1. Answer the following questions about porosity and permeability: a) Name three (3) parameters which are involved in calculation of porosity. b) Name four geological mechanisms affecting porosity values. c) Describe effect of sorting on porosity.

1. Answer the following questions about porosity and permeability: a) Name three (3) parameters which are involved in calculation of porosity. b) Name four geological mechanisms affecting porosity values. c) Describe effect of sorting on porosity.

An Introduction to Physical Science

14th Edition

ISBN:9781305079137

Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Publisher:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Chapter24: Geologic Time

Section: Chapter Questions

Problem 5MC

See similar textbooks

Similar questions

d) Describe how porosity and permeability are associated with one another.
5. The "iceberg analogy" for the isostatic equilibrium of the continental crust turns out to be quite the relative density of icebergs versus seawater is close to the relative density of continental crust versus mantle. Glacial ice is about 15% less dense than seawater; likewise continental crust is about 15% less dense than the mantle. This leads to a simple rule that we can call the 1-to-8 rule: for every 1 unit of extra elevation for an iceberg or a mountain belt, there need to be 8 units of total thickness. These iceberg examples illustrate the idea: an iceberg 3 meters above sea level is 24 meters thick an iceberg 1 meter above sea level is 8 meters thick an iceberg 2 meters above sea level is 16 meters thick 3m 2m water level 1m >7m 14m 21m For the following questions, apply the 1-to-8 rule, assuming continental crust in isostatic equilibrium. a. Continental crust at sea level averages about 35 kilometers thick. (1 km = 0.6 miles.) Therefore, in general, how thick must the crust…
13. How deep in the crust is 10 kbar? Lithostatic pressure within the crusts results from the weight of the rocks above. Assume an average density of 2750 kg/m3. Use the equation P=p*g*h or P/(p *g)=h 23kPa/m P=pressure (e.g. kbar), p=density, g-gravity 9.8 m/s2, h= depth (m), 1 kbar=1,000 bars, 1 bar=100,000 Pa, 1 Pa=kg/(m*s2), 1 kbar =100,000,000 Pa, 1 km =1000 m. Give your answer in kilometers.
How does physics apply to these geological processes (volcanic eruptions, mountain formation, deposition)? Please explain.
b. Under what condition is a material or a rock mass considered to: i. Have positive Poisson’s ratio ii. Have negative Poisson’s ratio iii. Possess planar discontinuity iv. Exhibit positive deformation v. Exhibit negative deformation?
1. Describe the behavior of the "lava" once the lamp is up to temperature. In what way(s) does it mimic Magma? 2. What are the causes of the material rising and then falling? 3. What conditions must be present to make this occur? Think about energy but also think about the nature of the materials involved.
Q1-Choose the correct answer (use ) 1. The normal fault characterizes by: a) Moving up of foot wall. b) Moving down of hanging wall. c) Both of them. 2. Recumbent fold has: a) Vertical axial plane. b) Horizontal axial plane c) No axial plane. 3. Tension recognized on seismograph by: a) High peak then low peak amplitude. b) Low peak then high peak amplitude. c) Equal peaks. 4. Joints is; a) A fracture with horizontal movement. b) A fracture with rotational movement. c) A fracture without any movement. 5. Thrust fault is; a) A reverse fault with <30° fault angle. b) A reverse fault with 230° fault angle. c) A normal fault with <30° fault angle. 6. Box fold has; a) One axial plane. b) Two axial planes c) All the above. 7. Plastic deformation characterized by: a) Equal ratio of stress and strain. b) High strain versus low stress. c) Brittleness. 8. The destructive wave is; a) Longitudinal wave. b) Short wave. c) Primary wave. 9. Compressive strength increased when rock; a) With quartz…
1) Distinguish between the mantle and the inner core. 2) Explain in your own words how the Earth's layers were formed. 3) Explain what cause the mantle to "flow"? 4) What are the two main metals that make up the outer and inner core?
How does sedimentary rock from the ocean floor sometimes end up in highland and mountainous regions on the Earth? (22.5) (a) Sedimentary rock is commonly made inside volcanoes. (b) Wind and water carry the sediment to the mountaintops. (c) It is believed that asteroid impacts probably caused the sedimentary rock to move great distances. (d) The sedimentary rock was uplifted by powerful forces to form mountain chains.
Which of the following is most responsible for the formation of new crust ar the edge of a tectonic plate? A. mountain building at a continent-continent convergent boundary B. magma rising up from the mantle at a divergent boundary С. two tectonic plates sliding past one another at a transform boundary D. subduction of one oceanic plate under another at a convergent boundary
On July 13, 1986, the strongest earthquake known to strike San Diego County registered 5.4 on the Richter scale. It was centered off the coast of Oceanside on the Coronado Bank Fault. a) Determine the amount of energy released in ergs and b) Joules.
15. If the incident angle is 45 degrees and the seismic velocity in the first medium is a reasonable value for sediments, and the seismic velocity in the second medium is 4 times slower than in the first medium, then the refracted angle a. Is less than 45 degrees. b. Is more than 45 degrees. c. Is 45 degrees. d. Cannot be determined given this information. 16. Assume that the earth is represented by a horizontal layer overlying a half-space. A simplest refraction survey with minimum instrument requires one shot and one geophone b. one shot and two geophones c. one shot and three geophones d. two shots with two geophones 17. You carried out a single-shot seismic reflection survey to find the depth to the basement and the velocity structure. Exact knowledge about the material above the basement and the shape of the basement interface was not known. After carrying out the survey he picked out the first arrivals and plotted the T-X graph as below. What conclusion can you make? a. he can…