The conductors of a 66 kV, 50 Hz three phase transmission line are suspended horizontally as shown below. The conductors span 300 km and each have a radius of 5 cm. If the lines assumed to be fully transposed calculate; a) the inductance per phase; b) the capacitance per phase; c) the charging current; d) the total reactive power of the line due to charging current. 5cm 0.2m 0.2m 0.2m 3m- 3m-

The conductors of a 66 kV, 50 Hz three phase transmission line are suspended horizontally as shown below. The conductors span 300 km and each have a radius of 5 cm. If the lines assumed to be fully transposed calculate; a) the inductance per phase; b) the capacitance per phase; c) the charging current; d) the total reactive power of the line due to charging current. 5cm 0.2m 0.2m 0.2m 3m- 3m-

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.31MCQ

See similar textbooks

Similar questions

2.5 A 3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontal spacing with 6.1 m between the centre lines of adjacent phases. The distance between the sub- conductors of each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find the inductance per phase per km. [0.988 mH]
Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal spacing. (transposition of conductors is not required)
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
9.24 A three-phase, 60-Hz transmission line is completely transposed. The separation distances between conductors are 7, 7, and 10 m. Each conductor has a diameter of 5 cm. The line-to-line voltage is 138 kV, and the length of the transmission line is 100 km. Determine the following: a. Capacitance per phase b. Total capacitive reactance per phase C. Charging current taken by the total capacitance of the transmission line
(a) A three phase transposed transmission tower comprises of three-bundled conductor and double-circuit configured in vertical position as shown in Figure 2. Each sub-conductor in each circuit and each phase is an ACSR type, size 477,000 cmil and stranding 26/7. Given the GMR of each sub-conductor is 0.8809 cm and diameter is 2.1793 cm, analyze: i. Inductance in mH/km ii. Capacitance in µF/km 0.75m 7.5m b' 4m 4m 45cm Figure 2
The mutual inductance coupling coefficient standard unit is .. * Ohm Henery O Unit-less Mho
Subject - Design electrical circuits for single phase AC networks Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and series AC circuits on voltage resistance and impedance.
Discuss why a. Complex power in an AC circuit is more than the DC resistance. b. Receiving end voltage of an unloaded long line may be more than sending end voltage. c. Inductance of the three phase of a transmission line are generally not equal. d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
For transferring electrical power at 220 kV, six conductors of ACSR Drake constitute a 60Hz double circuit three phase line arranged as shown below. The vertical spacing between consecutive conductors is 14ft; the longer horizontal distance is 32ft whereas the shorter horizontal distance is 25ft. a. Find the inductance per phase per mile and the inductive reactance per phase in ohms per mile. b. Find the capacitive reactance to neutral in ohm-miles. c. Find the resistance per phase per mile in ohms per miles. d. If the length of the line is 90 miles then draw an equivalent circuit of the line and analyse the open circuit and short circuit performance of the line. e. Find the maximum power we can transmit over the line. f. If the line is delivering power to a load of 20MW at 0.8 power factor lagging then find the voltage at the receiving end of the line. Also, Determine the voltage regulation, losses and efficiency of the line. g. If a fixed shunt compensation of 3 MVAr is attached at…
The three conductors of a 3-phase, 3-wire line are arranged at the corners of a triangle, the sides of which are 1 m, 1.3 m and 2 m. Calculate the inductance and capacitance per km of the line, when the conductors are transposed. The conductors are 1.5 cm diameter. [B.T.E. A.P. Power Systems II, T & D, June 1994) (Ans. 1.0923 mH: 0.0107 µF]
A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'