When the switch is closed, the current is a constant 12 Amps. Suppose the switch is opened at t = 0, causing the current to instead flow through the capacitor. 202 240 V .05 H C F a) Find the value of C such that the circuit is critically damped. b) Solve for I, using I(0) = 12, and I'(0) = 0. (Use C from part a)) c) Find the maximum (negative) voltage across the inductor.

When the switch is closed, the current is a constant 12 Amps. Suppose the switch is opened at t = 0, causing the current to instead flow through the capacitor. 202 240 V .05 H C F a) Find the value of C such that the circuit is critically damped. b) Solve for I, using I(0) = 12, and I'(0) = 0. (Use C from part a)) c) Find the maximum (negative) voltage across the inductor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
In the diagram below, the switch S has been closed for a long time. A) What is the output voltage Vout? What is the charge on the capacitor? b) The switch is opened, so the output voltage increases. What is the time constant that describes the charging of the capacitor in terms of R and C? c) When Vout reaches 10 V, the switch closes and the capacitor begins to discharge. What is the time constant that describes the discharging in terms of R and C? Hint: Apply Kirchhoff's Rules to both loops and the sum of the currents at the junction above the capacitor in the diagram, and use I=dq/dt. If the switch opens when Vout reaches a lower value, say 5V, the capacitor will charge again, and thus one can cycle the voltage with a time constant determined by the circuit: this demonstrates the principle of operation of an electronic timer. 4R S 15 V Vout R
(surtch ) Consider the Circuit below: RI=200r a 7. R2 35mH 1000 For parts a-c assume the switch S is in position "a" after it was off for a long time. a) Find the time constant t for the switch in position "a". b) Determine the maximum inductor current, Imax. c) When will the inductor current be 95% of Imax. For parts d-f assume the switch S is in position “b" after it was in position "a" for a long time d) Find the time constant t for the switch in position "b". e) When will the inductor current be 5% of its initial value (initial value is when the switch is switched from “a" to “b") f) How much energy is dissipated by the resistance if the switch is in position "b" for a long time. eele
In the above circuit, the switch is open for a long time.i)The switch closes for 50 us. What is the current through the inductor? Also, what is the voltage at the output with respect to ground just before the switch open?ii) The switch closes. What is the maximum current the inductor will see?
4) For the circuit in figure a) What is the relation between Icharging and q? b) Write down Kirchoff's potential law clockwise around the circuit in terms of the variables q and dq/dt. c) Seperate the differential equation so that it is ready to integrate. Do not integrate. Switch S. Vs 5) For the circuit in figure a) Write down Kirchoff's current law at the point e. b) Write down Kirchoff's potential law around the loop abcdea. c) Write down Kirchoff's potential law around the loop abcdefgha. Do not solve the equations 4=18 V 0.50 250 S. S150 050
There is no energy stored in the circuit at the timethe current source is energized.1. a) Find Ia and Ib.2. b) Find ia and ib.3. c) Find Va, Vb, and Ic.4. d) Find va, vb, and vc.5. e) Assume a capacitor will break down whenever its terminal voltage is 1000 V. How long after the current source turns on willone of the capacitors break down?
I Review | Constants In the circuit shown in the following figure(Figure 1) the capacitor has capacitance 17 uF and is initially uncharged. The resistor Ro has resistance 11N. An emf of 91.0 V is added in series with the capacitor and the resistor. The emf is placed between the capacitor and the switch, with the positive terminal of the emf adjacent to the capacitor. The small circuit is not connected in any way to the large one. The wire of the small circuit has a resistance of 1.0 N/m and contains 30 loops. The large Part A The switch is closed at t = 0. When the current in the large circuit is 3.10 A , what is the magnitude of the induced current in the small circuit? Express your answer with the appropriate units. circuit is a rectangle 2.0 m by 4.0 m, while the small one has dimensions a = 13.0 cm and b = 23.0 cm. The distance c is 4.0 cm. (The figure is not drawn to scale.) Both circuits are held stationary. Assume that only the wire nearest the small circuit produces an…
Find the voltage across the terminals of the capacitors in the circuit shown in the figure under dc (direct current) conditions. Note: I leave the image of the exercises in Spanish, but it is easy to understand. Also in the other image is the correct final answer, for checking. IMPORTANT:Please, preferably the procedure should be digital, not on paper.This way I understand better.I would appreciate it very much!
(i) For the circuit below, draw the output waveforms for both the given input wave- forms. (ii) How can you convert this circuit into a half-bridge by removing any two compo- nents? Please draw a circuit diagram. Also, draw the current flow through the modified circuit. This can be done by annotating the modified circuit diagram. M (i) (ii)
The following figure represents an RC-Circuit with the switch. In Figure A, the capacitor is initially uncharged. In Figure B, the capacitor is initially fully charged. 1) Draw and label the current direction immediately after the switch is closed for each figure. 2) Consider Figure A. What is the voltage across the capacitor as t → 0? Explain. 3) Consider Figure B. Is the voltage across the resistor increasing, decreasing or staying the same as t → 0? Explain. A) B) R C
A 500 ohm resistor, an 1.5 F uncharged capacitor, and a 6.16-V emf are connected in series. (a) What is the initial current? (b) What is the time constant? (c) What is the final voltage on the capacitor? (d) what is the final charge on the capacitor? What is the final energy stored in the capacitor? (e) Express (i) Current in the circuit, (ii) Voltage on the capacitor, (iii) Charge accumulated on either plate of capacitor, (iv) energy stored in the capacitor as a function of time. (must include all the value calculated in the earlier part). (f) What is the i) current ii) charge on capacitor, iii) voltage on capacitor & iv) Energy stored in the capacitor after one time constant?
I need the DC analysis for this circuit, hence IC, IE, IB, VB, VC and VE Assume Beta to be 200, capacitors are open circuits in DC analysis and please make a clear explanation of the mode of operation