solve with use free body diagram, Please fast. Q(4) The engine block M with a mass of 250kg is suspended from the pulley system inFigure Q4. What force F must be applied to the end of the rope to keep the enginesuspended?FMFigure Q4A578 NBCDE591 N652 N788 N818 N

Answered: Q(4) The engine block M with a mass of…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter7: Rotational Motion And Gravitation

Section: Chapter Questions

Problem 32P

See similar textbooks

Similar questions

A 0.400-kg pendulum bob passes through the lowest part of its path at a speed of 3.00 m/s. (a) What is the tension in the pendulum cable at this point if the pendulum is 80.0 cm long? (b) When the pendulum reaches its highest point, what angle does the cable make with the vertical? (c) What is the tension in the pendulum cable when the pendulum reaches its highest point?
A 0.400-kg pendulum bob passes through the lowest part of its path at a speed of 3.00 m/s. (a) What is the tension in the pendulum cable at this point if the pendulum is 80.0 cm long? (b) When the pendulum reaches its highest point, what angle does the cable make with the vertical? (c) What is the tension in the pendulum cable when the pendulum reaches its highest point?
A 0.500-kg potato is fired at an angle of 80.0 above the horizontal from a PVC pipe used as a “potato gun” and reaches a height of 110.0 m. (a) Neglecting air resistance, calculate the potato’s velocity when it leaves the gun. (b) The gun itself is a tube 0.430 m long. Calculate the average acceleration of the potato in the tube as it goes from zero to the velocity found in (a). (c) What is the average force on the potato in the gun? Express your answer in newtons and as a ratio to the weight of the potato.
To get in shape, you head to the local gym to exercise by lifting weights. Using a lat machine (Fig. P5.48), you notice that the wire connected to the bar is run around three different pulleys and is connected to a vertical stack of weights on the other end. The weights move up and down as you pull down on the bar. Suppose you set the machine so that the weight to be lifted is 120.0 lb. When you pull down on the bar, exerting a constant force, the acceleration experienced by the weights is 0.250 m/s2. What tension must exist in the wire connecting the bar and weights under these conditions? Assume the pulleys are massless and frictionless. FIGURE P5.48
What can you say about the velocity of a moving body that in dynamic equilibrium? Draw a sketch of such a body using clearly labeled arrows to represent all external forces on the body.
77 K/s l A:0. docs.google.com/forms Sove tne peiow question ana then seiect the correct answer Sam pushes toward the right on a box with a force of magnitude 31.0 N. Sarah applies an 11.0 N force on the box in the opposite direction. The magnitude of the kinetic friction force between the box and the very smooth floor is 4.50 N as the box slides toward the right. Also, the magnitude of the normal force is 98 N. Find the box's mass, the box's acceleration in the x-direction, the box's acceleration in the y-direction, and the coefficient of dynamic friction. Choose the correct answers * m = 10 kg, a, = 2.55 m/s?, a, = 0 m/s?,p = 0.5 العربية الإنجليزية
17 W The 50 KN block is on top of an inclined plane shown in the figure. Determine the weight (W) of the steel bar that will move the 50 KN block sliding down the inclined plane with velocity of 2 m/sec and displacement of 2 meters. cable 50 KN 8H=0.30
Problems: 210, 211, 216, 218, 231, 233, 238, 242, 257, 264 I. In the figure below, the x-component of the force P is 140 lb to the left. Determine P and its y- component. P 7 ww Y
A 2.00-kg block is at rest on a horizontal plank that is 1.50 m long. When one end of the plane is raised to 0.50 m, the block starts sliding down. What is the coefficient of static/starting friction between the block and the plank? O 0.43 O 0.35 0.33 O 0.53
13. -/0.62 points v SERCP11 5.A.P.076. R My Notes Ask Your Teacher V A 5.6-kg block is pushed 3.9 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of 0 = 30° with the horizontal, as shown in the figure below. If the coefficient of kinetic friction between block and wall is 0.30, determine the following. F (a) the work done by F (b) the work done by the force of gravity J (c) the work done by the normal force between block and wall (d) By how much does the gravitational potential energy increase during the block's motion? J
A push of magnitude P acts on a box of weight W as shown in the figure. The push is directed at an angle 0 below the horizontal, and the box remains a rest. The box rests on a horizontal surface that has some friction with the box. The normal force on the box due to the floor is equal to: O W + P cos 0. O W + P sin 0. OW-P sin 0. O W + P. O W. W 0 P
A 45.0-kg sled is pulled across a horizontal icy surface as in the figure. The horizontal pulling force of magnitude P is directed opposite to a constant 25.0-N kinetic friction force. Starting from rest, the sled acquires a final speed of 2.25 m/s after being pulled a distance of 28.0 m. P What is the magnitude P of the pulling force? N twikke Ⓡ

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

SEE MORE TEXTBOOKS

Q(4) The engine block M with a mass of 250kg is suspended from the pulley system in Figure Q4. What force F must be applied to the end of the rope to keep the engine suspended? F M Figure Q4 A 578 N B C D E 591 N 652 N 788 N 818 N