Answered: Which of the following represents the…

Which of the following represents the rotating losses of machine Friction and windage losses Eddy current losses O All of the them O Hysteresis losses O

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Related questions

Q: The spring in some instruments causes hysteresis effect. O True False

Q: D.C. generator will be in a position to build up without any residual magnetism compound series…

A: To start DC generarator residual magnetism is required, if it is not present then by method of…

Q: Rotor eccentricity can be caused by A. high motor loads. B. excessive voltage. C. poor motor…

A: A rotor eccentricity is a condition of unequal air gap that exists between the stator and the rotor.…

Q: A 6 pole generator has a flux of 12 mWb per pole. The armature has a total of 900 conductors and is…

A: We have a generator with, Pole (P) = 6 Flux/pole Ф = 12 mWb = 0.012 Wb…

Q: 7. The armature of a d.c. generator has a 2-layer lap-winding housed in 72 slots with six con-…

A: Given data of DC Generator, Double layer generator, Lap wound, No. Of slots (s) = 72 Conductors/…

Q: Iron losses in a DC machine are independent of variations in

A: The explanation is as follows.

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: The current flows in the windings of the DC machine which causes the O Ohmic loss O Eddy current…

A: Given : Generally DC machines are those circuits which will converts the electrical energy into…

Q: 1. Current flowing through the field coils : a. Magnetizes the pole pieces. b. Makes the generator…

A: MCQs type questions are given. Note: As per Bartleby Portal, I am solving first three MCQs.

Q: The spring in some instruments causes hysteresis effect. True False

A: Choose the correct option The given Statment The spring in some instruments cause hysteresis effect.…

Q: A 4-pole wave-wound motor is connected to a 406 V d.c. supply. The armature has 479 conductors and a…

Q: Exereise 2-1: The armature core of a 4 pole de machine has 31 slots ench designed to accomodate 4…

Q: 27. A 4-pole 1200 rpm generator with a lap wound armature has 65 slots and 12 conductors per slot.…

Q: 4-Is the residual magnetism on the generator is necessary how can you cancel these residual…

A: The residual magnetism in the generator is necessary because it helps in the voltage build-up of the…

Q: A 2 pole DC generator has an armature containing a total of 40 conductors connected in two parallel…

A: In the question, Find the terminal voltage of the generator. V= E-Ia Ra where E is induced emf.

Q: The resistance of the shunt winding of a d.c. machine is measured before and after a run of several…

Q: Mechanical losses represent: A. Windage losses B. None of the other choices are correct O C. Losses…

A: In this answer let us try to understand what are mechanical losses as explained below.

Q: to magnetic flux density of 1.0 T at the airgap. The details are provided as follows: Number of turn…

A: Given,Magnetic flux density of air gap(B)=1.0TNumber of turn of field winding in each pole(N)= 200…

Q: "The lap connected armature of a 2-poles, 750 rpm DC generator has 50 slots. Each coil has 3 turns…

A: The LAP winding DC Generator Speed N= 750rpm Slot = 50 Each coil have 3 turns Flux = 0.06 wb…

Q: DC motor's magnetic field gets stronger with an increase in mechanical load?

A: DC Machine A DC machine is nothing but a synchronous machine plus a commutator. DC…

Q: A 6 pole DC wave wound generator has 34 armature conductors with flux per pole is 29 m speed of the…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: The hysteresis loop occurs because: Select one: a. The machine is full-loaded b. some eddy current…

A: consider the given circuit;

Q: The voltage induced in 8 poles lamp wound generator is 120 V with armature resistance = 0.3 2. What…

Q: If the area of hysteresis loop of a material is large, the hysteresis loss in this material will be…

A: In this question , we will write hysteresis loss..

Q: . Lap winding is suitable for ……. Voltage, …… current d.c. generators. 2. The critical resistance of…

A: 1. Answer : Low voltage High Current The applications of lap winding mainly include low voltage as…

Q: 6) Flashing the field of D.C. generator means A. Neutralizing residual magnetism B. Creating…

Q: 6.a. Arcing in manual starters is eliminated by the use of A. overload relays. B. nonconductive…

A: Here we discuss about the MCQs on the motor protection.

