semiconductor diode has a leakage current of 25 pA. Calculate ID when the voltage across the diode is 0.65 V, mission coefficient is 1. Assume the diode is in forward bias. 5 mA 1 mA O 2.1 mA O 3 mA

Q: or Is this a low pass high pass filter and where is the 3dB down point?

A: The function of the given circuit needs to be identified and the location of the 3dB line should be…

Q: Given a motor with the following parameters: Rw = 12 Ω (winding resistance) Kv = 5.67mV/RPM (back…

A: Given, Rw=12 Ωkv=5.67 mV/RPMkt=552 gm-cm/ARf=0.0236 gm-cm/RPM We have to calculate the voltage for…

Q: c) Find the Z.Transform of the following signal and its ROC

A: In this question we need to find the Z transform of the given signal

Q: 2. Create a State Table and write a Boolean equation for input D.

A:

Q: 1. For this circuit, find the expression for I(s). i(0)-1 A A) I(s) = -(s+6.5) (s+8)(s+0.5) B) I(s)…

A: The current in an inductor does not change suddenly change suddenly unless an impulse source is…

Q: 7.47 Determine v(t) for t > 0 in the circuit of Fig. 7.114 if v(0) = 0. 3u(t-1) A Figure 7.114 For…

A: In this question we need to find the voltage v(t) for t>0

Q: Multi-stage impulse generator with 14 stages and 6/50 µsec impulse wave. The testing object value…

A: For a multi-stage impulse generator, the following parameters are given: number of stages n=14,…

Q: Problem 4: A 4-pole, Y-connected, three-phase, wound-field, synchronous generator is rated at 13.2…

A: In this question We need to determine the rated current.  We know Inductive Reactance XL = wL

Q: Question 3 For a circuit with one input A and one output Z implemented using T flip-flops with T₁ =…

A:

Q: Using Figure 1, Vs 50V-15 339 Hz R1 1100 R2 100 -m XL1 320 HH XC1 700 R3 600 Figure 1 13 R4 400 XL2…

A: Here I am Solving first three subparts as per guide lines.

Q: Problem: Fx=(AB+CD+EF+G)'   a. Draw its equivalent transistor circuit. b. Determine if the…

A: According to the question, for the function Fx=(AB+CD+EF+G)' ; a. Draw its equivalent transistor…

Q: 3.1 Truth table      3.2 standars POS      3.3 Standard SOP

A: we need to determine,      3.1 Truth table      3.2 Standard POS      3.3 Standard SOP

Q: (i) Apply the superposition theorem to determine the currents 11, 12 and 13 in the following network…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Please provide explanation or steps if needed; 1.Determine whether the following Boolean equation is…

A: To determine: xy+xz+xz=xz+yz+xz, whether the expression is True or False F(A,B,C,D)=∑(0, 6, 7, 8,…

Q: Based on the following circuits, find values read at state Q at the time i

A: The output of the given NOR-based SR Latch needs to be analyzed at the given time interval with the…

Q: 3 7(~ so So jto tjes -j ³0 û. if the capacitor is luf, find the value of the inductor b) find Vo(t)…

A: In this question,  We need to determine the value of inductor in the circuit and voltage Vo(t)  and…

Q: Use your reasoning logic to determine which diodes are on and which might be off in the following…

A: In this question  We need to determine the voltages VA  and VB  . Also current in the diodes ID1  ,…

Q: 174. The EMF induced in the armature of a shunt generator is 500 V. The armature resistance is 0.2…

A: A shunt generator having, Induced emf in the armature, E=500 V. Armature resistance, Ra=0.2 Ω.…

Q: Given a signal x(n)=2n+1 and N=8, evaluate the Fast Fourier Transform using signal flow graph. (Use…

A: Given: A discrete time sequence, x[n]=2n+1, and N=8,  To find: Fast Fourier Transform (FFT) using…

Q: For the circuit shown below R₁ 330 V₁ R₂ R₂ 1.5 k 470 V₂ V₂ Voltages v1, v2 and v3 are respectively:…

A: Circuit diagram is given as,

Q: 2. Find the voltage at the capacitor using nodal analysis if Vg = 340/0°V. 80 Ω 50 Ω www g +1 -j100…

A:

Q: It is necessary to reduce the power consumption of a system by at least 5 times using pipelining.…

A: To reduce the power consumption of a system by a factor of 5 using pipelining, we can use the…

Q: What is the demand load for a school with an area of 30,000 sq. ft. and a total load of 500 kW when…

