the process of error controlling using an FEC encoder and decoder in wireless communication with suitable block diagram
Q: 1. Calculate the coil pitches and indicate the slots into which the first coils should be placed for…
A: NOTE: As per our company guidelines we are supposed to answer only first three sub-parts. kindly…
Q: A field of strength 5 × 10 ampere turns / meter acts at right angles to the coil of 50 turns of area…
A:
Q: If two 115-volt loads were connectedin parallel with 240 volts, they would__________.a. burn dimlyb.…
A: The given loads are rated for 115 Voltage. The loads are connected in parallel, hence each load will…
Q: circuit with a resistance of 25 ohms, the current flowing through the circuit is which of the…
A: Given data, Supply voltage V = 100 V Resistance R = 25 ohm
Q: The radar in which both transmission and ception is done using the same antenna are called:
A: The solution is provided in the following section.
Q: What will be the resultant capacitance of the given combination? 1mF=2mF 3mF=4mF= 5mF
A: Given circuit,
Q: or the common emitter amplifier circuit in Figure Q4(a), determine the low cut- ff frequency for…
A:
Q: 1. What is the wavelength of light waves if their frequency is 5.0X1014 Hz? a. 0.60 m A b. 6.0 mm c.…
A: 1. Given, Frequency of light, f=5.0×1014 Hz
Q: Nodal Analyvis
A:
Q: Consider an NMOS transistor operating in the triode region with VGs = 3V, Vtn = 0.7V, and kn = 2.5-…
A: (a)Given equation of incremental resistance rds=1∂iD∂VDSVDS=VDS (b)Given the values of…
Q: The total charge of a uniform insulating sphere is 12.84 nanocoulombs. If the radius of the…
A: We need to find out the electric field due to sphere
Q: Consider the circuit in Figure Q.1(b). The frequency of the circuit is given 23 f = 50 Hz. Find: (i)…
A: The reactance of inductance and capacitance is given by Inductive reactance, XL = 2πfL Capacitive…
Q: The voltage VAN in the single-phase equivalent circuit for a balanced three-phase circuit (positive…
A: Given, For the single phase equivalent circuit of a balanced three-phase +ve sequence circuit, The…
Q: A 120V dc shunt motor having an armature circuit resistance of 0.2 Ω and field resistance of 60 Ω,…
A: Given that Terminal voltage, Vt=120 V Ra=0.2 ohm Rsh=60 ohm The full load current, 40 A Brush…
Q: Determine the time constant for the circuit in Fig. 10 ΚΩ 100 pF 20 ΚΩ Μ • 40 ΚΩ 30 ΚΩ
A: Given data, Circuit diagram is given as,
Q: An EM wave progating in a certain medium is described by E = 49.9 sin(28.4 x 106t - 4.5x)az V/m…
A: Given, The EM wave propagating in a medium is E=49.9sin28.4×106t-4.5az V/m
Q: Solve completely the given circuit below by applying two ac theorems discussed. Choose among…
A: It is given that: Z1=4-j8 ΩZ2=9-j12 ΩZ3=8-j10 ΩZ4=6+j12 ΩV2=30∠-60° V
Q: 1. Obtain the Thevenin equivalent seen by the (2-j) 2 impedance and employ it to determine the…
A:
Q: Determine Vout in V. +10 V Vin OV- -10 V THE F 8 3V Vout when Vin = +10V = Vout when Vin = -10V =…
A: We can analyze that the given circuit is clipper circuit in positive half cycle and negative half…
Q: 2. In a certain magnetic field the cross- sectional area is 0.5 m² and the flux is 1, 500 Wb. What…
A: Given, In a certain magnetic field, The cross sectional area, A=0.5 m2 Flux, ϕ=1500 μWb
Q: Derive the transfer function of a two phase AC Servo Motor giving relationship between control…
A: AC servo motor has two stator fields placed at right angles to each other. one is reference…
Q: Determine Vout in V. +10 V Vin OV -10 V 8 3V Vout when Vin = +10V = Vout when Vin = -10V = 1.0 ΚΩ…
A: When vin=+10, the diode will be in reverse bias and it is off. Therefore Vout=0.
Q: Design a circuit with an op amp that provides a gain of 7.5 having a Rin resistor of 12k ohm. What…
A:
Q: Explain how the holes move in valence band to carry current. b) At very high temperatures…
A: Step 2: Holes move in valence band to carry current. Step 3: At very high temperatures extrinsic…
Q: I3 An infinite length wire carrying current 10A is positioned along the x-axis . a point is located…
A: By amperes law, We Know that magnetic field due to infinitely long line at distance r is…
Q: R(Resistance, ohms) L[mH] 250 t t=0 200 R L io[mA] for t=0 40 a)Find the current i as a function of…
A:
Q: The effective armature resistance of a 3-phase, star connected, 500 kVA, 1100 V alternator is 0.1…
A:
Q: TABLE 9-2.2 Total Resistance RT and Percentage of Error
A: The total resistance of the parallel resistance network can be reduced into single equivalent…
Q: An RC high pass filter consists of an 820 W resistor. What is the value of C so that Xc is t times…
A: Given an RC high pass filter consists, Resistance of resistor, R=820 W Input frequency, f = 12 kHz…
Q: What is the magnetomotive force in a 50 turn coil of wire when there are 3 A of current through it?
