Using the following information, determine the vapor pressure of water at 300 °C. Note: We started this problem in week 6 lecture 3. Please refer to the lecture to get started on this problem. You only need to show your work starting from where the lecture left off. H₂0 at T = 179.88 degrees C the vapor pressure is PSAT = 10 bar. The enthalpy of vaporization is 2014.59 kJ/kg V = 0.1944 m³/kg V¹ = 0.001127 m³/kg The equation we left off on in class was, 1 [²² pi psat dpsat 1 AvapH [Tf 1 RAZ dT Tz dr Ti T²

Using the following information, determine the vapor pressure of water at 300 °C. Note: We started this problem in week 6 lecture 3. Please refer to the lecture to get started on this problem. You only need to show your work starting from where the lecture left off. H₂0 at T = 179.88 degrees C the vapor pressure is PSAT = 10 bar. The enthalpy of vaporization is 2014.59 kJ/kg V = 0.1944 m³/kg V¹ = 0.001127 m³/kg The equation we left off on in class was, 1 [²² pi psat dpsat 1 AvapH [Tf 1 RAZ dT Tz dr Ti T²

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

bliuzodt to mopolb 9. If machine parts are degreased by means of kerosene as shown in the diagram, how much kerosene make-up is needed per day? How much kerosene has to enter the degreasing vat per day? There are about 3 lb of grease per 100 lb of machine parts, and 60 tons of machine parts are processed each day. Five thousand pounds of kerosene (the 10% solution) are carried away by the machine parts each day but drip off and are caught and put back in the degreasing vat. Two hundred pounds of the 10% solution are lost each day from the vat by evaporation, spillage, or by being carried away.
For the following table, fill in the missing values. Tparcel refers to the temperature of a single parcel being lifted from 0 – 5 km, whereas Tenvironment represents the environmental lapse rate. "e" is the yapour pressure and "es" is the saturation yapour pressure. The figure relating saturation yapour pressure and temperature can be found below. The dry adiabatic lapse rate is 10° C/km and the moist adiabatic lapse rate is constant and 6° C/km. Height Tenviornment Tparcel е (parcel) es (parcel) RH 0 km 20 ° C 20 ° C 6.0 mb 24 mb 1 km 12 ° C 10 ° C 50 % 2 km 4° C 6 mb 3 km -4 ° C 3 mb 4 km -12 ° C -12 ° C 2.5 mb 5 km -20 ° C 1.5 mb 100 %
Show the COMPLETE SOLUTIONS including the derivation of formula and interpolations/extrapolations:NO Calculator Technique and Applications. 2. Steam at a pressure of 2.5 MPa is known to have a specific volume of 39.7x10-3 kg What is it specific enthalpy? 3. Your steam has a Data of 5.25 MPa and 395 C. Find v, u, h and s. 4. Your steam has a data of 4300 KPag and 362 °C, Find v, u, h and s.
* OMANTEL I. A moodle1.du.edu.om Not yet answered Marked out of 4.00 P Flag question THE PRESSURE IN AUTOMOBILE TIRE DEPENDS ON THE TEMPERATURE OF THE AIR IN THE TIRE. WHEN THE AIR TEMPERATURE IS 30°C, THE PRESSURE GAGE READS 250KPA. THE VOLUME OF THE TIRE IS 0.030 m3 AND THE ATMOSPHERIC PRESSURE IS 100KPA. THE GAS CONSTANT OF THE AIR IS 0.287 KPA.m3/Kg.K. THE GAGE PRESSURE IN THE TIRE WHEN THE AIR TEMPERATURE RISES TO 60 °C IS Select one: O a. 305.8 KPa O b. 285.25 KPa O c. 220.9 KPa O d. 274.75 KPa Previous page Next page
QUESTION 18 Describe the T-s diagrams accordingly by filling it the blanks accordingly. Use the sets of words given below for correct description. Ideal / Actual / vapour /cycle /Carnot/ Rankine/ Diesel/Otto/ Brayton/Ericsson/Stirlin g/regenerative/ reheat/ closed open/with/a Wurbout 9in A B P= constant 9in V= constant (b) T-s diagram D 4s 4a G Yout v=const. 9in v=const. E H Yout Yout Wpumpin High-pressure turbine C F Reheating I 4 3 Low-pressure turbine
A Boeing 767 due to fly from Montreal to Edmontonrequired refueling. Because the fuel gauge on the aircraft was not working, a mechanic used a dipstick todetermine that 7682 L of fuel were left on the plane.The plane required 22,300 kg of fuel to make the trip. Inorder to determine the volume of fuel required, thepilot asked for the conversion factor needed to converta volume of fuel to a mass of fuel. The mechanic gavethe factor as 1.77. Assuming that this factor was in metric units the pilot calculated the volume to beadded as 4916 L. This volume of fuel was added andthe 767 subsequently ran out the fuel, but landed safelyby gliding into Gimli Airport near Winnipeg. The errorarose because the factor 1.77 was in units of pounds perliter. What volume of fuel should have been added?
What does this graph saw about ice melting at zero degrees Celsius?
The left side of this equation tells how much energy Q the cylinder gives to the water while it cools. The right side of this equation tells how much energy Q the water and aluminum cup absorb from the cylinder to warm up. Because it is the same energy, they are equal. What is known in this equation? Mcyl 411.7 g, malum 46.5 g, malum+water = 175 g Can you find: mwater =? g Twater = Talum = 20°C (water and cup of room temperature) 90°C, T; = 35°C (hot cylinder and cool "cylinder+cup+water" temperatures) Tcyl kCal Calum = 0.22, Cwater 1 (specific heat of water and aluminum, measured in units kg-°C What are we looking for is Ccul - How we find it? Plug all the numbers into the equation (1), Ccul will be one unknown which you can calculate from the equation. Important, convert all the masses from grams to kilograms! After you find Ccyl, compare it to known value for the copper 0.093(our cylinder is made out of copper). |Ceyl -0.093| % : · 100% 0.093
= 14 15 16 17 18 19 20 21 22 23 24 25 26 A gas storage cylinder in an ordinary chemical laboratory measures 3.9 cm wide and 16. cm high. This is the label on it. olo Contents: N, gas Pressure: 7.93 atm If the cylinder is opened and the gas allowed to escape into a large empty plastic bag, what will be the final volume of nitrogen gas, including what's collected in the plastic bag and what's left over in the cylinder? Write your answer in liters. Round your answer to 2 significant digits. ?
*29. ssm The drawing refers to one mole of a monatomic ideal gas and shows a process that has four steps, two isobaric (A to B, C to D) and two isochoric (B to C, D to A). Complete the following table by calculating AU, W, and Q (including the algebraic signs) for each of the four steps. B -800.0-K isotherm -400.0-K isotherm 200.0-K isotherm D Volume Pressure
NOTE: Complete manual computation. Show the integration method and derivation of units. The specific heat of a certain ideal gas is given as a function of 345.1 4.13 x 104 KJ temperature: Cp = [1.54 - when temperature increases %3D T T2 kg K from 325°K to 1,100°K. Find the change of enthalpy.
Definition, diagrams, equations, & sample problems 合 Test Your Skills 14.1 2. A substance undergoes a polytropic process where n = 1.4. If the final pressure is twice as large as the initial pressure and the initial temperature is 264 K, find the final temperature in K. Your answer