10.) An ideal gas with goes thru the quasistatic cycle shown to the right. The Pabs(atm) steps are: A. Isothermal expansion from state 1 to state 2. B. Constant pressure compression from 2 to 3. C. Constant volume increase in pressure from 3 7.00 back to 1. a) Find the net change in internal energy of the gas for the complete cycle. b) Find the net heat exchanged by the gas with its surroundings. Is this heat into or out of the gas? c) Find the net work done by the gas for the complete cycle. Hint: Remember Q = nCvAT(const. volume) & Q = nCpAT(const. Pressure) 3.11 3: В V(L) 4.00 9.00

10.) An ideal gas with goes thru the quasistatic cycle shown to the right. The Pabs(atm) steps are: A. Isothermal expansion from state 1 to state 2. B. Constant pressure compression from 2 to 3. C. Constant volume increase in pressure from 3 7.00 back to 1. a) Find the net change in internal energy of the gas for the complete cycle. b) Find the net heat exchanged by the gas with its surroundings. Is this heat into or out of the gas? c) Find the net work done by the gas for the complete cycle. Hint: Remember Q = nCvAT(const. volume) & Q = nCpAT(const. Pressure) 3.11 3: В V(L) 4.00 9.00

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. The working substance for a Carnot cycle is 8 Ib, of air. The volume at the beginning of isothermal expansion is 9 ftand the pressure is 300 psia. The ratio of expansion during the addition of heat is 2 and the temperature of the cold body is 90 °F. Find: a) Q, and Qr (BTU), b) V, and Ps, c) V, and P4, d) mean effective pressure (psia).
Use the given values Air as an ideal gas flows through the turbine and heat exchanger arrangement. Steady-state data are given on the figure and on the table. Stray heat transfer and kinetic and potential energy effects can be ignored. a) Determine the power developed, ? ̇ in Turbine 2 Find the rates of entropy production, ?̇ each in kW/K, for b) Turbine 1 and c) Heat exchanger d) Which component contributes more to inefficient operation of the overall system? How do you know?
(17 blanks) Calculate the efficiency of the Carnot Engine for ideal gas. Consider the figure below for a complete cycle of Carnot engine, where the cycle goes from ad->ab->bc->cd Carnot cycle Он TH Tc - V 02016 Pearson Education, Inc. processes: processes and segment ab & cd are the Where segments ad & bc are the and the volumes involved are Va, Vb, Vc, Vd, and the two temperatures TC and
SU-2 A gas at 500K is in a cylinder with a frictionless piston. The gas goes thru a reversible cycle during which it absorbs 400J from a reservoir at 500K. During part of the cycle the gas rejects heat Q to a reseroir at 300K. Let the system be defined as the gas. a) What is the change in entropy for the system for one cycle of operation of the engine? Briefly explain your answer. b) Find the change in entropy for the universe for one cycle of operation of the engine. Briefly explain your answer. c) Find the change in entropy for the surroundings for one cycle of operation of the engine. Briefly explain your answer. d) Use your results from the previous parts to find how many joules of heat were rejected to the 300K reservoir during this process.
1. In a steam power cycle, steam enters the turbine at 30bar with the following different conditions and leaves at 1bar. Calculate Carnot efficiency, Rankine efficiency, condenser heat flow in kW assuming mass flow rate of steam as 9.5kg/s and steam rate for each case considering the pump work. Using mollier diagram (ii)Wet with 0.95 dryness
Q.17 The given figure shows an open-cycle gas turbine employing reheating, on T-s plane. Assuming that the specific heats are same for both air and gas, and neglecting the increase in mass flow due to addition of. fuel, the efliciency is T. 1000 K 3. 800 K. G00 K 500 K 450 K- 9. 300 K %24
In a Rankine cycle ,saturated liquid water at 0.80 bar is compressed isentropically to 170 bar . First by heating in a boiler ,and then by superheating at constant pressure of 150 bar ,the water substance is brought to 700 K . After adiabatic reversible expansion in a turbine to 0.80 bar ,it is then cooled in a condenser to saturated liquid . Find the following : A.) Quality after turbine expansion B.) Turbine work C.) Heat added in the boiler D.) Heat rejected from the condenser E.) Pump work F.) Net work G.) Cycle efficiency
Problem3: At the beginning of the compression process of an air standard Otto cycle, p-1 bar, T 300 K. The maximum temperature in the cycle is 2250 K and the compression ratio is 9.8. The engine has 4 cylinders and an engine displacement of Vg-2.2 L. Determine per cylinder: a) the volume at state 1. b) the air masS per cycle. c) the heat addition per cycle, in kJ. d) the heat rejection per cycle, in kJ. e) the net work per cycle, in kJ. f) the thermal efficiency. g) the mean effective pressure, in bar. h) Develop a full exergy accounting per cycle, in kJ. Let To- 300 K. po = 1 bar. i) Devise and evaluate the exergetic efficiency for the cycle.
Find the following: a.Steam temperature in degree celsius b.entropy of steam at the turbine in exit in kJ/kg c. Entropy of saturated liquid at condenser temperature in kJ/kg d. Sfg in kJ/kgK at condenser temperature. e.hf at condenser temperature f. hfg at the condenser temperature g. Specific volume of the condensate h. Quality of the steam at the turbine exit
2) Find the heat supplied, in kJ per kg of air circulation. 3) Find the percent thermal efficiency of the cycle, neglecting the mass of fuel.
In a gas turbine plant working on air standard Brayton cycle, the air at inlet is at 27°C temperature ,0.1 MPa pressure respectively.The pressure is 6.25 and maximum temperature is 800° C the turbine and compressor efficiencies are each 80%. Find per kg of air; i) The compressor work ii)The turbine work iii) The cycle efficiency iv) The turbine exhaust temperature
1. In a steam power cycle, steam enters the turbine at 30bar with the following different conditions and leaves at 1bar. Calculate Carnot efficiency, Rankine efficiency, condenser heat flow in kW assuming mass flow rate of steam as 9.5kg/s and steam rate for each case considering the pump work. (ii)Wet with 0.95 dryness (iii) Superheat at 550°C