Answered: 1. What is the total wetted area of a…

1. What is the total wetted area of a trapezoidal section of depth y base B and side slope Z? y 1 a) Z(B+Zy) b) у(В+Zy) c) Zy² d) Zy

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Tollowing Formation width Depth of cut at the midpoint of formation Transverse slope on the right…

Q: and the side slope is 1H:2V, calculate the wetted perimeter. a) 17.41m

A: To find : Wetted perimeter.

Q: Q2: A road embankment is 8 m wide and 200 m in length at the formation level, with a side slope of…

A: Embankment : An embankment is a volume of earthen material that is put and compacted to raise the…

Q: A very wide rectangular concrete channel (n =0.013) carries 12m3/s per unit width of water. The bed…

A: Concrete channels are Cast with a smooth, class A finish, precast concrete channels are easier to…

Q: 1. A partially open sluice gate in a 5-m-wide rectangular channel carries water at 10 m/s. The…

A: Given y1 = 2.5 m Q= 10m3/s b= 5 m

Q: 3. What is the top width of a trapezoidal channel having depth y, side slope Z and base B? a) 2Zy b)…

A: This question is related to the open channel flow from Fluid Mechanics. In This question we…

Q: d two times as large for the overflow section. Use the slope=0.00030 for both. Determine the…

A: data given Main channel as trapezoidal section with [2V:1H] depth of flow = 3.60 m Base width = 12m…

Q: A trapezoidal channel has a bottom width of 75 ft and side slopes of 4:1 (4 horizontal and 1…

A: Solved 3 subparts as per guidelines

Q: 1. What is the wetted area for a triangular channel having depth y and the side slope being Z? a)…

A: The wetter area for a triangular channel having depth y and the side slope being Z

Q: 15.3 A trench is to be excavated in a clay soil with y sat 20 kN/m³ and s, = 15 kPa. (a) Determine…

Q: 14. An embankment is made on a ground having a transverse slope of 1 in 10. The width of the bank at…

Q: Question 26 A cut is to be made in a saturated clay, as shown in the figure below. The cut slope…

Q: 1. Water is flowing through a concrete rectangular channel at a rate of 0.5 m'/s. If the manning's…

A: As per our guideline we are supposed to answer only 1 question. Kindly repost other questions as a…

Q: A canal slope of 5 m height is made up of soil which has C = 50 kPa, o = 10°, Y,at = 20 kN/m3. If Y…

Q: H.W. 4 For a triangular channel having a side slope of Z horizontal: 1 vertical, Prove that: 20 Y. =…

A: The given data is shown below: Side slope=Z horizontal:1 vertical

Q: A trapezoidal channel is to be designed to carry 280m3/minute of water. Determine the cross –…

Q: 2. Estimate the wetted perimeter of a trapezoidal section of depth y, base B and side slope Z. 2) RI…

A: To find : Wetted perimeter.

Q: If the median size of bed material of a natural channel is 2 mm, then the Manning's n for the…

A: Size of bed material d=2mm

Q: Determine the section factor (Z) of a triangular channel with right angle corner (900) with a depth…

Q: From the following cross-s end-area method, the roa slope for both cut and fill i 5.04

Q: 14.6 A 40-in. conduit carries a discharge of 25 cfs. Determine the critical depth using the geo-…

Q: 7. A rectangular channel has depth y and top with B. Determine its section factor. 32

A: To find : Section factor

Q: Lw Trapezoidal section Q = 120 m³/s %3D S = 12 cm/km, Side slope 2 : 1, n= 0.0182 Compare the…

A: The most economical section of a trapezoidal channel is one which has hydraulic mean depth equal to…

Q: 2 and the side slope is1/2. Calculate the wetted perimeter of the channel section if the wetted is…

A: To find : Wetted perimeter.

Q: 1. What is the total wetted area of a trapezoidal section of depth y base B and side slope Z? I 1 a)…

A: This question is related to the Open channel flow from Fluid Mechanics. In this question we…

Q: A rectangular channel 4.82 m. wide by 1.33 m. deep is lined with a smooth stone (n = 0.014), well…

A: Find Flow…

Q: 91:50, calculate the depth of the channel if the bed slope is 1 in 3000 and C = 50.

A: To find : Ratio between maximum discharge and top width.