A: In this question We need to determine the total demand load.  Given area = 30000 sq ft Total load =…

Q: 3 resistors have the resistance shown in the figure. They are all connected together. Solve for the…

A: Asked to find equivalent resistance between terminals A and B

Q: In the shown circuit if the currents i, (t) = 15 cos (20t-45°) mA and i(t) = 8 sin (2001+30°) mA,…

A: Current is given as, i1t=15cos20t-450 mA.i2t=8sin200t+300 mA. At t = 0. i1=15cos450,=152…

Q: a. Determine the total real power, Pr, and total reactive power, QT- b. Draw the simplified circuit.…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: (sin 5t + cos 5t) for a unit impulse input. An open-loop control system results in a response of e…

A: The response of an open loop control system, ct=e-2tsin5t+cos5t. Input is unit impulse so, rt=δt.

Q: (i) Apply the superposition theorem to determine the currents 11, 12 and 13 in the following network…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 36. For each truth table in Table 4-15 , derive a standard SOP and a standard POS expression. ABER X…

A: To write the standard SOP and POS expressions:

Q: 6) Consider the below two signals used in a binary communication, determine the dimension and the…

A: According to the question, two signals are used in a binary communication as shown below We need to…

Q: E = 120 V, R2 = 10k ohms, VR1 = 50 V and IT = 13.5 mA. Find the value of IR1, R2, R1, and IR3. till…

A: In this question we need to find the current through resistor R1 , R2 & R3  and find the value…

Q: Determine the values for i and v for the circuit shown in the figure below (Figure 1). The diode is…

A: input voltage  Vi = 15 V resistance R = 5 KΩ given LED characteristics, by observing we get cut-off…

Q: the laplace transform of f(t)=(1-t)u(t) is?

A: We need to find out Laplace transform of given signal.

Q: In case of 4-pole D.C. generator provided with a two layer lap winding with sixteen coils, the pole…

A: A DC generator with, Total number of poles, P = 4. Two layer lap winding.  Total number of coils =…

Q: Exercise 1: Use the z-transform of - x[n] = d[n − 1] − 6[n − 2] + 6[n − 3] − d[n − 4] and the system…

A: it is asked to find the output of given discrete time system from input and z-transform of system…

Q: 6) Consider the below two signals used in a binary communication, determine the dimension and the…

A: According to the question, two signals are used in a binary communication as shown below We need to…

Q: QUESTION 3 For the network below E Is 11 = R₁ 36 V Calculate RT RT 12 = Determine Is, 11, and 12 Is…

A:

Q: 4 use eqation as show in picture design logic circuir ?   4.1 use NAND only    4.2 use NOR only

A:

Q: Find the current in the 12 resistor in the figure below. (R₁3.00, R₂ = 6.60, AV = 11 V) R₁ www 4.00…

A:

Q: Calculate the active power in a 487 H inductor. a) 2482 W b) 1545 W c) 4565 W d) O W

A: it is asked to find active power in 487H inductor

Q: a) Assume the resistance is constant: R = 100.Check by direct substitution that the function VC (t)…

A:

Q: 7.39 Calculate the capacitor voltage for t 0 for each of the circuits in Fig. 7.106. 20 V 12 V (+)…

A: In this question We need to determine the value of voltage across the capacitor.  We know Capacitor…

Q: What do the connection angles and groups show in transformers? For example, where are the Yy0 , Dy5…

A: It is asked what do the connection angles and groups show in transformers. Also it is asked where…

Q: Clock and Data Signals are shown for a D-FlipFlop. Sketch the output waveform Q. Assume the…

A:

Q: Two infinitely long linear charges of uniform density ρ11 and ρ12 shown in the figure are placed…

A: Given, Two infinitely long linear charges of uniform line charge densities of ρ11 and ρ12 (as shown…

Q: Exercise 2: Use z-transforms to combine the following cascaded systems w[n] = x[n] + x[n − 1] y[n] =…

A:

Q: Find the overall system transfer function

A:

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t= 850 ms is: a. 36.22…

A: Given, Capacitor C=2mF Voltage across capacitor =525cos(20t) We have to calculate the energy stored…

Q: 7.44 The switch in Fig. 7.111 has been in position a for a long time. At t = 0, it moves to position…

A: In the Transient analysis of any circuits, the Inductor always opposes the sudden change of current…

Q: The per phase impedance of a short transmission line is 0.3 + j0.4 ohm. The sending-end line-to-line…

A: