120 * 8F what is the T?' b. what is the voitage capactor apter 10 sec? c. How many a. time constants will it toake for tue Vo itage to reach 8o v.? how

Q: When the series combination of R1 and R2 is connected across a 30 V battery, the current drawn is 10...

A: Given

Q: R

A:

Q: Find the width of the depletion layer in a germanium junction diode which has the following specific...

A:

Q: 1. A 1Ø, 2 wire distribution line, 1280m long has an impedance per conductor per km of 1+j2.52. The ...

A:

Q: Transform the vectors F 10 a, to spherical coordinates at (4, 110°, 120°)

A:

Q: 1. For the following truth table: A B CDG a. [2] Write the equation for G for the canonical SOP form...

A:

Q: A resistance of 10 Q and a capacitance of 100 µF is connected in series to the parallel combination ...

A:

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: EQUIVALENT RESISTANCE    Equivalent resistance is the sum of the resistance  connected either in ser...

Q: 7. Refer to the graphics appendix. What is the total resistance of the circuit? 1500 Ohms 400 Ohms 3...

A:

Q: A CE amplifier uses a BJT with ß = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 ...

A:

Q: It is the ratio of the units of electricity generated per year to the capacity of the plant installe...

A: The ratio of the units of electricity generated per year to the capacity of the plant installed in t...

Q: A nonmagnetic medium has an intrinsic impedance of 250∠30 Ω. Find a) Loss tangent b) Dielectric cons...

A: Given, Non magnetic medium has  Intrinsic impedance η=250∠30° ΩFrequency f=1 MHz

Q: Determine the values of the node voltages of the circuit shown. 5 V 20 Ω U2 12 2 U3 U1 U4 (1)1.25 A ...

A:

Q: An electrodynamometer type wattmeter is used to measure power in 1-o circuit. The connected load dra...

A: The solution is given below 

Q: Region 1 (y 0) contains dielectric medium with ɛ2

A: Region 1 (y<0) contains the dielectric medium with ε1=5ε0 and μ1=1.5μ0. While region 2 (y>0) c...

Q: A 4-pole, wave-wound, 750 rpm shunt generator has field resistances of 0.4 ohm and 200 ohms, respect...

A: The solution is given below 

Q: Doe Do Dor Do Vị V3 Figure 2: Simulating delays with inverters. Let each inverter have delay A, then...

A: Given the logic circuit as shown below: We need to construct this circuit using the MUX circuit. We...

Q: The voltages va, Vb, and ve in below Figure are the node voltages corresponding to nodes a, b, and c...

A:

Q: A 10-k of 2.0 A when delivering rated output. Find the armature resistance A 5.75-kW 115-V separatel...

A:

Q: 152 30Ω A 45V(E 30Ω 302 (1) 0.6 A (2) 0.75 A (3) 1 A (4) 1.2 A (5) 2.4 A (6) 6 A (7) none of the abo...

A:

Q: at is the minimum requirement of the power supply if the transmitter requires 17.3 volts? Answer to ...

A: To answer is question

Q: Use spherical coordinates to find the volume of a hemispherical shell of inner radius 2.00 m and out...

A: Brief description:  In electromagnetic theory we have three type of coordinate systems such as  Car...

Q: For this class AB amplifier with an output resistance of 5 Ohms and quiescent collector current of 2...

A: Given -  Output resistance = 5 Ohms Quiescent collector current = 2.5 mA

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm? at temperature of 0°C...

A: (1) It is given that: L=15.6 mA=12 mm2=12×10-6 m2V=240 VI0=7.9 A  (At 0°C)        

Q: 3. Given the series circuit, solve for the 1.2 0 a. Total resistance 12 V 0.2 0 b. Current of each r...

A:

Q: Discuss the importance of Nyquist plot technique in control systems.

A: Brief description: In the given question they want to know the importance of the nyquist plot techni...

