The spool of cable has a mass of m (100 kg) and a radius of gyration of k (0.77m). The tension in the cable T' is a function of time t (1.81 s). Neglect the mass of the unwound cable, and assume it is always at a constant radius. a.) What is the moment of Inertia of the spool? b.) What is the angular acceleration of the wheel at t (Use + for the ccw direction)? c.) How quickly is the cable being pulled at time t (Use + for to the right) in m/s?

The spool of cable has a mass of m (100 kg) and a radius of gyration of k (0.77m). The tension in the cable T' is a function of time t (1.81 s). Neglect the mass of the unwound cable, and assume it is always at a constant radius. a.) What is the moment of Inertia of the spool? b.) What is the angular acceleration of the wheel at t (Use + for the ccw direction)? c.) How quickly is the cable being pulled at time t (Use + for to the right) in m/s?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The spool of cable has a mass of m and a radius of gyration of k. The tension in the cable T is a function of time t, when this in seconds. Neglect the mass of the unwound cable, and assume it is always at a constant radius. a.) What is the moment of Inertia of the spool? b.) What is the angular acceleration of the wheel at t (Use + for the ccw direction)? c.) How quickly is the cable being pulled at time t (Use + for to the right) in m/s? do T d₁ 0 = 60° Variable do d₂ h kc m T TEL Value 1m 0.5 m 2.25 m 0.77 m 100 kg 30t³ +77t N 1.81 s 1352 + 0) N h
1.) What is the moment of inertia of the object about an axis at the center of mass of the object? (Note: the center of mass can be calculated to be located at a point halfway between the center of the sphere and the left edge of the sphere.) 2.) If the object is fixed at the center of mass, what is the angular acceleration if a force F = 489 N is exerted parallel to the rod at the end of rod?
The mass of flywheel of an engine is 8 tonnes and the radius of gyration is 1.8 metres. It is found from the turning moment diagram that the fluctuation of energy is 100 kN-m. If the mean speed of the engine is 150 r.p.m., find the maximum and minimum speeds.
A stepped cylinder has the dimensions R₁ = 0.30 m, R₂ = 0.65 m, and the radius of gyration, k, is 0.35 m. The mass of the stepped cylinder is 100 kg. Weights A and B are connected to the cylinder. If weight B has a mass of 80 kg, and weight A has a mass of 50 kg, how far does A move in 5 seconds? In which direction does it move? (Draw all FBDs)
Question #1: Find the total system kinetic energy for the weight and pulley system shown in the figure below at the instant at which the downward speed of body A is 4 ft/s. Hint: kc is the radius of gyration. The radius of gyration can be used to calculate the polar moment of inertia about the center of mass by Izc = (mass)(kc)². B(32.2 lb, kc - 1 ft) %3D C 2 ft A (32.2 lb) C (96.6 lb)
Q. An engine flywheel has mass of 6.5 tonnes, and the radius of gyration is 2 m. If the maximum and minimum speeds are 120 r.p.m and 118 r.p.m respectively, find the maximum fluctuation of energy.
A wheel is attached by a cable to a block The wheel has a radius of 2ft and weighs 300lbs, the block weights 20lbs. If the radius of gyration about the point of rotation of the disk is 1.5ft, how many revolutions will it take for the wheel to come to a stop assuming it was moving at 10 rad/s CW. Assume the block is on the left side of the wheel and thus causes a CCW moment.
Given that P = 50N, and the rod has mass = 0.370 kg with centroidal mass moment of inertia l = 37/19200 kg-m²:a. Which of the equations given in the second image can be used to solve for the angular acceleration of rod BD?b. What is the angular acceleration of rod BD?
Paragraf Stiller Düz 11 In Figure 2, the wheel with mass p (kg) with an inertial radius of kA (mm), M-X.t (N.m) it has been subjected to moment (t seconds). Starting from a stationary state calculate the angular speed of the wheel after t1 seconds. Also, the reaction force that the fixed bearing a exerts on the wheel during movement calculate. (Gravity acceleration will be taken as 9.81 m/s2.) kA= 252 mm p= 13 kg x= 3 t;=2 M Odak
The wheel shown below has a mass of 5 slugs and a radius of gyration for the z-axis through point Cof 0.7 ft. The spring is massless and has a modulus of 20 lb/ ft and a natural (unstretched) length of 4 ft. Use the acceleration due to gravity, g = 322 ft/sec. The wheel is released from rest, and it rolls without slipping on the plane. Find how far down the plane the mass center Cwill move. Cord wrapped ´around hub IT 1.3 ft 0.8 ftC 3 ft 3 4 0.5 ft
M M 1.5m m M m = 2kg. M = 3.5kg a) justify whether the moment of inertia about the vertical or horizontal axis have smaller value. Show your calculation. (b) Given angular velocity of 80 rev s¹ in 240 rev. Has a moment of inertia of 1.41x10-3 kg m2. Find: (i) angular acceleration. (ii) net constant torque must apply (c) A space station consists of a giant rotating hollow cylinder of mass 10 kg including people on the station and a radius of 100 m. Given initial angular velocity of 3.3rpm in order to generate artificial gravity. If 100. people, each with an average mass of 65 kg spacewalk to an awaiting spaceship. Find the new angular velocity (in rpm) once all the people are off the station. (d) Suppose a child walks from the outer edge of a rotating merry-go-round to the center. What happend to the angular velocity of the merry-go-round does it increase, decrease, or remain the same? By using the conservation of angular momentum, explain your answer qualitatively.. A large train has…
Gravitational acceleration g = 10 m/s? 1. A uniform thin rod of length Im and mass m,od = 20 Kg in the figure can rotate freely in the plane about an axis at 30 cm from one of its ends while the other end attached with a disk of radius 10 cm and mass maisk = 10 Kg. As the rod swings from the angle 30". a. Find the position center of mass. b. Calculate the moment of inertia for the composed system. c. What is the velocity of the disk while reaching an equilibrium point? 30 cm