10. For a 10 Mbps data link using 12,000-bit frames, and assuming that electrical signals propagate at 2.5 x 108 m/s: a. How long does it take to introduce a single frame onto the link? b. How long does it take for the trailing edge of the frame to travel 1,620 km? c. What is the total transmission time of this frame, from start to finish?

10. For a 10 Mbps data link using 12,000-bit frames, and assuming that electrical signals propagate at 2.5 x 108 m/s: a. How long does it take to introduce a single frame onto the link? b. How long does it take for the trailing edge of the frame to travel 1,620 km? c. What is the total transmission time of this frame, from start to finish?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 27VE

See similar textbooks

Similar questions

Given a transmission rate of 1 Gbps and a propagation speed of 200m / μ sec , how many meters of cable are needed for a full duplex transmission link to have a minimum capacity of 1500 bytes?
Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data frames carry a useful payload of size 12,000 bits. Assume that both ACK and data frames have 320 bits of header information, and that ACK frames carry no data. What is the effective data throughput When using Stop and Wait?
2. A path in a digital circuit-switched network has a data rate of 1 Mbps. The exchange of 1000 bits is required for the setup and teardown phases. The distance between two parties is 5000 km. Answer the following questions if the propagation speed is 2 X 10° m: a. What is the total delay if 1000 bits of data are exchanged during the data transfer phase? b. What is the total delay if 100,000 bits of data are exchanged during the data transfer phase? c. What is the total delay if 1,000,000 bits of data are exchanged during the data transfer phase? d. Find the delay per 1000 bits of data for each of the above cases and compare them. What can you infer?
Suppose a 128-kbps point-to-point link is set up between the Earth and a rover on Mars. The distance from the Earth to Mars (when they are closest together) is approximately 55 Gm, and data travels over the link at the speed of light-3 × 108 m/s. (a) Calculate the minimum RTT for the link. X (b) Calculate the delay x bandwidth product for the link. (c) A camera on the rover takes pictures of its surroundings and sends these to Earth. How quickly after a picture is taken can it reach Mission Control on Earth? Assume that each image is 5 Mb in size.
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the shortest time possible (in seconds) to transmit a 1 Mbyte file over the given link?
Suppose there is a b+n (Sum of first and last digit of your Reg#) Mbps microwave link between a geostationary satellite and its base station on Earth. Every minute the satellite takes a digital photo and sends it to the base station. Assume a propagation speed of 2.4*108 meters/sec. 1. What is the propagation delay of the link? 2. What is the bandwidth-delay product?
4. Satellite Transmission. Suppose there is a 12 Mbps microwave link between a geostationary satellite and its base station on earth (the distance between the two is 36,000 km). Every minute the satellite takes a digital photo and sends it back to the base station. Assume a propagation speed of 2.5 x 10³ m/sec. a. What is the propagation delay, dprop, of the link (in seconds)? b. What is the bandwidth delay product, R x dprop? c. Let X denote the size of the photo. What is the minimum value of X, in bits, for the microwave link to be continuously transmitting?
Assume that, in a Stop-and-Wait system, the length of the line is 10 Km, the volume of the pipe is 5Kbytes, and 1 bit takes 40 milliseconds to make a round trip. What is the bandwidth of the line?
Suppose that the spectrum of a channel is 2 MHz, and an intended capacity is of 8 Mbps, then the SNR is .............. in order to obtain this capacity 8 04 O 15 O 17 O 16
Suppose that data are stored on 8.54-gbyte single-sided, double-layer dvds that weigh 15 g each. suppose that an eurostar rail service train, london to paris via chunnel, carries 10 4 kg of these dvds. the great circle distance of the line is 640 km and the traveling time is 2 hours, 15 minutes. what is the data transmission rate in bits per second of this system?
Suppose a 128-Kbps point-to-point link is set up between Earth and a rover on Mars. The distance from Earth to Mars (when they are closest together) is approx- imately 55 Gm, and data travels over the link at the speed of light-3 × 108 m/s. (a) Calculate the minimum RTT for the link. (b) Calculate the delay x bandwidth product for the link. (c) A camera on the rover takes pictures of its surroundings and sends these to Earth. How quickly after a picture is taken can it reach Mission Control on Earth? Assume that each image is 5 Mb in size.
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. Assuming it is possible to combine several circuits, how many circuits does it take to keep the transmission time of a 1 Mbyte file below 15 seconds?