A: Given: Number of turns in coil, N=50 Current through it, I=3 A
Q: 3. The radar in which both transmission and reception is done using the same antenna are called:
A: The correct option along with the explanation is provided in the following section.
Q: Circuits for DE We will be building 4 different circuits and determining voltage drop for each (very…
A:
Q: What is tungsten,CFL,led bulb... Which one save electricity and why
A: The endeavour to lower energy consumption by utilising fewer energy services is known as energy…
Q: State-Space Representation to Transfer Function PROBLEM: Given the system, find the transfer…
A:
Q: discuss the application of nyquist criterion to determine stability of a closed loop control system
A: Nyquist criterion: Nyquist criterion is a tool widely used to determine the stability of a system.
Q: 5. When a power Pt is transmitted by an antenna, amount of energy incident on the target is given by…
A: here we have to find the amount of energy incident on the target when a power Pt is transmitted by…
Q: A thermally conducting solid bounded by two concentric spheres of radii a and b. a<b, is such that…
A: Given that the temperature of the inner surface is T1 The temperature of the outer surface is…
Q: Using Mesh analysis, find i3 in Amperes if Is = 2.44 A and R = 4.4 Ohms. Give answer in 3 decimal…
A: Given: Circuit diagram:
Q: difference betwwen substation and transmission.
A: A high-voltage electric system facility is known as a substation. It is used to switch equipment,…
Q: Q3. At a frequency of 4000 Kilo-Hertz a parallel-wire transmission line has the following…
A:
Q: c) Drive the expression for maximum phase leads of m given network V. in R₁ min C₁ wwww R2
A:
Q: If in an RC circuit, the capacitance is increased by 20% and the resistance, R, is increased by 10%,…
A:
Q: In the given Data were conversion, Find the value of R₁, R₂ & R3. I 40 R₁ 4-**** 202 R3
A: Given circuit:
Q: Find Vo using voltage divider. Vo Μ W 2 ΚΩ 12 V +1 + Select one: Ο a 6V O b. None of them Οι 12V O…
A: We need to find out the voltage for given circuit
Q: a) i) The data inputs have a low value of 0 V and a high value of +5V for a DAC in Figure 2, If the…
A: Given parameters : DAC input - 0 and 5 V Number of inputs - 4 Resistance at A, Ra - 120 k ohm…
Q: 5. Solve for V(s) and then v(t) (using a partial fraction expansion). Find v(t=o) and v(t-infinity).…
A: If we want to transform the function from complex domain or Laplace domain to time domain, we need…
Q: characteristic impedance is Zo= 60 2 and losses in conductors are negligible, and the complex…
A:
Q: Vs Zs -↑ + V₁ Two-port Network Figure Q4(a) 1₂ ↑ + V₂ ZL
A:
Q: Using nodal analysis, find V, in the circuit. 2 ΚΩ 4 ΚΩ ν(+ 2 ΚΩΣ | 2 ΚΩ Vo
A: Given circuit,
Q: what is steady state stability? why ground wire is used on the top of tower ?
A: The duration of a process is described by steady-state and unsteady-state processes. When a variable…
2) Analyse the process of error controlling using an FEC encoder and decoder in wireless communication with suitable block diagram
Step by step
Solved in 4 steps with 3 images
- Write down a Verilog module implementation of a 2-to-4 decoder (and/or encoder).How do you design to 2-4 active low decoder?Q2] For a PCM system with the following parameters, determine a) Minimum sample rate. b) Minimum number of bits used in the PCM code, resolution, and c) Quantization error. Parameters: Maximum analog input frequency=4KHZ. Maximum decoded voltage at the receiver = +- 2.25V. Minimum dynamic range=46 dB.
- Define priority encoder and Differentiate between encoder and decoder.C D .accepts this data and redistributes it to the n outputs. encoder De-multiplexer are faster in speed because the delay between the input and. * *.accepts this data and redistributes it to the n outputs. Decoder O output is due to the propagation delay of gate combinational circuit O Sequential network O Integrated circuit O Decoder O encoder O De-multiplexer3/ A Digital Analog Converter of 12 Bits of Precision is available A/ Determine the signal to the system's peak noise ratio B/ If the signal is sampled at 44 kHz. What is the bits rate generated by the system? C/ Determine the required bandwidth if I wanted to transmit this data with a modulator 16-QAM.
- QA: what is Encoders and DecodersExplain how a priority encoder worksThe information in an analog waveform, whose maximum frequency fm-4000Hz, is to be transmitted using a 16-level PAM system. The quantization must not exceed #1% of the peak-to peak analog signal. (a) What is the minimum number of bits per sample or bits per PCM word that should be used in this system? (b) What is the minimum required sampling rate, and what is the resulting bit rate? (c) What is the 16-ary PAM symbol Transmission rate?
- For a FM system, the maximum freq deviation is 75 kHz and the maximum freq of the info. signal is 10 kHz. What will be the total bandwidth of the FM system? What will be the modulation index?E- Design 3-to-8 decoder by using 2-to-4 decoders has active high enable.1. Explain on Encoders, Decoders, Multiplexer and demultiplexer(. 3. Explain the procedure of solving K Map. 4. Explain half adder and full adder with neat schematic sketch.