Q: 8. The top width of a triangular channel section is 4m and the depth of the section is 8m, calculate…

Q: 1. Calculate the normal depth in a concrete trapezoidal channel with side slope of 1 to 3, a bed…

A: Using the Mannings equation to calculate the depth of flow through the trapezoidal channel section,…

Q: Determine hydraulic radius Wetted area=25 m2 Wetted perimeter3D15 m

Q: 3. Calculate the wetted perimeter of a triangular section having a depth of 4m the side slope…

Q: PROBLEM 3 GIVEN THE CROSS SECTION NOTES OF AN EARTHWORK BETWEEN STA. 2+300 TO 2+450. ASSUME BOTH…

Q: 6. Calculate the wetted perimeter of a triangular channel section having a depth of 5m and the side…

Q: 9. Calculate the top width of a trapezoidal channel section having a side slope1H:4V, base of 5m and…

Q: Find the required slope of a rectangular open channel when the water flows at a rate of 20,000 L/s,…

A: Given data :- Type of channel = Rectangular channel Base width (B) = 4 m Depth of flow (y) = 2.5…

Q: Red line in confined aquifer called إختر أحد الخيارات cone of depression A O Static water level BO…

A: A multiple choice questions have been given and it has been asked to select correct option. Please…

Q: Find the minimum size of the gravel that will not move in the bed of a wide rectangular channel of…

A: Given :- Depth, y = 1.5 m Longitudinal slope, S = 0.003 To Determine :- Minimum size of the gravel,…

Q: blä 5 page level field book. 1) calculate the difference in level between point A and G. 2) If it is…

A: Height of instrument for station A, B, and C: H.I = Back sight…

Q: 1. An earth canal in good condition, having a bottom width of 3.65m and 5.6cms side slope of 3…

Q: 2. A trapezoidal canal section having side slope of 2H to 3V has a total depth of 1.5m. For a most…

A: Given data: Slope=2H to 3V Total depth=1.5 m It is asked find the bottom width of the most…

Q: A rectangular channel 6 m wide by 1 m deep is laid on a slope of 0.001 has a roughness coefficient…

Q: The table below is the page of a level field book. 1) Calculate the difference in level between…

A: Given that:

Q: For the channel shown assume a = 1m, b = 3m, d = 2m, w = 8m and n = 0.015, what bed slope is…

A: Given, a = 1m, b = 3m, d = 2m, w = 8m and n = 0.015, Our aim is to calculate the bed slope (s) of…

Q: This wood flume (n=0.012) has a slope of 0.0015. What will be the discharge of water in it for a…

A: Given:- n=0.012 slope = 0.0015 depth =1 m To find:- discharge of water

Q: A concrete channel which is laid on a slope of 1.8m per kilometer discharges water at a rate of 2…

Q: A rectangular channel 4.59 m. wide by 1.35 m. deep is lined with a smooth stone (n = 0.014), well…

Q: Water is flowing at a depth of 1.5m in a 3m-wide rectangular channel having n-0.013 and S =0.0009.…

A: b=3m y=1.5m n=0.013

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

1. What is the total wetted area of a
trapezoidal section of depth y base B and
side slope Z?
1
a) Z(B+Zy)
b) у(В+Zy)
c) Zy?
d) Zy

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Note: P = 85.50 kN
Find the value of passive earth pressure coefficient if the angle of shearing resistance as 26 degree
y y = x 1/2 locate the centroid of the area by rntegration 0.6 m 0.36 m
A uniformly distrubuted load applied on a strip fooing constructed in sand. Based on Hansen's equations, for a given factor of safety (FoS = 3) find the required width (B). Water table is far below the base of fooing. 800 kPa 1.8 m q D Y Φ с OF Nq 33.3 FOS 20 35 deg kPa www. Ny 33.9 B kN/m³ m q B D
What is the greatest slope angle (B) of a slope formed by a cohesionless (C=0) sand? Assume the friction angle of the sand, o'= 28° O a. 280 Ob 350 OC. This sand cannot form a slope Od. Information is insufficient to determine
5. .What is the value of the vertical component of A in KN?
Ray= 97.8553kn Rbx= 73.7132kn Rby= 14.14221 kn this must be the answer show solution pls
Design a most economical trapezoidal section of a canal having the following data: Discharge of the canal = 20 cumec Permissible mean velocity = 0.85 m/sec. Bazin's constant, K = 1.30 Side slope = 1.5:1 Find also the allowable bed slope of the canal. %3D %3D
A sloping line 392.40 m long was measured using a 50 m steel tape weighing 0.075 kg/m which was standardized at 15°C and 25 N pull. The difference in the elevation between the initial and end point was 2.25 m. If the measurement was undertaken with a temperature of 20°C and the tape was supported at both ends with an applied pull of 50 N. The cross-sectional area of the tape is 5.25 mm^2 and E=200GPa. Determine the corrected length of the horizontal line.
a.) Q=0.56m/s. V=1.16m/s b.)D=420mm. q=5.5x10^-3m^3/s That is the answer need some solutions
A two-level section has the following data:bottom width=8m side ,slope=2:1 on the left ans 1:1 in the right,transverse slope of the ground=8:1.Find the area of the section if the height at the center is 35% of tge formation width
Q1). Calculate the volume of cut and fill from followings: bo = 6m, s = 10, n = 1 in cut, n = 2 in fill, assume left side higher than right side, the stations and elevations are taken along centerline." St. N.G. Elev. 87 88 1972 12+60 12+80 Design Elev. 82 94