Answered: 11. Forty gal/min of a hydrocarbon fuel…

11. Forty gal/min of a hydrocarbon fuel having a specific gravity of 0.91 flows into a tank truck with a load limit of 40,000 lb of fuel. How long will it take to fill the tank in the truck?

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter3: Basic Theories And Math

Section: Chapter Questions

Problem 9RQ: Describe the effect of pressure on an enclosed volume of a gas.

See similar textbooks

Related questions

Q: Compressed liquid

A: Given Data: The pressure of liquid water at the inlet of the steam generator is, P1=10 MPa. The…

Q: 9. Liquid benzene at 20°C is to be pumped from a storage tank to a chemical reactor through 165 ft…

A: Given: The length of pipe 1, L1 = 165 ft The diameter of pipe 1, d1 = 2 in The length of pipe 2, L2…

Q: Why is compressed air supplied to the sewage treatment plant on board? What is its importance and…

A: Compressed air is used during treatment of sewage treatment plant. It is due to the reason that…

Q: Give a concise introduction on Self pressurizing reservoirs

A: Self pressurizing reservoirs :-

Q: a. The static pressure on the pipe wall b. The dynamic pressure c. The stagnation pressure

Q: Khachik's truck has 76-L fuel tank and a fuel efficiency rating of 11.8 L /100 km. How far can his…

A: we have to calculate how far will the truck travel.

Q: nozzles diameter in cm.

A: d=2r=0.764cm

Q: 250 degrees saturated steam enters a steam coil. The steam is condensed in the coil, leaving as a…

Q: the molar percentage of N2

A: Given; Assuming complete combustion of methane,Determine the molar percenatge of N2 in the products…

Q: Problem 12.4 solve the given problem: A 2-compartment vessel contains fluid in each section. For the…

Q: Give a concise introduction on Douglass pressurized reservoirs.

A: DOUGLASS PRESSURIZED RESERVOIR :- Douglass pressurized reservoir is a tank which has immense…

Q: When fluid flows through an orifice, the greater pressure is in the (inlet/outlet) part of the…

A: Concept: Water flow through orifice 1.When the water flow through an orifice (smaller diameter) ,the…

Q: ..Equation for Law of conservation of mass and energy for a nozzle

A: Law of conservation of mass (For nozzle) The mass is conserved during the process, the mass of fluid…

Q: Calculate the density, specific weight, and the weight of one litre of fuel with a specific gravity…

A: Specific gravity = 0.82 Density of water = 1000 kg/m³( reference fluid) Specific gravity = (density…

Q: A flexible tube peristaltic pump operates at 100 rpm, with a lobe volume of approximately 3 ml. What…

Q: A cylindrical tank is filled with water at the rate of 5,000 gal/min. The height of water in the…

A: Given data: Q=5000 gal/mint=15 minh=20.42 ft Need to determine the diameter of the tank.

Q: A certain fluid has a specific gravity of 1.25 flows through a 150 mm diameter pipe with mean…

Q: What is the ratio of a jet fuel load of 286 gal. to one of 2546 lbs?

Q: 6. Which Pump is preferred for flood control and irrigation applications and why?

Q: 5. The fuel tank of a large truck measures 1.2m x 0.9m x 0.6m. If it takes 12 min. to fill the tank…

A: Given, Dimensions,V=1.2m×0.9m×0.6mTime taken to fill fuel pump,t=12minRealtive density of the…

Q: A worker in a children's playground is cleaning a slide with a hose. She observes that a horizontal…

Q: A water pump increases the water pressure from 10psia to 50psia. On your procedure sheet, check that…

A: Given: Initial pressure→Pi=10 psia Final pressure→Pf=50 psia So difference of…

Q: 3) A large tonk initially contains 200 gallons of brine in ur/e 15 lbs. 0f salt is dissolved.…

Q: With the aid of illustration, discuss the operation of a fuel meter.

Q: f a 1/3 horsepower pump runs for 20 hrs. What is the energy used in MJ?

A: 1hp =746 W Power in hp =1/3 hp Power in Watt=746(1/3)=248.67 J time to consume, t=20 hr…

Q: C) What is the maximum possible mass flow rate that the pump can produce?

Q: PROBLEM 8. The total weight of space shuttle including its payload mass and the empty external tank,…

A: Given data The total weight of space mo = 428,100 lb. The external tank and the two solid rocket…

Q: A fuel line is to convey octane over a distance of 35 ft. The required flow rate is 0.3 ft3/s and…

A: Given data: L=35 ft=10.668 mQ=0.3 ft3/s=0.00849505 m3/s∆P=75 kPaf=0.002 Need to determine the size…

Q: 02.Comlete the following Table for R134a

A: Using Property table of R-134a and P-h chart the required data is tabulated below.

Q: Analyse the effect on the pressure of gasoline pipeline if mercury is replaced with water.

A: Given :- Effect on the pressure of gasoline pipeline if Mercury is replaced with water

Q: Low fuel pump pressure causes a _____ mixture and excessive pressure causes a _____ mixture.

