= (Static Equilibrium) An 8-m long horizontal boom with a mass of 100 kg (w 981 N) supports a 2000 kg load (W = 19, 620 N) as shown in the figure below. A pin exerts a force on the boom at the left end of the boom, P. P 0=40° 1 = 8.0 m 2000 kg Find: (a) The vertical component of the pin force, F (b) The horizontal component of the pin force, Fh (c) The tension on the cable, T

= (Static Equilibrium) An 8-m long horizontal boom with a mass of 100 kg (w 981 N) supports a 2000 kg load (W = 19, 620 N) as shown in the figure below. A pin exerts a force on the boom at the left end of the boom, P. P 0=40° 1 = 8.0 m 2000 kg Find: (a) The vertical component of the pin force, F (b) The horizontal component of the pin force, Fh (c) The tension on the cable, T

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 90A

See similar textbooks

Similar questions

A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A trapeze artist with swing weighs 800n; he is momentarily held to one side by his partner so that the swing ropes make an angle of 25.0 degrees with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?
The right support of a cable is located 45 m below the left support. The horizontal distance between supports is 250 m. The lowest point on the cable is 15 m below the right support. If the maximum tension in the cable result- ing from a uniformly distributed load w along the hori- zontal is 850 kN, determine The length of the cable.
Consider a rigid steel beam of length L = 13 m and mass mb = 383 kg resting on two supports, one at each end. A worker of mass mw = 68 kg sits on the beam at a distance x from support A. Refer to the figure, though note that it is not drawn to scale. 1.) the force exerted on on the beam by support A is found to be 2180 N as wht distance x in meters from support A is the worker sitting now?
An individual leans forwards to pick up a box of 100 N. The weight of his upper body has a magnitude of 450 N. The back is pivoting around the base of the vertebral column. Consider the back of the individual as a rigid bar that is controlled by a muscle with an angle of 12° (See picture, d = trunk-head distance = 1 m).a) Calculate the magnitude of muscle force required to lift the box.b) Calculate the magnitude of the force at the base of the vertebral column. Hints: For (a) solve the equilibrium of moments, i.e. what force is required in the muscle to balance out the moments acting around the base of the spine.For (b), solve the equilibrium of forces acting on the spine, including the muscle force you’ve just calculated, in x and y separately. There are two extra forces not shown in the diagram: x and y contact forces acting at the base of the spine. These are whatever is needed to keep the total forces acting on the spine = 0 (so the spine isn’t accelerating off in some…
A 1,100-N uniform boom at y = 56.5° to the horizontal is supported by a cable at an angle 0 = 33.5° to the horizontal as shown in the figure below. The boom is pivoted at the bottom, and an object of weight w = 2,150 N hangs from its top. 0 e Pivot W (a) Find the tension in the support cable. KN (b) Find the components of the reaction force exerted by the pivot on the boom. (Assume the positive x-direction is to the right and the positive y-direction is upward. Include the sign of the value in your answer.) horizontal component kN vertical component KN
A carpenter carries a 6kg uniform board as shown below? (a) What downward force does he apply with his hand at point B? (b) What upward force does he apply with his shoulder at point Ar 4. nere snould his shoulder be positioned to reduce the upward force he is applying at ns shoulder? (d) What force does he now apply with his hand? 大 03m 1.5 m 0.6 m
A 1220N uniform boom is supported by a cable perpendicular to the boom, as seen in the figure below. The boom is hinged at the bottom, and an m=2120N weight hangs from its top. Assume the angles to be a=60.7deg and 0=(90.0°- a). Ꮎ Ө ja m Find the tension in the supporting cable. Submit Answer Tries 0/10 Find the x-components of the reaction force exerted on the boom by the hinge (choose to the right as positive). Submit Answer Tries 0/10 Find the y-components of the reaction force exerted on the boom by the hinge (choose upwards as positive). Submit Answer Tries 0/10
A homeowner is trying to move a stubborn rock from his yard. By using a a metal rod as a lever arm and a fulcrum (or pivot point) the homeowner will have a better chance of moving the rock. The homeowner places the fulcrum a distance ?=0.288 mfrom the rock, which has a mass of 465 kg, and fits one end of the rod under the rock's center of weight. If the homeowner can apply a maximum force of 671 N at the other end of the rod, what is the minimum total length ? of the rod required to move the rock? Assume that the rod is massless and nearly horizontal so that the weight of the rock and homeowner's force are both essentially vertical. The acceleration due to gravity is ?=9.81 m/s2.
The three cables are used to support the 40-kg flowerpot. Determine the force developed in each cable for equilibrium.