Q: 100 kN 15 V = 10 V 56 kN RL (©) figure also for Norton's theorem

A:

Q: Region 1 (y 0) contains dielectric medium with e, = 6 to and uz = 2.75 Ho- Draw a figure which defi...

A: "According to the Company's policy, we will solve only the first part of the question since the seco...

Q: T (s) = s+2 s2+9

A: "As per our guidelines, we are supposed to answer only three subparts. Kindly repost the other subpa...

Q: (b) Explain the steps involved in analysing balanced bolted fault in power system using Zbus method,...

A: Admittance matrix and impedence matrix is very important to analyze the power system .Admittance mat...

Q: Problem 1: Thermal units with Non-Linear Convex fuel cost function (Lagrange Function) Assuming two ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 2 A signal consists of a fundamental frequency of 500 Hz, and the lowest five harmonics: 1000 Hz, 15...

A: A signal consists of a fundamental frequency of 500 Hz and the lowest five harmonics: 1000 Hz, 1500 ...

Q: 4. Given the parallel circuit, solve for the a. Total resistance 12 VE 1.2 03 0.6 0 0.4 0g b. Curren...

A: Brief description : Resistor is an electrical element which is used to limit the amount of current f...

Q: What is the value of Vgs, when Id is.10 ?constant reference voltage Vdd =12V @

A: For a circuit, The reference voltage is 12V. and The drain current is constant.

Q: α 2 V 2Ω 2Ω 2 A

A:

Q: State the frequency of the 7th harmonic of a 2KHZ sine wave? O i) 14Khz O ii) 9KHZ O ) 5KHZ O iv) 2K...

A: Given: A sine wave with Fundamental frequency, f=2 kHz Harmonic is 7th.  

Q: 2: Calculate the thermal equilibrium electron ncentration in silicon at T=300K for the case ergy lev...

A:

Q: 5. Trace and discuss the power train of a four-wheel tractor and power tillers. Discuss how power is...

A: due to rules i can answer only one question at a time. so am answering the 5th question. please uplo...

Q: Q2\ It is required to use a diodes specified to have a 0.9V drop at a current of 1 mA. The diodes ar...

A: The circuit is as shown below, Forward drop of the diodes is given to be 0.9 Volts. RL = 1.9 kΩ So ...

Q: Sketch the output waveform. Show your complete analysis. 1. Vigat R E CITY RSI" IN 2.

A:

Q: Given the following Resistances in Series and Voltage Source: R1 = 8 ohms R2 = 5 ohms R3 = 8 ohms...

A: If resistances R1,R2,R3 are in series then their equivalent resistance is sum of the three resistors...

Q: 4. Use the circuit shown in Figure P4.4 to find the indicated quantities. a) Find the power delivere...

A:  

Q: 2. Refer to the graphics appendix. What current is most near the current through R2? .200 A .046 A ....

A:

Q: 8. Refer to the graphics appendix. What is the current flow through R3? 23.3 mA 21.85 mA 8.75 mA 71....

A:

Q: Which of the folowing statement is true? The bigg er the AWG number the smaller the cros s section o...

A: The solution is given below 

Q: A certain shunt motor armature has a resistance of 0.07 2 and current of 50 Amperes at 120 Volts. De...

A:

Q: A 25 kVA, 220V, 3φ alternator delivers rated kVA at a power factor of 0.84. The effective ac resista...

A: Pout= 250.84 = 21KWI0 =250003×220=65.61ARa =Rt2=0.182=0.09 ohmLosses:-a) armature winding-   Pa = 3I...

Q: (t) is defined by the convolution g(t) = 5II(t/2) * [8(t +1) + 8(t)] ere II(t) and d(t) are the unit...

A:

Q: A 25-volt electromotive force is applied to an LR series circuit in which the inductance is 0.5 henr...

A: For First order RL circuit with source enabled The calculations are straight forward The response of...

Q: A simple network of RLC circuit is depicted in Figure 1. (i) Derive the differential equations of th...

A: Solve the problem