Q: Which of the following represents the rotating losses of machine? Select one: O a. "Hysteresis…

A: Iron losses basically consist of two types namely eddy currents loss, hysteresis loss. The iron…

Q: 16 A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding consist…

A: DC shunt generator No of pole 2 Speed N= 1200 rpm Flux per pole 0.03 No of turns 200 No of…

Q: - A 4-pole,40 kw,220V d.c. generator has a wave-wound armature with 220 turns. If the brush lead is…

Q: A 4-pole generator has a lap-wound armature with 48 slots with 36 conductors per slot. The useful…

Q: 12.a. The metal plates that are riveted or bolted together inside a motor are called A. sheaves. B.…

A: Select the correct option: 12.a. The metal plates that are riveted or bolted together inside a motor…

Q: A lap wound DC machine has 400 conductors and 8 poles. The voltage induced per conductor is 2V. The…

A: Given: Lap wound DC machine has 400 conductors and 8 poles. So, Z=400P=8A=P=8 Voltage induced per…

Q: A 6 pole D.C. shunt generator has 60 slots on its armature. Each slot contains 15 conductors, 0.3…

A: Solution: D.C. shunt generator pole P=6, slot = 60 15 conductors/slot, armature resistance…

Q: Q2/A Four pole generator havi ng Waver Wond armature winding has 5I slots, each slof contnining what…

A: Generated emf =)(flux×speed×no. of armature conductors)/60)×(Poles/parallel paths).

Q: A 4 pole generator with wave wound armature has 51 slots each having 24 conductors. The flux per…

Q: 6. Hysteresis loss depends upon_ a. the volume and grade of iron c. frequency of magnetic reversals…

Q: 4.b. When a pneumatic solenoid fails, the failure is normally due to a B. weak pilot. C. bad…

A: When seal is damaged, the valve does not shut off properly. after a close inspection damaged…

Q: Ohmic loss

Q: A 900 rpm, 4 pole lap wound shunt motor takes 300 A. The flux per pole is 0.02 Wb and the armature…

A: A 900 rpm, 4 pole lap wound shunt motor takes 300 A. The flux per pole is 0.02 Wb and the armature…

Q: BELEGE OEEINEERDs Answer 4 questions only QI/A) Fill in the following blanks 1. The air gap between…

A: In this question, Fill the blank of any 4 options. All are related to the induction machine.

Q: A motor _________shunt has the better speed regulation of the cumulatively connected DC compound…

A: DC compound motor A DC Compound wound motor is an example of a self-excited motor and is made with…

Q: 1. Induction motor's slots not evenly spaced. 2. Air gap distance change from 4 mm to 6 mm. 3.…

A: 1) This results in Reduced leakage reactance, Reducing tooth puleating losses as well as Higher…

Q: Stray losses represent: O A. Resistive losses in the windings of the machine O B. Losses due to…

A: In this answer let us try to understand what the stray load losses represent in a machine as…

Q: four-pole, wave-wound generator has 220 coils of 10 turns each. The resistance of each turn is 0.02…

A: In this question we will find armature winding resistance....

Q: Which one of the following is not the function of pole shoes in a dc machine? (1) To reduce eddy…

A: The pole core basically has the field winding required to generate the magnetic flux. The airflow…

Q: An 8-pole DC machine has a simplex wave-wound armature containing 200 coils of 10 turns each. The…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 8. The critical resistance of the d.c. generator is the resistance of (a) armature (b) field (c)…

A: The maximum resistance of Field circuit above which no voltage build up is possible is called the…

Q: Both flux density and magnetic filed intensity affect the hysteresis loss.

Question

Which of the following represents the rotating losses of machine
Friction and windage losses
Eddy current losses O
All of the them O
Hysteresis losses O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

opper losses Which of following is a variable loss in a transformer? O Constant loss O Eddy current Hysteresis losses O Copper loss
A three-winding transformer is connected to an AC voltage source as shown in the figure. The number of turns is as follows: N₁ = 100, N₂ = 50, N3 = 50. If the magnetizing current is neglected, and the currents in two windings on secondary side are 2230° and 22150°, then what is the value of the primary current in Ampere? I 0000000000- N₁ № ₂ Z 00000 00000 Z N3 H I₁₂ I₁₂₁ ¹3
What are the constant losses in electrical transformers?
17 By laminating the core, the Hysteresis losses can be reduced. Select one: True False
The iron core in a transformer has the purpose of decreasing the reluctance of the magnetic path reducing hysteresis loss providing support to windings reducing eddy current loss
For 4 pole d.c machine armature winding with a double layer progressive simplex wave winding with 23 number of slots answer the following: a How many coils are present? b What is the coil span in terms of number of slots? c What is commutator pitch in terms of commutator segments? d How many coils are there between two consecutive commutator segments? e How many parallel paths are present?
In a certain transformer, the hysteresis loss was found to be 160 watts when the maximum flux density was 1.1 Wb/m² and the frequency 60 Hz. What will be the loss when the maximum flux density is reduced to 0.9 Wb/m and frequency to 50 Hz?
Open circuit test on transformers is conducted to determine Eddy current losses Copper losses O Hysteresis losses Core losses
Total core loss is also called as Select one: O a. Magnetic loss O b.Copper loss O C. Eddy current loss O d. Hysteresis loss
* Answer by true or false False True The reluctance is proportional to flux
The Ohms law for the magnetic circuit states that the net magnetomotive force (mmf) equals the product of the core reluctance and the core flux. (a) True (b) False
For dc machines, the series field windings have many turns of fine wire true False