A: Given Low fuel pump pressure causes a _____ mixture and excessive pressure causes a _____ mixture.

Q: Consider a diesel electric plant which consumes a thousand liters of fuel with 20 degree API at 200K…

A: Given data: V˙=1000 L/day Need to determine the fuel rate in kg/min.

Q: How long (in minutes) can a 75.0 US gallon receiver supply 8.5 SCFM of compressed air if the…

Q: m3 /second is SI the unit of a. Pressure b. Discharge c. Velocity

A: A discharge is a measurable quantity of any fluid flow over unit time. Mathematically, discharge is…

Q: Two types of pumps

Q: An engine has a shaft horsepower of 290 hp and its fuel weighs 185 lbs. Compute for the specific…

Q: 7. An automobile tire contains 3730 cu in. of air at 32 psig and 80°F. (a) What mass of air is in…

Q: 5. A diesel fuel tank has been filled with gasoline and runs until it quits. Which of the following…

A: When the diesel tank is filled with the gasoline then the combustion process becomes abnormal It…

Q: 1lmu: rate a two-stage

A: introduction: Two-stage cooling refers to an air conditioner or heat pump that has two operating…

Q: How much should you charge to wash alI the windows in Seattle?

A: How much should you charge to wash all the windows in seattle? Assumptions Seattle consists of…

Q: Because of a break in a buried oil storage tank, ground water has leaked into the tank to the depth…

Q: mass flow rate of the liquid

A: Given data; Blade outer radius,r=50 mm It consumes power,P= kWN= 3000 rpm Determine mass flow rate…

Q: What is the energy produced in MW per month of fuel

A: To determine Energy produced/month

Q: How to steam flow control in Hydroelectric Plants

A: A hydroelectric plant is operated by Water. There is not steam in hydroelectric plant. Steam is…

Q: A diesel power plant provides power for Meralco in 20 hrs per day of operation. The industrial fuel…

A: Given DataConsumption per day V=3500 L/day=3.5m3/dayT=20hrs/dayAPI=40°

Q: As more heat is transferred, part of the saturated liquid vaporizes (saturated liquid–vapor…

A: If we supply more heat in Saturated liquid-vapor mixture, the steam becomes superheated

Q: The net power imput

Concept explainers

Thermodynamic Relations

Thermodynamics is the division of physics that deals with the transfer of any kind of energy, whether it be heat, temperature, or work, from one object to another.

Question

11. Forty gal/min of a hydrocarbon fuel having a specific gravity of 0.91
flows into a tank truck with a load limit of 40,000 lb of fuel. How long will
it take to fill the tank in the truck?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the ratio of a jet fuel load of 286 gal. to one of 2546 lbs?
16.A motorist equips his automobile tires with a relief-type valve so that the pressure inside the tire never will exceed 240 kPa (gage). He starts a trip with a pressure of 200 kPa (gage) and a temperature of 23°C in the tires. During the long drive, the temperature of the air in the tires reaches 83°C. Each tire contains 0.11 kg of air. Determine: a. The mass of air escaping each tire. b. The pressure of the tire when the temperature returns to 23°C.
11. A tank contains 1000L of brine with 15kg of dissolved salt. Pure water enters the tank at a rate of 10L/min. The solution is kept thoroughly mixed and drains from the tank at the same rate. How much salt is in the tank after 20 minutes?
Engineering Utilities Please answer in paragraph form. UPVOTE will be given. Discuss/Explain the principle of compressed air system.
Describe the effect of pressure on an enclosed volume of a gas.
Problem 12.4 solve the given problem: A 2-compartment vessel contains fluid in each section. For the first compartment, the fluid density is 1254 kg/m^3 and the second is 611.9kg/m^3. The partition is removed, allowing the liquids to mix. Determine the specific gravity of the mixture if the fluid masses are equal.
The pressure ratio during the constant volume portion of combustion in a Dual Combustion engine is 1.89 . If the pressure at the end of the constant volume addition of heat is 4.49 , what is the pressure at the beginning?
SG of Water=1.0 SG of Mercury=13.6 SG of n-Octane=0.65
Q2) briefly explain using appropriate sketches three methods used for removing moisture from compressed air. (air driers)
How long (in minutes) can a 75.0 US gallon receiver supply 8.5 SCFM of compressed air if the compressor is running and supplying 4.0 SCFM of compressed air? Cut-in pressure is 80.0 psig and cut-out pressure is 125.0 psig. Pls fast hand written solution
c. A lorry is carrying 4000 liters of water. It is driven from Kota Kinabalu to Mesilau and it was discovered that the tank was only half full on arrival. The driver started with a full tank, climbed at a steady rate, and accomplished the 1000 meters elevation change in 3 hours. If the water leaked at a steady rate, compute how much work was spent to carry water to the top? Do not count the work done by the driver and the lorry to get there. Water weighs 9.8 N/liter.
If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7 s O b. 0.0233 min O c. 0.7 min O d. 1.4 min