.LC under the topic Communication؟

A: Given: DSB-LC

Q: 39. Determine the equivalent admittance of the following, assuming an operating frequency of 1000 ra...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Consider a 3-bit ADC and full scale voltage measurement range of (0-56) The Resolution will be O 7.0...

A: Given: A ADC having, Number of bit, n = 3 Full scale voltage, VR=56 V

Q: ix 10 2 8 A 1Ω 82 VB VA PA W Vx ↑ 1 A 5Ω. Figure 1 assume the following node voltages were obtained ...

A:

Q: K_ 49. An RLC parallel circuit has an applied voltage of 208 V. R= 68 N, XL - 87 2, and Xc=16 Q. Wha...

A: Given an RLC parallel circuit has,  Applied voltage, V = 208 V Resistance, R = 68 Ω Inductive reacta...

Q: Suppose a thyristor is triggered with a suitable value of gate current. The thyristor conduction is ...

A: In this question we will write why thyristor conduction maintained even the gate current is removed....

Q: Find the equivalent inductance of the circuit shown in the figure. 0.06 H u 0.04 H 0.06 H 0.06 H u

A: Given circuit,

Q: In a Zbus building algorithm adding element between two old buses comes under O a. Type 4 modificati...

A: In a Zbus building algorithm adding element between two old buses comes under the type 4 modificatio...

Q: Find the equivalent e.m.f of the network when viewed from terminals A and B 15 12 T 24 V r=12 O 18 V...

A: Given circuit,

Q: A potential difference of 250V is applied to a field winding at 15 C and the current 5A. What will b...

A:

Q: 1. A metallic conductor has a resistivity of 18 x 100m. What is the resistance of a piece that is 30...

A:

Q: Also, express the signum function in terms of the unit step function.

A: In this case, the signum function needs to be defined and then its relation with the unit step funct...

Q: Question 2: [- Given a periodic discrete-time sequence r(n) = [2,0,0, 2] with N 4. Calculate the fol...

A: We need to find Fourier series coefficient and power for given sequence

Q: The structure of a 4-Bit Subtractor is like this (See Attachment Below). What is the structure of 4-...

A:

Q: Q1. Decode the following ASCII code: 1010011 1110100 1100101 1110110 1100101 0100000 1001010 1101111...

A:

Q: Given: 6 = 100 -6V {200N Find: a) Ays: Vo Vs Vo B. b) Ais= io is io 400N ac vollage @ each pt. indic...

A: GIVEN:   β=100 FIND: (a) AVS=V0VS          (b) Ais=i0is         (c) AC voltage at each point

Q: Draw the circuit being described below: A parallei combination of a capacitor and inductor is connec...

A: The pictorial diagram of the circuit with the given specifications is shown below:  The switch all...

Q: Find the current required by a 400 V, 10 H.P. DC motor at 73.55% efficiency.

A: Given: A DC motor having, Output power rating, Po = 10 HP = 7460 W Efficiency, η=73.55 % Input volta...

Q: -- Design half subtractor circuit using NOR gates only.

A: The solution is given below

Q: R. R3 = 302 Re= 2·5Ω %3D Ri= 25Ω 50V

A:

Q: What are electrical techniques used for failure analysis

A: The process of identifying and, in most cases, seeking to reduce the fundamental cause of a failure ...

Q: 1. How you can recognize the heathy thyristor from the faulty one? 2. Explain the temperature effect...

A: According to the Bartleby policy, I will be doing starting 3 questions only. 1. Process to recognise...

Q: 2 kQ 6 k2 6 k2 2 k2 30V 4 k2 4 k2

A: The solution is given below 

Q: Problem 1 A 240/120V, 60HZ ideal transformer is rated at 5KVA. 1) Calculate the a-ratio 2) Calculate...

A:

Q: Find the response i(t) of the RLC series circuit for t>0 R L 1 = 0 ll Vs +1

A: Case-I L=0.1H, R=5Ω, C=1640F,V=30 VApply loop after t>0 then current it30=5it+0.1ditdt+640∫-∞titd...

Q: di 3. ート 10v Rr Vo ー1o V こ。

A:

Q: A synchronous generator having no-load frequency of 51HZ and droop constant of 0.5Hz/MW is synchroni...

A: Given a synchronous generator having, No load frequency, fnl=51 Hz Drop constant = 0.5 Hz/MW Slope =...

Q: 6µF 6µF 6µF 4µF 4µF 6µF 6µF 6µF 6uF

A: The solution is given below 

Q: Write down at least three reasons which cause difference between R1 (R2) and R = Vmes/imes values in...

A: The reason behind the difference measured value of resistance and calculated value of resistance are...

Q: Find Rab 20 2 ww- 50 a www ww 18Ω 20 Ω Rab 12 9Ω www ww

A:

Q: SA 32 BA 40

A:

Q: What are the advantages & disadvantages of this type of amplifiers?

A: During the AC analysis, the VCC will be connected to ground so the circuit will act as common collec...

Q: 1. Determine whether each silicon diode below figures is forward-biased or reverse- biased. 2. Deter...

A: Brief description : Diode is a unidirectional device which will allow current to pass only in one di...

Q: Is 12N RL + Vs SW1

A: The solution is given below 

Q: For the given parallel circuit shown in Fig.1 below, the applied voltage v = 100sin 5000t. Determine...

A: In this question,  We need to determine the current i1, i2 and total current iT  as shown in the cir...

Q: 51. Define three clockwise mesh currents for the circuit of Fig. 4.78 2, and employ the supermesh te...

A:

Q: 47 kN 220 k. 10 k2 +Vcc +Vc 33 kN 1 kΩ V 51 -Vcc -Vc V32 Both voltage sources are at 1 V. -What is t...

A:

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.